Benutzeranleitung / Produktwartung AirStation Pro Intelligent WLM2-G54 des Produzenten Buffalo
Zur Seite of 36
WLM2-G54 Users Guide.
.
i W arning ................................................................................................................................................................................................................................................
ii 9.4.2 Syslog Setup .............................................................................................................. ......................................................................................................................
iii W arning This section explains the symbols, signs and ter minology used in this manual. The follo wing terminology is used in this manual to distinguish between an Ethernet 10/100B ASE-T LAN and a Wireless LAN and should not be constr ued as gener ally accepted ter minology outside this context.
1 PA R T I 1.0 Introduction I The WLM2-G54 protects customer s’ inv estments o ver the long ter m. Buffalo’ s new WLAN product, WLM2-G54, is the IEEE802.11g-based access point (AP). The Buffalo solution offers simultaneous commu- nication on both 11Mbps and 54Mbps bands without annoying bottlenecks.
2 5.0 F eatures The Buffalo AirStation Intelligent access point pro vides the features necessar y in today ’ s business en vironment, with a high level of reliability and security . Use of these features along with VPN will allo w the user to have the highest security a WLAN can offer .
3 TKIP – T emporal Key Integr ity Protocol is an advanced encr yption method using the RC4 algorithm. Instead of using the sequential IV , a r andom IV will be used, and the IV key definition will be updated regularly at a preset time inter val.
4 5.2.3 Spanning T ree (IEEE802.1d) Networ k looping often results in repeated packet transmission, which causes ov er loads and inter r uption of communications. The Spanning T ree in a network loop disconnects one of the links, rerouting the tr aff ic in the event of failure, avoiding pack et sending repetition and increasing network stability .
5 the Syslog ser ver as a par t of its administr a- tiv e utilities, it is possible to use additional off- the-shelf Syslog ser ver software. 5.5 Easy Suppor t F eatures Buffalo periodically releases new firmware updates for AirStation products. The firmware is easily uploaded to the AirStation from a PC .
6 system can be set with authenticated secur ity so that only the authorized tenants can access the networ k. Buffalo’ s wireless solution can be used as an optional fee-based ser vice . 6.3 Schools Sometimes it is necessar y for students to hav e per sonal Internet connections for schoolwork.
7 mands. With a wireless LAN, any changes in the factor y’ s machine layout can be com- pleted quickly . Wireless flexibility offer s installation and oper ation cost sa vings for the factor y . 6.6 Area Intranets Community buildings such as schools, city halls, gyms, etc .
8 7.2 Envir onmental Resistance The WLM2-G54 AP ’ s high durability design allows resistance to en vironmental conditions like temperature changes. Since it is less susceptible to en vironmental change, it is suitable f or warehouses, public areas and other locations where temperature control is not a vailable.
9 5 . After finding an AirStation, select Admin / Set IP address. 6. Either enter the IP and Subnet Mask address in the bo xes or select DHCP . 7. Lea ve the P assword bo x empty .
10 8.6 Input Parameters Through the Client Manag er 1. Click the "Management" to open the next page . 2. Click the "Time Settings" menu on the left (menu section) to set the cur rent time. Click Set. 3. Click the "LAN Setup" menu on the left; then click the "Wireless" menu.
11 possible to use an y other off-the-shelf software . ■ Note: If the AirStation is already connected by T elnet or Client Manager , you cannot log in from the ter minal software . 3. Setup the terminal as follows: Baud rate: 57600 Data bit: 8 Parity: None Stop bit: 1 Flow Control: None 4.
12 Manager or T er minal Software setup screen. 4. When login prompt appear s, enter “ root ” as a default login name . 5. Input "?"/press "Enter" to view list of commands.
13 9.3 Time Settings Input the cor rect time manually or input the NTP ser ver on y our networ k. Using NTP Ser ver : Check ON box in NTP . Specify the NTP ser ver name , check inter val, and time zone.
14 This enables repor ting to the syslog ser ver . Check the "ON" bo x if you want the system logs to be sent to the log ser ver . The setup for the log ser ver should be f ound in the syslog ’ s manual. The follo wing log type can be tranfered: Setting, Autheutif ication, Device , Filter , and System.
15 Data forwarding can be dela y ed by a preset length of time . The delay time value ma y be from 4~30 seconds. The default value is 5 seconds. 9.5.4 “ Hello ” Time The Hello message (to the networ k) broadcast time inter val can be changed. The "Hello" message is used to set up network routing under the Spanning T ree protocol.
16 9.6.3 Routing T able Entries Set routing information recognition and elimination. Check the item to be eliminated; then click "Delete Checked Items." 9.7 Basic Filter This is a simple f ilter for limiting access to the WLM2-G54. 9.7.1 Filter Settings Four f ilter s can be enabled by clicking “ add the r ule .
17 9.9.2 List of the Wireless PCs Displays the PCs that are comm unicating with the WLM2-G54. Check the "registr ation" box and click the "change" button to add a MA C address. 9.9.3 Authorized Wireless LAN PCs Displays all MA C addresses that are allow ed to comm unicate with the WLM2-G54.
18 4. Y ou will need the Wireless MA C address of the tar get WLM2-G54. Enter its MA C address in the field labeled "MA C Address of AirStation (Wireless)." Use the format XX:XX:XX:XX:XX:XX for the MA C address. 5. Click "Add." Repeat this process for up to 5 additional access points.
19 Configure EAP in the Security/802.11g screen. ■ Note: For MA C Access Restr iction, do not check the "Enab le" box until y ou have set up Author ized MA C addresses (Section 9.8.4.3). 9.10.6 Privacy , WEP Set the encr yption method used in wireless communications f or the protection of y our data.
20 9.11.3 Inter val of Checking Connection Inter val timer to check connection with destination host. 9.11.4 Retr y Count The number of times a retr y will be at- tempted when a failed connection is detected. The retr y is perfor med ever y 2 seconds.
21 10.2.1 Unit Information (see previous page) Parameter s used in the WLM2-G54: 1. Model Name: The AirStation model name and firmware ver sion number 2. AirStation Name: The alias for the AirStation 3. Wired Settings: WLM2-G54 ’ s wired MA C address 4.
22 log related to the setup histor y from a browser or T elnet session is recorded. 10.2.5 Ping T est The WLM2-G54 issues a ping test to the tar get PC in order for the AirStation to check the communication link. Input the tar get device ’ s IP address and click "OK".
23 Additional Information For more information, please consult one of the following: • The on-line help system of your AirStation wireless system - for information about software and driver functionality . • The AirStation web site - for frequently ask ed questions (FA Q ’ s) and Software Updates.
24 Appendix A - Intelligent Access P oint (WLM2-G54) Specifications Frequency Band 2.4GHz channel suppor t Oper ating Channels 11 channels; 20 MHz BW 1:2412, 2:2417, 3:2422, 4:2427, 5:2432, 6:2437, 7:2442, 8:2447, 9:2452, 10:2457, 11:2462 Standards IEEE 802.
25 Appendix B - T r oubleshooting This appendix is divided into follo wing sections with each with it ’ s own specif ic troubleshooting tips: • LED Activity on section B.1. • Other Problems on section B.2. B.1 LED Activity • P ow er LED should be GREEN • Wireless LED should be GREEN if the line is active.
26 Client : A PC or a w or kstation on a networ k. CRC (Cyclic Redundancy Check) : Calculation method used to check the accuracy of a digital tr ansmission over a communications link. Cross-Ov er Wiring: A UTP cable that has its tr ansmit and receive wires crossed to allo w communications betw een two devices.
27 of information that is sent in packets across the Internet or Intr anet. Infrastructur e : A wireless netw or k or other small network in which the wireless networ k devices are made a par t of the networ k through the Access P oint. ISP (Internet Ser vice Pro vider) : A company that pro vides access to the Inter net and related ser vices.
28 ROM (Read Onl y Memory) : P er manent memor y . Router : A device that can connect individual LANs and remote sites to a ser ver . Roaming : The ability to use a wireless device and be able to mo ve from one access point to another without losing the connection.
29 Notes:.
30 Notes:.
Buffalo T echnology T echnical Suppor t We b USA http://www .buffalotech.com/wireless EUROPE http://www .buffalo-technology .com CHINA http://www .buffalo-china.
Ein wichtiger Punkt beim Kauf des Geräts Buffalo Buffalo AirStation Pro Intelligent WLM2-G54 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Buffalo Buffalo AirStation Pro Intelligent WLM2-G54 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Buffalo Buffalo AirStation Pro Intelligent WLM2-G54 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Buffalo Buffalo AirStation Pro Intelligent WLM2-G54 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Buffalo Buffalo AirStation Pro Intelligent WLM2-G54 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Buffalo Buffalo AirStation Pro Intelligent WLM2-G54 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Buffalo Buffalo AirStation Pro Intelligent WLM2-G54 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Buffalo Buffalo AirStation Pro Intelligent WLM2-G54. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Buffalo Buffalo AirStation Pro Intelligent WLM2-G54 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
