Benutzeranleitung / Produktwartung RF363PXVT des Produzenten Whirlpool
Zur Seite of 24
RANGE Self-Cleaning Models RF363PXVT (Shown) RF3620XV hers. Clothes Dryers. Freezers. Relrlgeralor-Freezers Ice Makers. Olshwashers. Bu~ll-In Ovens and Surface Umlr Ranoes Microwave Ovens Trash Comoac.
Contents BEFORE YOU USE YOUR RANGE.................... IMPORTANT SAFETY INSTRUCTIONS PARTS AND FEATURES 1 USING YOUR RANGE. Using the Surface Units Optional Canning Kit Setting the Clock Using the Min.
IMPORTANT SAFETY INSTRUCTIONS 1. DO NOT allow children to use or 6. KEEP pan handles turned in, but play with any part of the range, not over another surface unit to or leave them unattended near it. avoid burns, injury and to help They could be burned or injured.
Parts and features Models RF363PXVT and RF3620XV AUTOMATIC MEALTIMER* START CLOCK/MINUTE TIMER TIME LEFT FRONT SUdFACE UNIT LEFf REAR STdP CONTROL KNOB SIGNAL LIGHT CONTROL KNOB TIME CONTROL PANEL B.
OVEN LIGHT SWITCH (RF363PXVT~only) OVEN TEMPERATURE OVEN SURFACE UNIT CONTROL , / SELECTOR INDICATOR Using your range Using the Surface Units Surface Unit Indicators The solid dot in the surface unit PUSH IN indicator shows which surface unit :: AND TURN is turned on by that knob.
Use only flat-bottomed utensils for best cooking results and to prevent damage to the cooktop. Specialty items with rounded or ridged bottoms (woks, ridged bottom canners or tea kettles) are not recommended. See the Cooking Guide for important utensil information.
Setting the Clock Push in and turn the Minute Timer Knob to set the Clock. 1. Push in Minute Timer Knob and turn clockwise until clock shows the right time of day. 2. let the Minute Timer Knob pop out. Turn clockwise until Minute Timer hand points to OFF.
Using the Oven Controls Baking 1. Position the rack(s) properly before turning on the oven. To change rack position, lift rack at front and pull out. 2. Set the Oven Selector on BAKE. The “on” Signal Light will come on. 4. Put food in the oven. NOTE: Oven racks, walls and door will be hot.
Does your oven seem hotter or colder than your old oven? The temperature of your old oven may have shifted gradually without you noticing the change. Your new oven is properly adjusted to provide accurate temperatures. But when comparing to your old oven, the new design may give you different results.
Broiling 1. Position the rack before turning the oven on. See “Broil Chart’ in the Cooking Guide or a reliable cookbook for recommended rack positions. 3. Close the door to the Broil Stop position (open about 4 inches, 10.2 cm). The door will stay open by itself.
Using the Automatic MEALTIMER” Clock The automatic MEALTIMER* Clock is designed to turn the oven on and off at times you set, even when you are not around. Automatic baking is ideal for foods which do not require a preheated oven, such as meats and casseroles.
To start baking now and stop automatically: 1. Position rack(s) properly and place the food in the oven. 2. Make sure the clock is set to the right time of day. 3. Push in and turn the Stop Time Knob clockwise to the time you want the oven to shut off.
The Storage Drawer The storage drawer is for storing pots and pans. Use care when handling the drawer. Removing the storage drawer 1. Pull drawer straight out to the first stop. Lift front and pull out to the second stop. -- 2. Lift back slightly and slide drawer all the way out.
Optional Rotisserie If you would like a rotisserie for your oven, you can order a kit [Part NO. RCK-BV242985) from your Whirlpool Dealer. The kit includes easy installation instructions.
3. Pull the surface unit straight away from the receptacle. Replacing 4. Lift out the reflector bowl. See ” Cleaning Chart ” on page 20 for cleaning instructions. 2. Line up openings in the reflector I bowl with the surface unit recep- tacle and the element hold down 3.
CAUTION: Reflector bowls reflect heat back to the utensils on the surface units. They also help catch spills. When they are kept clean, they reflect heat hefter and look new longer. If a reflector bowl gets discolored, some of the utensils may not be flat enough, or some may be too large for the surface unit.
Using the Self-Cleaning Cycle The Self-Cleaning cycle uses very high heat to burn away soil. Before YOU start, make sure YOU understand exactly how to use the Self-Cleaning cycle safely. . Before You Start 1. Clean the shaded areas by hand. They do not get hot enough during the Self-Cleaning cycle for soil to burn away.
Setting the Controls Be sure the kitchen is ventilated during the Self-Cleaning cycle. This will help normal smoke and heat odors to disappear from the room as quickly as possible. L , 1. Set the Oven Selector and Oven Temperature Control on CLEAN. The “on” Signal Light will come on.
Special Tips l Keep the kitchen well ventilated during the Self-Cleaning cycle to help get rid of normal heat, odors and smoke. l Clean the oven before it gets heavily soiled. Cleaning a very soiled oven takes longer and results in more smoke than usual.
Cleaning Chart PART WHAT TO USE HOW TO CLEAN Exterior surfaces (porcelain and chrome finish) Warm soapy water and a soft cloth. Plastic scrubbing pad for stubborn spots. l Wipe off regularly when range is cool. l Do not allow food containing acids (such as vinegar, tomato, lemon juice or milk) to remain on surface.
The Oven Light Model RF363PXVT: The oven light will come on when you push the Oven Light Switch on the control panel. Push it again to turn off the light. Model RF3620XV: The oven light will come on when you open the oven door. To Replace : 3. Remove the light bulb from its socket.
If you need service or assistance, we suggest you follow these five steps: 1. Before calling for assistance... Performance problems often result from little things you can find and fix without tools of any kind. If nothing operates: l Is the power supply cord plugged into a live circuit with the proper volt- age? [See Installation Instructions.
3. If you need service*... Whirlpool has a nationwide network of fran- T&W-CARE FRANCHlSED SERVICE j TECH-CARE serv- ice technicians are trained to fulfill the product war- ranty and provide after-warranty service, anywhere in the United States.
WHIRLPOOL’! RANGE PRODUCT WARRANTY EROOl LENGTH OF WARRANTY WHIRLPOOL WILL PAY FOR FULL ONE-YEAR WARRANTY FSP replacement parts and repair laborto From Date of Purchase correct defects in materlals or workmanship. Service must be provided by a franchised TECH-CARE’ service company.
Ein wichtiger Punkt beim Kauf des Geräts Whirlpool RF363PXVT (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Whirlpool RF363PXVT noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Whirlpool RF363PXVT - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Whirlpool RF363PXVT reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Whirlpool RF363PXVT erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Whirlpool RF363PXVT besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Whirlpool RF363PXVT verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Whirlpool RF363PXVT. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Whirlpool RF363PXVT gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
