Benutzeranleitung / Produktwartung RD SERIES des Produzenten Briggs & Stratton
Zur Seite of 32
OPERA T OR’S MANU AL 21HP Hydro Tractors Mfg. No. Description 2690762 Simplicity Baron XL, 21HP w/ 40” Mower (CE) 2690763 Snapper RD21V40, 21HP w/ 40” Mower (CE) 2690772 Massey Ferguson 2421 XL,.
Not for Reproduction.
Regular Maint enance ........................................20 Maintenance Schedule ..........................................20 Check Tire Pressures ............................................20 Safety Interlock System Check .......................
Opera ting Saf ety Congratulations on purchasing a superior-quality piece of lawn and garden equipment. Our products are designed and manufactured to meet or exceed all industry standards for safety.
Slope Opera tion You could be seriously injured or even killed if you use this unit on too steep an incline. Using the unit on a slope that is too steep or where you don’t have adequate traction can cause you to lose control or roll over. A good rule of thumb is to not operate on any slope you cannot back up (in 2-wheel drive mode).
GENERAL OPERA TION 1. Read, understand, and follow all instructions in the manual and on the unit before starting. 2. Do not put hands or feet near rotating parts or under the machine.
CHILDREN Tragic accidents can occur if the operator is not alert to the presence of children. Children are often attracted to the unit and the mowing activity. Never assume that children will remain where you last saw them. 1. Keep children out of the mowing area and under the watchful care of another responsible adult.
SER VICE AND MAINTENANCE Safe Handling of Gasoline 1. Extinguish all cigarettes, cigars, pipes, and other sources of ignition. 2. Use only approved gasoline containers. 3. Never remove the gas cap or add fuel with the engine running. Allow the engine to cool before refueling.
Tractor ID Tag Identifica tion Numbers When contacting your authorized dealer for replacement parts, service, or information you MUST have these numbers. Record your model name/number, manufacturer’s identification numbers, and engine serial numbers in the space provided for easy access.
Saf ety Decals This unit has been designed and manufactured to provide you with the safety and reliability you would expect from an industry leader in outdoor power equipment manufacturing.
Warning: Read Operator’s Manual. Read and understand the Operator’s Manual before using this machine. Danger: Thrown Objects. This machine is capable of throwing objects and debris. Keep bystanders away. Warning: Remove Key Before Servicing. Remove the key and consult technical literature before performing repairs or maintenance.
12 F ea tures & Contr ols Throttle/Chok e Control (Single Lever Models) The throttle/choke lever controls engine speed and choke. Move the throttle forward to increase engine speed and back to decrease engine speed. Always operate at FULL throttle.
Headlight s The light switch turns the tractor headlights on and off. Brak e P edal Depressing the brake pedal applies the tractor brake. Hour Met er (Optional) The hour meter measures the number of hours the key has been in the RUN position (A).
Seat A djustment L e ver The seat can be adjusted forward and back. Move the lever, position the seat as desired, and release the lever to lock the seat into position. T ransmis sion Release V alv e Le ver The transmission release valve lever deactivates the transmission so that the tractor can be pushed by hand.
G eneral Oper ating S afety Be sure to read all information in the Safety and Operation sections before attempting to operate this unit. Become familiar with all of the controls and how to stop the unit. Adding F uel To add fuel: 1. Remove the fuel cap (A, Figure 2.
16 Opera ting the T ractor If an operator chooses to mow in reverse, the RMO system can be used. To use the Reverse Mowing Option (RMO) turn the RMO key after the PTO is engaged. The L.E.D. light will illuminate, and the operator can then mow in reverse.
17 Opera ting the T ractor Figure 3. Engaging the Parking Brake A. Ground Speed Pedals B. Brake Pedal C. Parking Brake Knob Figure 4. Emptying the Hopper A. Catcher Dump Pedal B. Catcher Lever P arking Brake F unction Applying the Parking Brake - See Figure 3.
Ca tcher R emov al AND Installa tion 1. Move the catcher removal knob (C, Figure 6) forward to unlock the catcher from the rear support arms. 2. Depress the catcher dump lock pedal (A). 3. Use the catcher lever (B) to open the catcher slightly. 4. Lift the catcher off the rear support arms.
12 V olt P ower Outle t (certain models) The 12-volt accessory plug is located in the left side pod (Figure 1). It can be used to power small electronic devices. The accessory must be rated at 14 amps or less. NOTE: Operating a 12-volt accessory, especially with the engine at idle, may cause battery discharge.
Maintenance Schedule The following schedule should be followed for normal care of your tractor and mower. Check Tire Pr essur es Tire Pressure should be checked periodically, and maintained at the levels shown in the chart (Figure 7). Note that these pressures may differ slightly from the “Max Inflation” stamped on the side-wall of the tires.
Ba ttery Maintenance Cleaning the Batt ery and Cables 1. Disconnect the cables from the battery, negative cable first (A, Figure 8). 2. Remove the battery hold-down (C) and battery. 3. Clean the battery compartment with a solution of baking soda and water.
T roubleshooting While normal care and regular maintenance will extend the life of your equipment, prolonged or constant use may eventually require that service be performed to allow it to continue operating properly. The troubleshooting guide below lists the most common problems, their causes, and remedies.
T roubleshooting the T ractor (Continued) PROBLEM LOOK FOR REMED Y Brake will not hold. Internal brake worn. See authorized dealer. Tractor steers hard or handles poorly. Steering linkage is loose. See authorized dealer. Improper tire inflation. See Check Tire Pressure section.
Sea t Adjustment Pitch Adjustment The pitch of the seat can be adjusted to one of three positions. See your dealer for assistance. Seat Slide A djustment The seat can also be adjusted forward and back. Move the lever (A, Figure 9), position the seat as desired, and release the lever to lock the seat into position.
Ba ttery Charging A dead battery or one too weak to start the engine may be the result of a defect in the charging system or other electrical component.
26 1737660 Rev B BRIGGS & STRA TTON POWER PRODUCTS GROUP , L.L.C. OWNER W ARRANTY POLICY LIMITED W ARRANTY Briggs & Stratton Power Products Group, LLC will repair and/or replace, free of charge, any part(s) of the equipment that is defective in material or workmanship or both.
27 Specifica tions ENGINE 21 HP* Briggs & S tratton Make Briggs & Stratton Model Twin Vanguard (385777) Horsepower 21 Displacement 38.2 cu in. (627 cc) Electrical System Alternator: 12 volt, 16 amp Battery: 230 CCA Oil Capacity 48 oz (1,4 L) CHAS SIS Fuel Tank Cap Capacity: 2.
Replacement P ar t s Replacement parts are available from your authorized dealer. Always use genuine Simplicity Service Parts. Engine Oil Touch-Up Paint Grease Gun Kit 8 oz.
Not for Reproduction.
Not for Reproduction.
Not for Reproduction.
www.MasseyLawn.com www.snapper.com Briggs & Stratton Power Products Group, L.L.C. Copyright © 2010 Briggs & Stratton Corporation Milwaukee, WI USA.
Ein wichtiger Punkt beim Kauf des Geräts Briggs & Stratton RD SERIES (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Briggs & Stratton RD SERIES noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Briggs & Stratton RD SERIES - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Briggs & Stratton RD SERIES reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Briggs & Stratton RD SERIES erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Briggs & Stratton RD SERIES besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Briggs & Stratton RD SERIES verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Briggs & Stratton RD SERIES. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Briggs & Stratton RD SERIES gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
