Benutzeranleitung / Produktwartung RS576PXP des Produzenten Whirlpool
Zur Seite of 24
d304NCH SLIDE-IN ELECTRIC RANGE WITH CONVERTIBLE COOKTOP Model RS576PXP -Oven Vent Y Plug-In Surface Unlts / Heat Deflector Cooktop Module Reflector Bow Control Panel Model and Serial Number Plate Automatic Oven Front Frame FIberglass Uen,C.
Your responsibilMzs. l l Proper Installation and safe use of the range are your personal responslbilltles. Read this “Use and Care Guide” and the “Cooking Gulde”carefully for important use and safety information. Installation You must be sure your range is.
I . FOR YOUR SAFETY l I DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS AND LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE. I.
Using your range Oven Selector / Manual Oven Light Switch / / / Adjustable Oven Oven Signal Light Clean Light Lock Light l Left Coo top Module Temperature Control Signal Light SETTING THE CLOCK Push in and turn the Minute Timer Knob to set the Clock. 1.
Surface Unlt Minute Timer Control Knob I Stop Time Knob Right Cooktop Module Signal Light SurGce UnItI Cooktop Module lndlcator Start Ti&e Knob THE UVEN CONTROLS The oven is controlled by two knobs: the Oven Selector and the Oven Tempera- ture Control.
BAKING OR ROASTING Put the rack(s] where you want them before turning on the oven. Rack(s) should be placed so food can be centered in the oven. Always leave at least 1 1 2 to 2 inches (4-5 cm) between the sides of the pan and the oven walls and pans.
1. Place the rack where you 2. Put the broiler pan and want it for broiling. food on the rack. 4. Set the Oven Temperature 5. During broiling, the oven Control on BROIL (or on a door must be partly lower temperature for open. A built-in stop will slower broiling).
USING THE AUIOMAnC MEALTIMER* CLOCK The Automatic MEALTIMER Clock is designed to turn the oven on and off at times you set...even when you are not around. IMPORTANT: follow these steps In order. To start and stop baklng automatically: 1. Put the racks where you 2.
If the steps for using the Automatic MEALTIMER’ Clock are not followed in order, the electric oven door lock may be turned on. The door will then either: 0 not open; l not close all the way [the oven light stays on]. If the Door Won’t Open: 1. Make sure the Clock and Start and Stop Times are set to the right time of day.
SURFACE UNIT CONTROLS Uni Ill you get used to the settings, use the followlng as a gulde. , Control knob y-L be pushed In b t turnlng them to a set- ting. They can be set anvwhere between HI an6 OFF. PUSH IN. Turn to setting. The slgnal light will glow when a surface unlt Is on.
CHANGING COOKTOP MODULES The Cooktop Modules will work on either side of the cooktop. Make sure all controls are OFF and modules are cool before removlng them. SURFACE UNIT MODULES 1. To remove, lift slightly by the handle. 4. Replace in reverse order.
USING THE COOKIOP MODULES OPTIONAL GRIDDLE , Before using the griddle for the first time: 1. Wash, rinse and dry griddle. l Use warm sudsy water. l DO NOT immerse griddle. l DO NOT use metal scouring pads or abrasive cleansers. They will damage griddle.
GRILL MODULE A range hood (Whirlpool Model No’sRH8330 or RH8336) should be used to help get rid of smoke while using the Grill Module. Approximate Grill Module Cooklng Tlmes Preheat grill for five minutes at suggested setting.
OPTIONAL ROTISSERIE Rotlrrerle Parts The Rotisserie has 4 parts. It IS used with the Grill Module. 1. Remove the grills from the Grill Module. 2. Insert rear sup- port tabs into slots at rear of the Grill Module. 3. Slide forward to lock. Tilt top to level.
Approximate rotlsserle cooklng tlmes: Internal Control Spit Food Temperature Weight Setting(s) POSItIOn Time Comments Beet Rolled rib 140 F 3121bs Hi High 1 hr. Meat with an (rare) (60 Cl II.5 kg) 55 min. outer layer of fat Rolled rump 140 F 3141bs. Hi High 2 hr.
Cleaning and caring for your range CONTROL PANEL AND KNOBS 1. Flrst make sure knobs are set on OFF then pull knob stralght otf. 2. Use warm soapy water and a soft cloth to wipe the panel. Rinse and wipe dry 3. Wash knobs In warm soapy water Rinse well and 4.
Terminal 3. Hold the surface unit as level as possible with the terminal just started into the 4. While pushing the surface unit terminal into the receptacle, lift a little on the edge of the unit nearest the receptacle. 5. When the terminal is pushed into the re- ceptacle as far as it will go, the surface unit will fit into the reflector bowl.
SPECIAL TIPS 4. Keep the kitchen well 2. Clean the oven before 3. If the cleaning cycle ventilated durrng the It gets heavrly soiled doesn’t get the oven as cleanrng cycle to help Cleonrng a very so.
4. Set the Oven Temper- ature Control to CLEAN. 7. Turn the Oven Temper- ature Control to OFF. 5. The Lock Light comes on when the oven gets above normal baking temperatures. The door can’t be unlocked when the Lock Light is on. 6. When the Lock Light goes off, turn the Oven Selector to OFF.
CLEANING CHART PART WHAT TO USE HOW TO CLEAN Surface Units Do not clean l Sol1 burns off. l Do not Immerse Griddle Module and Cover Warm soapy water l Do not Immerse grlddle. l Wash, rinse and dry well. l Do not use metol scouring pads or harsh cleansers l Use olastlc scourlna ood If needed.
STORAGE DRAWER The storage drawer is for storing pots and pans. Never store anything that can burn or melt in the drawer. 1. Pull drawer straight out to 2. Lift front and pull out to 3. Lift back slightly and the first stop. the second stop. slide drawer all the way out.
If the Self-Cleanlng cycle will not operate: l Are the Oven Selector and the Oven Tem- perature Control set to “CLEAN?” l Does the Start Time Dial show the correct time of day? l Is the Stop Time .
THIS PAGE INTENTIONALLY LEFT BLANK.
FSP quality parts. Look lor thk symbol of quallty whenever you need a replacement part ’ for your Whirlpool appliance. FSP replacement parts will fit right and work right. because they are made to the same exacting speclftcatiorw used to build every new Whirlpool appliance.
Ein wichtiger Punkt beim Kauf des Geräts Whirlpool RS576PXP (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Whirlpool RS576PXP noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Whirlpool RS576PXP - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Whirlpool RS576PXP reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Whirlpool RS576PXP erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Whirlpool RS576PXP besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Whirlpool RS576PXP verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Whirlpool RS576PXP. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Whirlpool RS576PXP gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
