Benutzeranleitung / Produktwartung eh72 des Produzenten Subaru Robin Power Products
Zur Seite of 35
FOR EMISSION CERTIFIED ENGINE R ISSUE EMD-EU1725 2ZZ9020085 MODEL Warrnty_EH72D EPA/CARB_FOR RMI 02.7.12 7:38 PM ページ01.
NOTICE FEDERAL EMISSION COMPONENT DEFECT WARRANTY and CALIFORNIA EMISSION CONTROL WARRANTY are applicable to only those engines complied with EPA (Environmental Protection Agency) and CARB (California Air Resources Board) emission regulations in the U.
FEDERAL EMISSIONS COMPONENT DEFECT W ARRANTY EMISSIONS COMPONENT DEFECT WARRANTY COVERAGE - This emission warranty is applic- able in all States, except the State of California Fuji Heavy Industries Ltd.
*The replacement parts used for required maintenance services. *Consequential damages such as loss of time, inconvenience, loss of use of the engine or equip- ment, etc. *Diagnosis and inspection charges that do not result in warranty-eligible service being performed.
CALIFORNIA EMISSION CONTROL W ARRANTY ST A TEMENT YOUR W ARRANTY RIGHTS AND OBLIGA TIONS The California Air Resources Board and Fuji Heavy Industries Ltd. (herein "FUJI") are pleased to explain the emission control system warranty on your 2001 and later Small Off-Road engine (herein "engine").
LIMITED W ARRANTY on Emission Control Systems - California Only - FUJI warrants to the owner of the 2001 and later engine that the engine (1)has been designed, built and equipped so as to conform at t.
(4) repairs performed outside of the authorized warranty service dealers (5) use of parts which are not authorized by FUJI. 2. Add-on or modified parts This warranty does not cover any part that malfunctions, fails or is damaged due to alter- ations by changing, adding to or removing parts from the engine.
(5) Miscellaneous Items Used in Above Systems (i)Electronic controls, if applicable (ii)Hoses, belts, connectors, and assemblies. (iii) Filter lock assy (gaseous fuel, if applicable) I.
FOREWORD Thank you very much for purchasing a ROBIN ENGINE . Y our ROBIN ENGINE can supply the power to operate various sorts of machines and equipment. Please take a moment to familiarize yourself with the proper operation and maintenance procedures in order to maximize the safe and efficient use of this product.
CONTENTS 1. SAFETY PRECAUTIONS ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ 1 2. COMPONENTS ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ 4 3.
Read the owner's manual. Stay clear of the hot surface. Exhaust gas is poisonous. Do not operate in an unventilated area. Stop the engine before refueling. Fire, open flame and smoking prohibited. On (Run) Plus ; positive polarity Off (Stop) Battery Engine oil Engine start (Elec- tric start) Add oil SYMBOLS Warrnty_EH72D EPA/CARB_FOR RMI 02.
EXHAUST PRECAUTIONS ■ Never inhale exhaust gas. It contains carbon monoxide, a color- less, odorless and extremely danger- ous gas which can cause uncon- sciousness or death. ■ Never operate the engine indoors or in a poorly ventilated area, such as tunnel, cave, etc.
SURROUNDINGS ■ Operate the engine on a stable, level surface free of small rocks, loose gravel, etc. − 2 − PROTECTIVE COVER ■ Place the protective covers over the rotating parts. If rotating parts such as the drive shaft, pulley , belt, etc. are left exposed, they are potentially hazardous.
PRE-OPERA TION CHECKS . ■ Carefully check fuel hoses and connections for looseness and fuel leakage. Leaking fuel creates a potentially dangerous situation. ■ Check bolts and nuts for looseness. A loose bolt or nut may cause seri- ous engine trouble.
− 4 − 2. COMPONENTS REMARKS : ■ Fuel tank, valve (sediment bowl type is recommended), fuel hoses, and fuel filter are required for connecting fuel source to carburetor . ■ A battery rated at 12V -36AH or larger with the specified cable are required for electric starter operation.
3. PRE-OPERA TION CHECKS − 5 − Upper level Lower level Oil gauge Oil gauge 5W 10W 20W #20 #30 #40 10W-30 10W-40 Single grade Multi grade Ambient temperature -20 -10 0 10 20 30 40 -4 14 32 50 68 86 104 ■ When filling oil in the engine, keep the engine level and fill the oil up to the upper mark of the oil gauge.
− 6 − CHECK FUEL ■ The fuel tank shall be provided sepa- rately , because the engine is not equipped with a fuel tank. A fuel valve and fuel filter should be connected between the fuel tank and fuel pump. Securely connect with fuel hoses to the fuel pump to prevent leakage.
4. BA TTER Y INST ALLA TION − 7 − CABLE LENGTH CABLE DIA. WIRE GAUGE AWG (BS) BWG SAE JIS Less than 1.5 m 7.3 mm 1 6 AV15 1.5 m to 2.5 m 8.5 mm 0 4 AV20 2.5 m to 4.0 m 10.8 mm 3/0 2 AV30 P ARTS NEEDED ■ Use a battery rated 12V -36AH or larger . ■ Use a proper cable and ground wire to connect battery and key switch and electric starter .
− 8 − WIRING ■ Connect positive terminal of the electric starter and positive termi- nal of the battery with battery cable. ■ Ground negative terminal of the battery to the body of engine or machine with ground wire. NOTE T ighten bolts and nuts on terminals securely so they will not be loosened by vibration.
5. OPERA TING YOUR ENGINE − 9 − Pull the choke knob. ■ If the engine is cold or the ambient temperature is low , pull the choke knob fully . ■ If the engine is warm or the ambient temperature is high, pull the choke knob half-way , or keep it fully open.
− 10 − ■ After starting the engine, gradu- ally open choke by pushing the choke knob and finally keep it fully opened. ■ Do not fully open the choke immediately when the engine is cold or the ambient temperature is low , because the engine may stop.
− 11 − STOPPING Set the speed control lever at the low speed position and allow the engine to run at low speed for 2 or 3 minutes before stopping. SPEED CONTROL LEVER 2 T urn the key switch to the "STOP" position. ELECTRIC ST ARTER 3 Close the fuel valve.
6. EASY TROUBLESHOOTING − 12 − WHEN ENGINE WILL NOT ST ART : ■ Perform the following checks before you take the engine to your Robin dealer . ■ If you still have trouble after completing the checks, take the engine to your nearest Robin dealer .
− 13 − Is your battery well charged ? Check the battery , it may be discharged and unable to operate the electric starter . Consult your nearest dealer or service shop.
− 14 − 7. MAINTENANCE SCHEDULE DAIL Y INSPECTION Before running the engine, check the following service items. PERIODIC MAINTENANCE Periodic maintenance is vital to safe and efficient operation of your engine. Check the table below for periodic maintenance intervals.
− 15 − Maintenance Items Every 8 hours (Daily) Every 20 hours Every 200 hours Every 500 hours Every 1000 hours Clean engine and check bolts and nuts ● (Daily) Check and refill engine oil ● (Re.
8. "HOW -T O" MAINTENANCE − 16 − INSPECTING THE SP ARK PLUG ■ Clean off carbon deposits on the spark plug electrode using a plug cleaner or wire brush. ■ Check electrode gap. Adjust gap to : 0.03 inches (0.7mm to 0.8mm) ■ Use a proper spark plug : NGK BPR6ES 0.
− 17 − ENGINE OIL FIL TER REPLACEMENT ■ Initial engine oil filter replacement should be performed after 20 hours of operation. Thereafter replace the engine oil filter every 200 hours.
FUEL AND OIL HOSE REPLACEMENT CHECKING BA TTER Y − 18 − Replace the fuel and oil hose every 1,000 hours or every year . If fuel and oil hose leak is found, replace the hose immediately . W ARNING Ta ke extreme caution when replac- ing fuel hose ; gasoline is flamma- ble.
− 19 − HIGH AL TITUDE ENGINE OPERA TION ■ Please have an authorized Robin America service dealer modify this engine if it is to be run continuously above 5,000 feet (1,500 meters). Failure to do so, may result in poor engine performance, spark plug fouling, hard starting, and increased emissions.
9. PREP ARA TIONS FOR ST ORAGE − 20 − ENGINE OIL ■ Change the engine oil with fresh oil. ■ Remove the spark plug, pour about 5 cc of engine oil into the cylinder , slowly start the engine for 2 or 3 seconds, and re-install the spark plug. CLEAN AND STORE ■ Remove the spark plug wires from the spark plugs.
10. SPECIFICA TIONS − 21 − MODEL EH72D Type Air-Cooled, 4-Stroke, V-Twin Cylinder, Horizontal P.T.O. shaft, OHV Gasoline Engine Bore x stroke 2 - 3.31 in x 2.56 in (84 mm x 65 mm) Displacement 43.9 cu in. (720 cm 3 ) Continuous Output kW (HP) / rpm 13.
R Warrnty_EH72D EPA/CARB_FOR RMI 02.7.12 7:38 PM ページ22.
R Warrnty_EH72D EPA/CARB_FOR RMI 02.7.12 7:38 PM ページ23.
July 2002 CE-RMI PRINTED IN JAPAN Warrnty_EH72D EPA/CARB_FOR RMI 02.7.12 7:38 PM ページ25.
Ein wichtiger Punkt beim Kauf des Geräts Subaru Robin Power Products eh72 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Subaru Robin Power Products eh72 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Subaru Robin Power Products eh72 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Subaru Robin Power Products eh72 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Subaru Robin Power Products eh72 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Subaru Robin Power Products eh72 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Subaru Robin Power Products eh72 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Subaru Robin Power Products eh72. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Subaru Robin Power Products eh72 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
