Benutzeranleitung / Produktwartung SRS620DW des Produzenten Samsung
Zur Seite of 36
SIDE BY SIDE REFRIGERA T OR OWNER’S MANUAL AND INST ALLA TION ENGLISH DA99-00494B REV ( 0.7 ) CONTENTS SAFETY WARNING ....................................................................................2 OPERATING INSTRUCTIONS SETTING UP THE REFRIGERATOR .
Represents something you must follow. Represents something you must NOT touch. Represents something you must NOT SAFETY W ARNINGS CAUTION/WARNING SYMBOLS USED OTHER SYMBOLS USED Indicates that a danger of death or serious injury exists. Indicates that a risk of personal injury or material damage exists.
If the refrigerator is not to be used for a long period of time, pull out the power plug. • Deterioration in the insulation may cause fire. The appliance is not intended for use by young children or infirm persons without supervision. Young children should be supervised to ensure that they do not play with the appliance.
4 SETTING UP THE REFRIGERA T OR Place the refigerator in an appropriate location with reasonable clearance between the wall and the refigerator. (refer to installation instructions in this mannal) MAJOR FEA TURES Twin Cooling System • The refrigerator and the freezer have two evapora tors.
5 OPERA TING INSTRUCTIONS CONTROL P ANEL Basic Model Dispenser Model FREEZER TEMP. BUTTON To set the freezer temperature, press the but- ton repeatedly to change the set temperature in sequence between -14°C and -25°C FRIDGE TEMP.
6 CONTROL P ANEL Cool Select zone Cool Select zone Basic Model (With CoolSelect Zone) Dispenser Model (With CoolSelect Zone) DA99-00494B (EN)-0.7 7/22/04 12:36 PM Page 6.
7 OPERA TING INSTRUCTIONS DIGIT AL P ANEL Freezer Temp. indicates the current freezer temperature. Fridge Temp. indicates the current refrigerator temperature. Quick Cool, Thaw, and Select show the status of the CoolSelect Zone TM Drawer • This light indicates the recyclable deodorizer is in operation.
8 TEMPERA TURE CONTROL Press the Ice Type button to select the type of ice: • Cubed Ice • Crushed Ice • No Ice If the Ice remains in the Ice bucket, the cubed ice is obtained. Push the ice dispenser lever with a cup. • Place a cup to line of the dispenser lever to prevent the ice from jumping out.
9 USING THE W A TER DISPENSER (OPTION) OPERA TING INSTRUCTIONS With the water dispenser, you can obtain chilled water easily without opening the refrigerator door. In addi- tion, you can save electricity by reducing the number of times the door is opened by more than 30%.
10 • Gurgling sounds may be heard when air enters the water tank from regular mineral water or beverage bottles. • Some regular mineral water or beverage bottles may not fit the water supply device, depending on their size. • If water does not come out satisfactorily when you press the “push” button, press it again.
11 OPERA TING INSTRUCTIONS SHEL VES AND BINS REFRIGERA TOR Door Bin Ice maker Ice chute Light Shelf Twist ice maker Ice tray Drawer Front leg cover FREEZER Basic model Model with ice and water dispens.
12 FOOD ST ORAGE GUIDE FROZEN FOOD ST ORAGE IN FREEZER Tempered Glass Shelf • Can be used to store all types of frozen food. Door Bin • Can be used for small packages of frozen food. Plastics Drawer • Can be used to store meat and dry foods. Stored food should be wrapped securely using foil or other suitable wrapping materials or containers.
13 OPERA TING INSTRUCTIONS FOOD ST ORAGE GUIDE Tempered Spill Proof Glass Shelf • Can be used to store all types of chilled food. • Safe and hard to be broken. • Circular marks on the glass surface are a normal phenomenon. Foldable shelf (optional) • If you need more taller space for tall items.
14 CoolSelect Zone TM Drawer GUIDE “Select” button (Optional) Soft Freeze • When “Soft Freeze” is chosen, the temperature on the digtal panel displays -5 o C regardless of the set temperature of the refrigerator. • “Soft-Freeze” temperature helps keep meats and fishes fresh longer.
15 OPERA TING INSTRUCTIONS CoolSelect Zone TM Drawer GUIDE “Quick Cool” button “Thaw” button • You can use the Quick Cool feature with the CoolSelect Zone TM . • “Quick Cool” allows 1~3 canned beverages to cool within 60 min. • To cancel this option, press the “Quick Cool” button again.
16 Ice maker bucket (optional) • Remove the bucket lifting up and pulling out. Front Leg cover • Open the freezer and refrigerator doors, remove the three screws and detach the cover. • To reassemble the leg cover, put it back into position and tighten the three screws.
17 OPERA TING INSTRUCTIONS CLEANING THE ACCESSORIES Inside • Clean the accessories using a mild detergent. Then wipe with a dry cloth. • After washing the accessories, make sure that they are dry before using them again. Exterior • Wipe the front control panel with a clean cloth.
18 CLEANING THE ACCESSORIES INTERIOR LIGHT IN THE FREEZER (BASIC MODEL ONL Y) / REFRIGERA TOR INTERIOR LIGHT IN THE FREEZER (MODEL WITH ICE AND W A TER DISPENSER) CHANGING THE INTERIOR LIGHT Before changing the interior light, unplug the appliance from the power supply.
19 OPERA TING INSTRUCTIONS WA TER FIL TER The water “Filter Indicator” light • “Filter Indicator” light lets you know when it is time change your water filter cartridge. The light will change from green to orange. This tells you that it is almost time to change the current cartridge.
20 INST ALLA TION OF THE REFRIGERA T OR • Check the dimensions of your entrance door to determine whether the refrigerator can pass through it. • Moving refrigerator through door if depth or width of refrigerator is bigger than door’s, removes refrigerator doors.
21 INST ALLA TION INSTRUCTIONS REMOVING THE FRONT LEG COVER a 1) Remove the screw from clamp ( ). 2) Remove the water tube by pressing the coupler ( ➁ ) and pulling the water tube ( ➀ ) away. Open the freezer and refrigerator doors, and then take off the front leg cover assembly by turning the three screws counter-clockwise.
22 REMOVING THE REFRIGERA T OR DOORS 1) With the door closed, remove the upper hinge cover ( ➀ ) using a screwdriver, and then disconnect the wires ( ➁ ). 2) Remove hinge screws ( ➂ ) and ground screw ( ➃ ) counter-clockwise, and take off the upper hinge ( ➄ ) along the arrow ( ➅ ).
23 INST ALLA TION INSTRUCTIONS REMOVING THE REFRIGERA TOR DOORS 1) With the door closed, remove the upper hinge cover ( ➀ ) using a screwdriver, and then discon-nect the wires ( ➁ ). 2) Remove hinge screws ( ➂ ) and ground screw ( ➃ ) counter-clockwise, and take off the upper hinge ( ➄ ) in the direction of the arrow ( ➅ ).
24 REA TT ACHING THE REFRIGERA T OR DOORS Reattaching the Freezer Door 1) Insert the lower hinge ( ➀ ) in the bracket lower hinge ( ➁ ). 2) Reattach the freezer door by inserting the hose ( ➂ ) in the lower side of the door into the hole in the lower hinge ( ➃ ) and pulling the hose down.
25 INST ALLA TION INSTRUCTIONS REA TT ACHING THE REFRIGERA T OR DOORS Reattaching the Refrigerator Door 1) Insert the lower hinge ( ➀ ) in the bracket lower hinge ( ➁ ). 2) Place the hole in the refrigerator door ( ➂ ) over the lower hinge ( ➃ ).
26 REA TT ACHING THE REFRIGERA T OR DOORS FRONT LEG COVER SCREW 1) While pressing the front face of coupler ( ➁ ), insert the water line ( ➀ ) in the coupler. 2) Tighten the screw on the clamp ( ). a Put on the front leg cover by turning the three screws clockwise, as shown in the figure.
27 INST ALLA TION INSTRUCTIONS ADJUSTING THE CLEARANCE BETWEEN THE DOORS The doors will be uneven if the refrigerator is not level. Case 1) Freezer door is lower than that of the refrigerator Insert a straight screwdriver (-) ( ① ) into a slot of the control lever ( ➁ ), turn it clockwise and level the refrigerator.
28 ADJUST THE CLEARANCE BETWEEN THE DOORS Making small adjustments between doors. If the door of the freezer is lower than that of the refrigerator. If the door of freezer is higher than that of the refrigerator.
29 INST ALLA TION INSTRUCTIONS CHECKING THE W A TER DISPENSER LINE (OPTIONAL) Checking the Parts NOTE A universal water supply kit is available at extra cost from your dealer. The refrigerator manufacturer recommends using a water supply kit containing copper tubing.
30 INST ALLING OF THE W A TER DISPENSER LINE WARRANTY INFORMATION This water line installation is not covered by the refriger-ator or ice maker manufacturer's warranty. Follow these instructions carefully to minimise the risk of expensive water damage.
31 INST ALLA TION INSTRUCTIONS INST ALLING THE W A TER DISPENSER LINE - Remove the compressor cover of the refrigerator. - Connect the water line to the valve, as shown in the figure. - When connected, check if there is any leakage. If any, repeat the connection.
32 INST ALLING THE W A TER DISPENSER LINE Remove any residual matter inside the purifier. (Model with the purifier) - Open the main water tap to check whether water is running through the water tube on the water inlet side of the purifier. - If water does not come out through the line, check whether the tap is open.
33 INST ALLA TION INSTRUCTIONS INST ALLING THE W A TER DISPENSER LINE Secure the water line. - Using clip ”A”, fix the water line to the wall (the back of refrigerator). - When the water line is secure, make sure whether the water line is not excessively bent, pinched or squashed.
34 INST ALLING THE W A TER DISPENSER LINE Remove any residual matter inside the water supply line 1) Turn on the main water supply & shut-off valve of the water supply line. 2) Run water through the dispenser until the water runs clear (6~7 minutes).
35 INST ALLA TION INSTRUCTIONS TROUBLESHOOTING The refrigerator does not work at all or it does not chill sufficiently • Check that the power plug is properly connected. • Is the temperature control on the display panel set to the correct temperature? Try seting it to a lower temperature.
Ambient Room T emperature Limits This fridge/freezer is designed to operate in ambient temperatures specified by its tem- perature class marked on the rating plate. NOTE: Internal temperatures may be affected by such factors as the location of the fridge/freezer, ambient temperature and the frequency with which you open the door.
Ein wichtiger Punkt beim Kauf des Geräts Samsung SRS620DW (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Samsung SRS620DW noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Samsung SRS620DW - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Samsung SRS620DW reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Samsung SRS620DW erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Samsung SRS620DW besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Samsung SRS620DW verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Samsung SRS620DW. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Samsung SRS620DW gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
