Benutzeranleitung / Produktwartung RFX8210 des Produzenten Rockford Fosgate
Zur Seite of 37
SOURCE UNITS INSTALLATION & OPERATION R R F F X X 8 8 2 2 1 1 0 0 R R F F X X 8 8 2 2 2 2 0 0 R R F F X X 8 8 2 2 3 3 0 0 RFX.
– 1 – S PECIFICA TIONS General Operating V oltage +10.8V – +16.0V DC Standby Current 5mA Max Operating T emperature -30˚C to +70˚C (Receiver) -10˚C to +65˚C (CD Player) Dynamic Power Rating .
– 2 – FM T uner T uning Range Americas 87.5 ~ 107.9MHz (200kHz spacing) Eur/Aus 87.5 ~ 108MHz (50kHz spacing) Frequency Response 30Hz – 12kHz Usable Sensitivity 10dB (S/N 30dB) IF Rejection 90dB Image Rejection 50dB Signal-to-Noise Ratio 60dB Distortion < 0.
– 5 – – 4 – P RECAUTIONS Source Unit & Optional CD Changer Operating T emperature Be sure the temperature inside the vehicle is between –10° C and +65° C (+14° F and +149°F). DO NOT play a disc if the temperature is higher or lower than the operating range.
– 7 – – 6 – QUICK LOOK FEA TURES RFX8210 RFX8220 RFX8230 RFX8810 Control/Lighting/Appearance Detachable Faceplate X X X - ISO Din Mounting X X X - w/ Removable T rim Panel Multi Function V olu.
– 9 – – 8 – Source Unit Design 1. BAND – Selects which bank of tuner presets (FM1/FM2/ FM3/AM1/AM2) should be active. 2. POWER – T urns the sour ce unit on and off. 3. EJECT – Ejects the CD from the in-dash CD player . 4. DISP – Switches the sour ce unit between the clock and the currently selected mode (TUNER/CDP/CDX/AUX*).
– 11 – – 10 – 1 9. Sum Preamp Output** – These RCA jacks provide a low- level SUMMED MONO (L+R) output used to connect amplifier(s) driving subwoofers. 20. Front/Rear Preamp Output – These RCA jacks provide a low-level STEREO output used connect amplifier(s) driving front & rear speakers.
– 13 – *Features available on RFX8230 only **Features available on RFX8220 & RFX8230 only – 12 – 9. DISP – Switches the sour ce unit between the clock and the currently selected mode (TUNER/CDP/CDX/AUX*). 1 0. DISC ACC – Directly accesses the desired CD in the optional CD changer .
– 15 – – 14 – S OURCE U NIT M OUNTING L OCA TIONS The mounting position of your source unit will have a great effect on the performance of your in-dash CD Player . The source unit can be installed in a wide range of operating locations. However , care should be taken to ensure optimum performance.
– 17 – W IRING THE S YSTEM NOTICE: If you do not feel comfortable with wiring your new source unit, please see your local Authorized Rockford Fosgate Dealer for installation. • For safety , disconnect the negative lead from the battery prior to beginning the installation.
– 19 – – 18 – S OURCE U NIT I NST ALLA TION Source Unit Mounting Angle • Mount the Source Unit as close to horizontal as possible for optimum CD Player performance • Mounting Angles up to .
– 21 – – 20 – The faceplate is detachable as an anti-theft deterrent system. Attach the Faceplate 1. Insert left side of faceplate into the housing. 2. Press faceplate into housing until it clicks. Remove the Faceplate 1. Press the “^” button 2.
Operation 1. Press the power button to turn on the radio 2. Press the power button to turn off the radio Any Button W ake-Up Press any button on the faceplate (except EJECT , DISP) to “wake-up” th.
Display Recall temporarily displays the clock, radio sta- tion, station title**, CD track/time or disc title* or aux on the LCD for 5 seconds. Display Recall (TUNER) 1. While in TUNER mode, press the DISP button to cycle through CLOCK>RADIO ST A TION>ST A TION TITLE** 2.
Operation 1. Press and hold the LOUD button for 1 second to change the illumination from Green to Amber 2. Press and hold the LOUD button again to revert to the previous color Considerations On initia.
– 29 – The name of the radio station or CD can be stored in memory using up to 8 characters as a title. A maximum of 58 titles can be stored into memory . Station/Disc Title Memory 1. Press and hold the BAND button for 1 second 2. T urn the MENU knob to select the proper character 3.
– 31 – – 30 – Auto Store 1. Press and hold the AS/PS button for 1 second to automatically select the strongest radio stations and store them in the tuner banks 2. Auto Store will store radio stations indepen- dently in the selected tuner bank (FM1/FM2/FM3/ AM1/AM2) Preset Scan 1.
CD Player Mode 1. Press the MODE button until CDP PLA Y is dis- played 2. The CD player will immediately begin playing the disc LCD Display 1. The track # & elapsed time will be displayed for 5 seconds 2.
Fast Forward/Reverse 1. Press and hold the SEEK UP button to fast forward the track 2. Press and hold the SEEK DN button to fast rewind the track LCD Display The LCD will display the accelerated elapsed time for as long as the SEEK UP/DN button is depressed CDP/CDX T RACK F ORW ARD /R EVERSE * – 35 – T rack Selection 1.
T rack repeat plays the currently playing track over again T rack Repeat 1. Press the RPT (Preset #2) button to begin track repeat mode 2. T rack repeat will continue to repeat the current track until the mode is cancelled T rack Repeat Cancel 1. Press the RPT (Preset #2) button a second time to cancel track repeat mode LCD Display 1.
Pause CD 1. Press the MUTE button to pause the CD and reduce the volume to minimum 2. Press the MUTE button a second time to resume playing the disc LCD Display 1.
Loading Disc to the Magazine 1. Pull out the desired disc tray number from the magazine 2. Place the disc into the magazine label side up 3. Push the disc tray back into the magazine NOTE: Discs numbers are arranged from the top down Loading the Magazine to the CD Changer 1.
Disc Selection 1. Press the TUNE UP button to select the next disc in the magazine 2. Press the TUNE DN button to select the previous disc in the magazine LCD Display 1. The LCD will continuously flash the number of the currently playing disc 2. When a disc begins playing, the track # & elapsed time will be displayed for 5 seconds 3.
– 45 – Magazine Eject 1. Press the EJECT button to release the magazine disc from the CD changer 2. The source unit will revert to TUNER mode NOTE: A disc may be ejected during any mode or if the radio power/ignition is off LCD Display 1.
1. Press the PWR button to turn on the radio 2. Press the PWR button a second time to turn off the radio LCD Display When the radio is off (in sleep mode) the clock will be displayed P OWER O N /O FF IR R EMOTE O PERA TION (RFX8210 Optional Accessory) On Off V olume Up/Down 1.
T une (TUNER Mode) 1. Press the TUNE UP button to manually tune the radio station up the band 2. Press the TUNE DN button to manually tune the radio station down the band Disc Selection (CDX Mode) 1. Press the TUNE UP button to select the next disc in the magazine 2.
1. Press the SEL button to cycle through BASS> TREBLE>BALANCE>F ADER>SUM**>VOLUME 2. Press the VOL+ button to increase function 3. Press the VOL+ button to decrease function SOURCE TONE MEMORY Individual Bass & T reble settings are memorized for TUNER / CDP / CDX / AUX* modes.
Display Recall temporarily displays the clock, radio station, station title**, CD track/time, disc title* or aux* on the LCD for 5 seconds. Display Recall (TUNER) 1. While in TUNER mode, press the DISP button to cycle through CLOCK>RADIO ST A TION> ST A TION TITLE** 2.
T rack scan plays the intro to each track for 10 sec- onds before moving to the next track on the currently playing disc T rack Scan 1. Press the SCAN (Preset #1) button to begin track scan mode 2. T rack scan will continue to scan until the mode is cancelled T rack Scan Cancel 1.
T rack random selects and plays tracks at random from the currently playing disc T rack Random 1. Press the RDM (Preset #3) button to begin track random mode 2. T rack random will continue to select and play tracks at random until the mode is cancelled T rack Random Cancel 1.
Direct T rack Access allows any track to be immedi- ately selected and played. This method is faster than manually cycling through each track on the disc. Direct T rack Access 1. While in CDP/CDX mode, press the TRACK ACC button to select Direct T rack Access mode 2.
– 61 – AUTO STORE 1.Press and hold the AS/PS button to automatically select the strongest radio stations and store them in the tuner banks. 2. Auto Store will store radio stations individually in the desired tuner bank (FM1/FM2/FM3/AM1/ AM2). PRESET SCAN 1.
– 63 – – 62 – SYMPT OM DIAGNOSIS REMEDY ERROR 6 (T ransverse Error) T ransverse motor or switch is defective. T raverse area damaged Check CD mechanism motor , switch and transverse area. SYMPT OM DIAGNOSIS REMEDY Disc will not load into Source Unit (also see error codes) V oltage applied to Red and Y ellow wires is not between 10.
– 65 – – 64 – CD C HANGER T ROUBLESHOOTING SYMPT OM DIAGNOSIS REMEDY Error 1 (Initialize Error) Error 2 (Magazine Eject Error) Disc unit can’t detect magazine Press the eject button and pull out the magazine.
– 67 – – 66 – IR R EMOTE T ROUBLESHOOTING IR Remote has poor range Batteries are weak Check battery condition and replace as necessary with (1) CR2025 (+3 volt) battery Excessive dirt or dust .
– 69 – – 68 – I NTERNA TIONAL I NFORMA TION Ship to: Electronics Rockford Corporation W arranty Repair Department 2055 E. 5th Street T empe, AZ 85281 RA#: _________________________ Ship to: Speakers Rockford Acoustic Design (Receiving-speakers) 609 Myrtle N.
PRINTED IN KOREA Rockford Fosgate Rockford Corporation 546 South Rockford Drive T empe, Arizona 85281 U.S.A. In U.S.A., (480) 967-3565 In Europe, Fax (49) 8503-934014 In Japan, Fax (81) 559-79-1265 www .
Ein wichtiger Punkt beim Kauf des Geräts Rockford Fosgate RFX8210 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Rockford Fosgate RFX8210 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Rockford Fosgate RFX8210 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Rockford Fosgate RFX8210 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Rockford Fosgate RFX8210 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Rockford Fosgate RFX8210 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Rockford Fosgate RFX8210 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Rockford Fosgate RFX8210. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Rockford Fosgate RFX8210 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
