Benutzeranleitung / Produktwartung APS 650 RS des Produzenten Audiovox
Zur Seite of 24
3 Channel Remote Car Starter Installation Instructions For installation in vehicles with 12 volt negative ground circuits, gasoline engines, with automatic transmission only! Model APS 650 RS Installa.
The APS 650 RS is for Automatic Transmission vehicles only! Although it is a sophisticated system, with multiple built- in safety features, it must not be installed into vehicles with manual transmissions. Doing this can cause serious personal injury and property damage.
VIOLET Wire : Accessory Output Connect this wire to the accessory wire from the ignition switch. This wire will show +12 Volts when the ignition key is turned to the “ ACCESSORY “ and “ RUN or ON “ positions, and 0 Volts when the key is turned to the “ OFF “ and “ START or CRANK “ positions.
VATS WIRE #1 (CUT) TOWARDS VATS MODULE TO FUSED +12 VDC BATTERY SOURCE MATCHING RESISTOR VATS WIRE #1 (CUT) TOWARDS IGNITION SWITCH 87 87a 85 86 30 VATS WIRE #2 LIGHT BLUE IGN.
3 Wire Ground Switched door locks In this application, the red wire provides a ground pulse or the pulsed ground lock output. Connect the red wire to the wire that provides a low current ground signal from the factory door switch to the factory door lock control relay.
2. Programming Tach Rate: The APS 650 RS Remote Car Starter will learn the tach rate of the vehicle. To learn tach; 1. Start with the programming switch in the OFF position. 2. Turn the ignition key to the ON position. 3. Flip the program switch ON - OFF - ON - OFF - ON - then OFF.
COMPLETING THE INSTALLATION: 1. Select a desired mounting location for the program switch and the control switch. The switches may be mounted in or below the dash by drilling a 1/4" dia.
12 PIN CONNECTOR WIRING THE 12 PIN INPUT / OUTPUT HARNESS CONTROLSWITCH TO ALARM'S IGNITION INPUT- (YELLOW WIRE OFAUDIOVOX ALARMS) LIGHT BLUE WHITE WHITE POSITIVE INHIBIT 1 NEGATIVE INHIBIT 2 TAC.
Formulaire No. 128-4787A Modèle APS 650 RS Manuel d’installation Consignes d’installation Télécommande de démarrage d’auto à 3 canaux Ne convient qu’aux véhicules dont la tension de serv.
POSITION DE LA CLEF DE CONTACT ARRÊT ACCESSOIRE MARCHE DÉMARRAGE FIL VERT PÂLE VENANT DU APS 650 RS FIL JAUNE VENANT DU APS 650 RS Le APS 650 RS est conçu s.
Fil VIOLET: Sortie des accessoires Connecter ce fil au fil pour accessoires de l’interrupteur d’allumage. Ce fil reçoit une alimentation + 12 Vcc lorsque la clef de contact est mise en position "ACCESSORY" (ACCESSOIRES) et "RUN / ON" (MARCHE).
Fil BLEU PÂLE: Allumage 3/Inhibition de l’alarme de secousses Il s’agit d’une sortie transistorisée fournissant un contact à la masse. Si cette sortie doit être utilisée, un relais extérieur est absolument nécessaire. REMARQUE : Un signal est envoyé sur ce fil 3 secondes avant que le APS 650 RS démarre le moteur.
Commande de serrure de portières à 3 voies par impulsion négative Dans cette application, le fil rouge permet de fournir une masse commandant le verrouillage des portières. Il doit être connecté au fil qui permet déjà de fournir une masse à la serrure à partir de l’interrupteur existant.
Choix de fonction Premier Deuxième Troisième Quatrième Cinquième Sixième Septième Huitième 1 clignotement 1 seconde verrouillage des portières 10 minutes de marche Feux de stationnement allum.
POUR COMPLÉTER L’INSTALLATION 1. Choisir un endroit approprié pour l’installation des commutateurs de programmation et de contrôle. Les commutateurs peuvent être montés dans ou sous le tableau de bord en perçant des trous de 1/4 po dia (6,35 mm).
BLEU PÂLE INHIBITION POSITIVE 1 IN TERRUPTEUR À FREINS EXISTANT ALLUMAGE 3 OU CONTOURNEMENT DE L’ALARME DE SECOUSSE VERS LA MASSE DU CHÂSSIS FEU DE STATIONNEMENT MASSE DU CHÂSSIS Fil GRIS/R.BLANCHE NOIR VERT FONCÉ Fil JAUNE/R.
Modelo APS 650 RS Manual de instalación Form No. 128-4787A Arrancador remoto de automóvil con 3 canales Instrucciones de instalación Para la instalación en vehículos con circuitos negativos de conexión a tierra de 12 voltios, motores de gasolina, con transmisión automática solamente.
* El sistema APS 650 RS es para vehículos con transmisión automática solamente.
Cable VIOLETA: Salida de accesorios Conecte este cable al cable de accesorios del interruptor de encendido. Este cable tendrá +12 voltios cuando la llave de contacto se encuentre en las posiciones AC.
Cable CELESTE: Encendido 3 / Salida de desactivación de choque Se trata de una salida a tierra transistorizada de 500 mA y se requerirá un relé externo en todos los casos que se necesite esta salida. NOTA: Este cable celeste se activa 3 segundos antes de que el APS 650-RS arranque el motor.
Trabas de puertas conmutadas a tierra de 3 cables En esta aplicación, el cable rojo proporciona una salida pulsada de destrabado de +12 voltios. Conecte el cable rojo al cable que proporciona una señal de conexión a tierra de baja corriente del interruptor para las puertas de fábrica al relé de control de las trabas de puertas de fábrica.
1. Funciones RF programables: Selección de función Primera Segunda Tercera Cuarta Quinta Sexta Séptima Octava 1 destello Trabas de puertas de 1 segundo Tiempo de funcionamiento de 10 minutos Luces .
FINALIZACIÓN DE LA INSTALACIÓN 1. Seleccione un lugar de montaje para el interruptor de programación y el interruptor de control. Los interruptores pueden montarse en el tablero, o debajo del mismo, perforando un orificio de 1/4 pulgadas de diámetro.
BLANCO BLANCO NEGRO Y BLANCO GRIS GRIS Y NEGRO NEGRO VERDE OSCURO AMARILLO Y NEGRO CABLEADO DEL ARNÉS DE ENTRADA / SALIDA DE 12 CLAVIJAS CONECTOR DE 12 CLAVIJAS CABLE EXISTENTE PA.
Ein wichtiger Punkt beim Kauf des Geräts Audiovox APS 650 RS (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Audiovox APS 650 RS noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Audiovox APS 650 RS - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Audiovox APS 650 RS reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Audiovox APS 650 RS erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Audiovox APS 650 RS besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Audiovox APS 650 RS verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Audiovox APS 650 RS. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Audiovox APS 650 RS gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.