Benutzeranleitung / Produktwartung Gas Hob CIR60X3 des Produzenten Smeg
Zur Seite of 24
Index 1. INSTRUCTIONS FOR SAFE AND PROPER USE ________________ 4 2. POSITIONING OF HOB ____________________________________ 6 3. GAS CONNE CTION ______________________________________ 11 4. ELECTRICAL CO NNECTION ______________________________ 12 5. ADAPTATION TO DIFFERENT TYPES OF GAS _______________ 13 6.
Introduction 1. INSTR UCTIONS FOR SA FE AND PR OPER USE THIS MANUAL IS AN INTE GRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT I N ITS ENTIRETY AND I N AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE COOKING HOB. WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTI ONS THEREIN BEFORE USING THE COOKING H OB.
Introduction THE IDENTIFICATION PLATE, WITH TECHNIC AL DATA, SERIAL NUMBE R AND MARKING IS CLEARLY VISIBLE UNDER THE CASING. THE PLATE ON THE CASING MUST N OT BE REMOVED. BEFORE CONNECTING THE DEVICE, MAKE SURE THAT IT H AS BEEN REGULATED FOR THE TYPE OF GAS THAT WILL FEED IT, CHECKING THE LABEL UNDER THE CASING.
Instructions for the installer 6 2. POSITIONING OF HOB It is the law that all gas applia nces are installed by authorised persons . Clearance around th e appliance must com ply with the requireme nts of AS5601. The following operation r equires bu ilding and/or carpentry w ork so must be carried out by a competent tradesman.
Instructions for the installer In case of installation on a hollo w compartment with doors, a separating panel has to be placed under the hob. Keep a minimum distance of 10 mm between the bottom of the unit and the panel surface. The panel has to be easily removable to allow access in the event of te chnical service.
Instructions for the installer 8 2.2 Clearance above and around domestic appliances Extract from AS5601 REQUIREMENTS 1 Overhead clearances – (Mea surement A ) Range hoods and exhaust fans sha ll be installe d in accordanc e with the manufacturer’s instructio ns.
Instructions for the installer Where B , measured from the periphery of the nearest bur ner to any vertical com bustible surface , is less than 20 0 mm , the surface shall be protected in accordance wit h Clause 5.12 .1.2 to a height C of not less than 150 mm above the hob for the full dime nsion (width or depth) of the cooking surfac e area.
Instructions for the installer 10 2.3 Room ventilation Caution – This hob may only be insta lled and op erated in rooms permanently v entilated in a ccordance wit h current regulations. For proper operation of a gas applia nce it is es sential for the air nec essary for combustion of the gas to be able to flow naturally into the r oom.
Instructions for the installer 3. GAS CONNECTION This appliance is s uitable for inst allation wit h Natural Gas or LPG (propa ne). Refe r to page 12 for the relevant burner press ure and appr opriate injector sizes. W hen the app liance is to be connected to Natural Gas then t he pressure regulator suppl ied must be fitted to th e gas inlet.
Instructions for the installer 12 4. ELECTRICAL CONNECTION Make sure that the voltage a nd capacity of th e power line conform to the data shown on the plate l ocated under the casin g.
Instructions for the installer 5. AD APT A TION T O DIFFERENT TYPES OF GAS Before performing any cleaning or maintenance work, detach the appliance from the electrical socket. The hob has been inspected for NG natural gas at a pressure of 1.0 kPa. For functioning with other types of gas t he nozzles m ust be repl aced and the primary air adj usted.
Instructions for the installer 14 5.2 Regulation for LPG Loosen screw A and push support B all the w ay. Use a do uble hea d wrench to remove n ozzle C and ass emble the suitabl e one, following the instructions indicated in the referenc e charts, with r espect to the type of gas to use.
Instructions for the installer 5.3 Regulation for natural gas The hob has been adj usted for natural gas at a pressure of 1.0kPa. To allow the unit to work ba ck with this type of gas, after it has been adjusted for L PG, perform the s ame operations described in paragrap h “ 6.
Instructions for the installer 16 6. FINAL OPERA TIONS Having carried out the ab ove adjustments, reassemble t he appliance following, backwards, th e inst ructions in paragra ph “ 6.1 Removing the hob ”. 6.1 Regulation of minimum for natural gas Replace the co mponents on t he burner a nd slide the knobs on the gas tap pins.
Instructions for the installer 6.3 Arrangement of burn ers on hob BURNERS 1 Auxiliary 2 Semi-rapid 3 Rapid 4 Rapid 5 WOK 6.4 Lubrification of gas taps After a while, the gas tap may become hard to turn o r lock. If this happens, it has to be cleaned i nside and re-greased.
Instructions for the user 18 7. USING THE HOB Before turning on the burners, make sure that the burner rin gs, caps and grids have been fitted correctly. In the ultrarapid burner, notch A must be aligned with pin B . Grid C provided is intended for use with wok s (Chinese pans).
Instructions for the user 7.2 Practical advice for u s ing the burners For better burner performance and minimum ga s consumption, flat bottomed, even reci pients must be used, with covers and proporti onal in siz e to the burners (se e paragra ph “ 7.
Instructions for the user 20 7.4.2 Using the electric elements The electric elements are idea l for ultrarapid cooking. The settings shown in the table are merely in dicative. POSITION HEAT INTENSITY POSSIBLE COOKING - 0 Off To melt butter, chocolate, etc.
Instructions for the user 8. CLEANING AND MAINTENANCE Before any intervention, disconnect the power supply of the device. 8.1 Cleaning Clean the cooking top regul arly every time you use it, obv iously after it has cooled. Never use a steam jet to clean the appliance.
Instructions for the user 22 8.2 Cleaning of cooking hob components CAUTION: do not wash these components in a dishwasher. In normal use of the hob, the stainless steel burner caps and pan-stands tend to be burnished by the high temp erature. Clean thes e parts using very fine abrasive sponges or similar commercial pr oducts.
Instructions for the user 8.3 Preventive maintenance This appliance does not nee d any speci al maintena nce. However, a few simple operati ons have to be carried out peri odicall y to prevent malfunc.
Instructions for the user 24 9. PR OBLEMS AND CA USES Each of the followi ng cases is caused by a n abnormal op eration of th e appliance and should be dealt with by a authoris ed persons: pleas e contact your local de aler or Service Ce nter in case you detect a ny of these malfunctioning.
.
914773400/ B.
Ein wichtiger Punkt beim Kauf des Geräts Smeg Gas Hob CIR60X3 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Smeg Gas Hob CIR60X3 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Smeg Gas Hob CIR60X3 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Smeg Gas Hob CIR60X3 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Smeg Gas Hob CIR60X3 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Smeg Gas Hob CIR60X3 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Smeg Gas Hob CIR60X3 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Smeg Gas Hob CIR60X3. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Smeg Gas Hob CIR60X3 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
