Benutzeranleitung / Produktwartung CA 5550SST des Produzenten Audiovox
Zur Seite of 24
1 2010 Audiovox Electronics Corporation. All rights reserved. PROFESSIONAL SERIES Remote S t art with Keyless Entry Inst allation Guide CA 5550SST.
2 2010 Audiovox Electronics Corporation. All rights reserved. Before Y ou Begin ...................................................................................... 3 Wire Connection Guide ............................................................
3 2010 Audiovox Electronics Corporation. All rights reserved. PROFESSIONAL INST ALLA TION STRONGL Y RECOMMENDED Installation Precautions: Roll down window to avoid locking keys in vehicle during insta.
4 2010 Audiovox Electronics Corporation. All rights reserved. 6 Pin St art Harness 4 Pin Alternate Harness 2 Pin Lock Harness 7 Pin Main Harness 3 Pin Parking Light Harness.
5 2010 Audiovox Electronics Corporation. All rights reserved. 7 Pin Main Harness 1 BLACK/WHITE ILLUMINA TED ENTRY OUTPUT ( - ) This wire provides a ( - ) 500mA output for 30 seconds when the system is disarmed capable of driving relays. Locate the vehicle’s dome light or pin switch wire.
6 2010 Audiovox Electronics Corporation. All rights reserved. 5 PURPLE/WHITE T ACH INPUT Locate the vehicle’s ignition coil or fuel injector in the engine compartment. Verification: T est using the following procedure: 1. Set voltmeter to AC VOL TS.
7 2010 Audiovox Electronics Corporation. All rights reserved. 6 GRA Y HOOD PIN INPUT ( - ) Install a Hood Pin Switch and connect to the GRA Y wire. This connection is required for Remote S tart. V erification: This wire when connected will register ground when the vehicle's hood is opened.
8 2010 Audiovox Electronics Corporation. All rights reserved. 6 Pin St art Harness 1 PURPLE ST ARTER OUTPUT ( + ) Locate the vehicle starter wire. V erification: This wire registers voltage only when the key is turned to the ST ART position. Verification: The starter wire registers voltage when the key is turned to the ST ART position.
9 2010 Audiovox Electronics Corporation. All rights reserved. 6 PINK IGNITION 1 ( + ) Locate the vehicle’s ignition wire at the ignition switch. V erification: This wire registers voltage when the key is turned to the ON (or RUN) position. The volt age does not drop out when the key is turned to the ST AR T (or CRANK) position.
1 0 2010 Audiovox Electronics Corporation. All rights reserved. 4 BLACK/YELLOW PULSE DURING CRANK ( - ) Locate the vehicle’s second starter (crank) wire at the ignition switch. (if equipped) V erification: This wire registers voltage only in the st art (crank) position of the ignition switch.
11 2010 Audiovox Electronics Corporation. All rights reserved. Negative Switching Locks All Door Lock and Unlock: Locate the lock / unlock wire at the vehicle’s lock / unlock switch. V erification: These wires will register ground when the Lock and Unlock switches are activated.
1 2 2010 Audiovox Electronics Corporation. All rights reserved. Reverse Polarity Locks (5-Wire Door locks) All Door Lock and Unlock: Locate the lock / unlock wire at the vehicle’s lock / unlock switch. V erification: These wires will rest at ground and register positive voltage when the Lock and Unlock switches are activated.
13 2010 Audiovox Electronics Corporation. All rights reserved. Positive Multiplexed Locks All Door Lock and Unlock: Locate the lock / unlock wire at the vehicle’s lock / unlock switch. V erification: This wire will show variable positive voltage when the switch is activated.
1 4 2010 Audiovox Electronics Corporation. All rights reserved. Data Bus Interface Port This 4 pin port is used for Flashlogic Door Lock and Transponder Databus Interfaces to communicate with the vehicle's Databus.
15 2010 Audiovox Electronics Corporation. All rights reserved. Manual Feature Programming - Feature Bank 2 - 4 1. Turn the ignition ON. 2. Press and hold the valet/override button. 3. Within 10 seconds the system will chirp (3) three times. 4. Use the valet/override button to advance through each option bank.
1 6 2010 Audiovox Electronics Corporation. All rights reserved. Feature Bank 1 - 3 Chirps Transmitter Programming Refer to transmitter programming..
17 2010 Audiovox Electronics Corporation. All rights reserved. T ach Programming The unit will not operate unless a tach signal is programmed or the tachless option is turned ON .
1 8 2010 Audiovox Electronics Corporation. All rights reserved. Feature Bank 2 - Security 1 - Silent Choice: Controls the normal arm/disarm chirps of the security system. ON - Silent arming/disarming upon first press of lock/unlock, pressing lock/ unlock a second time will activate the arm/disarm chirps respectively .
19 2010 Audiovox Electronics Corporation. All rights reserved. 3 - Ignition Controlled Locks: Control of door locks when the ignition is cycled ON or OFF . OFF - Door locks not activated by ignition. Lock and Unlock - Doors lock when ignition is turned on and unlock when ignition is turned off.
2 0 2010 Audiovox Electronics Corporation. All rights reserved. 4 - T ach Mode: Determines how the system monitors the engine running during remote start.
21 2010 Audiovox Electronics Corporation. All rights reserved. 9 - Single / Double Pulse Start: Switches the remote start activation between a single or double press from the transmitter . 10 - IGN 2 Output: Programmable high current output. Ignition 2 - Ignition output during remote start.
2 2 2010 Audiovox Electronics Corporation. All rights reserved. Remote Start Shutdown Diagnostics If the remote start shuts down or fails to start, the parking lights will flash one of the patterns below indicating the shutdown input. T o manually enter diagnostics and view the last shutdown, turn the ignition ON and press and release the button.
23 2010 Audiovox Electronics Corporation. All rights reserved. L T GREEN/BLACK FACTOR Y DISARM / PULSE BEFORE ST ART ( - ) L T BLUE PULSE AFTER ST ART ( - ) GREEN/WHITE F ACTORY ARM / PULSE AFTER SHUT.
2 4 2010 Audiovox Electronics Corporation. All rights reserved. Audiovox Electronics Corporation. Customer Service 1-800-421-3209 WWW .CODE-ALARM.COM FCC COMPLIANCE This device complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada.
Ein wichtiger Punkt beim Kauf des Geräts Audiovox CA 5550SST (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Audiovox CA 5550SST noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Audiovox CA 5550SST - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Audiovox CA 5550SST reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Audiovox CA 5550SST erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Audiovox CA 5550SST besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Audiovox CA 5550SST verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Audiovox CA 5550SST. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Audiovox CA 5550SST gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
