Benutzeranleitung / Produktwartung ET-1118 des Produzenten Radio Shack
Zur Seite of 32
Cat. No. 43-1 118 OWNER’S MANUAL Please read before using this equ ipment. ET-1 1 18 900 MHz Digital Spread Spectrum Cordless Telephone with Caller ID and Call Waiting ID.
2 FEA TURES Your RadioSha ck ET-1118 90 0 MHz Digital Spread Spect rum Cordless Tele- phone uses the most a dvanced cor dless telephone technolog y to give you superi - or audio quality and exten ded range.
3 Security Access-Prot ection Code — automatica lly preven ts other cord less phone users from using your phone line while the handset is off the base. Redial — lets you quickly redial the last number di aled. Flash — sends an electronic switch- hook signal for u se with special phone services, such as Call Waiting.
4 Important: • Cordless phones such as t his one require AC power to o perate. When the AC powe r is of f, you ca nnot dial out or receive incoming calls using your ET-1 1 18.
5 CONTENTS Installation .. ................ ............. ................ ................ ............. ................ ................. .. 7 Mounting t he Phone ..... ................ ............. ................ ................ ............. .
6 T roubleshooting .................................................................................................... 25 Care and Maint enance .. ................ ............. ................ ................ ................. .......... 27 Replacing the Bat te ry Pac k .
7 INSTALLATION MOUNTING THE PHONE You can place the ET-1118’s ba se on a desk or table, mount it on a standar d wall plate, or mount it directly on a wall.
8 4. Route the adap ter ’s cord t hrough the strain re lief slot on th e bottom of the base. 5. Plug the ada pter into a st andard AC outlet. 6. Lift the ba se’ s antenna to a ve rtical position.
9 5. Plug the m odular cord’s other end into the wall plate jack, then align the brack et’ s keyhole slots with th e wall plate studs and slide th e base downward to secure it.
10 CONNECTING AND CHARGING THE BATTERY PACK The ET-1118 comes with a recharge- able nickel-cadmium batter y pack in the handset but not connecte d. Before using your phone, yo u must connect th e bat- tery pack and then cha rge it fo r about 2 4 hours.
11 • If the ba ttery pack becomes weak during a call, t he handset beeps every 3 seco nds and Lo w Bat- tery flashes. If this happens, you cannot make anothe r call on the phone until you r echarge the batte ry pack. • About once a month, fully discharge the battery pack by keep ing the handset of f the base until Low Battery flashes.
12 At any time except during a call, p ress or to set the handset’s r inger vol- ume. The ph one rings at the selected volume and the display shows Ringer Low or Ringer High . To set the ba se’s ring er volume, set RING VOL on the back of the base to OFF , LO , or HI .
13 3. Press SELECT to change th e Caller ID/Call W aiting setting. On or Off appears indi cating the select ed set- ting. 4. Press CALL ID or return the handset to the base to store th e new setting.
14 T ELEPHONE OPERATION MAKING AND RECEIVING CALLS WITH THE HANDSET To make a call, lift the handset, then press TA L K . Th e IN USE indicator on the base lights. D ial the number. You see the numbe r as you di al, then (ab out 5 seconds later) the call’s elapsed time.
15 To switch to the handset while you are using the speakerpho ne, simply lift the handset off the base. If t he handset is away from the base, press TA L K , then press SPEAKER . USING BOTH THE HANDSET AND SPEAKERPHONE If someone el se is using the speaker- phone, press TA L K on the handse t to join the conversation .
16 • The redial m emory for ea ch keypad is separate. Y ou cannot redial a number you dialed on the handset’ s keypad using REDIAL on the base’s keypad, and vice versa. • The redi al memory h olds up t o 32 digits, so you ca n redial long-dis- tance as well as local numbers.
17 To page the ba se from th e handset, press INTCM . Paging Base appears, and the base and hand set ring. Press SPEAKER or INTERCOM on the base to answer t he page. Intercom appears on the handset’s display. To page the ha ndset from the base, press IN TERCOM .
18 Use the supplied memory directory stickers to r ecord your st ored number s. Peel the backing f rom each sticker an d attach them to the pho ne as shown. Storing a Number in the Handset’ s Memory Each number stored in t he handset’s memory can be up to 20 digi ts, and each name can be up to 14 charact ers.
19 7. Press SELECT . The phone beeps and Memory n Stored appears. After 2 seconds, Memory Store appears, and you can repeat Steps 3–6 to stor e more nu mbers. To replace a stored number, simply store a new one in its place. Editing or Deleting a Number in the Handset’ s Memory 1.
20 Entering a Pause In some telephon e systems, you must dial an access code (9, for exampl e) and wait for a second dial ton e before you can dial an outside number . You can store the a ccess code with the phon e number. However, you should also store a pause af ter the acce ss code to allo w the outside line time to co nnect.
21 T esting Stored Emergency Numbers If you store an emergency service’s number (police depa rtment, fire depar t- ment, ambulance) and you choose t o test the stored n umber, make the test call during th e late evenin g or early morning hours t o avoid peak deman d periods.
22 CALLER ID OPERATION If you subscribe to Caller ID service from your phon e compan y, the phone com pa- ny sends information about the call, as well as the time and date, betw een the first and second rings of every call yo u receive.
23 Caller ID Messages DIALING NUMBERS FROM A CALLER ID RECORD To dial a local number stored in a Caller ID record, r ecall the record , then pres s TA L K . If it is a long distance call, press 1 ( 1 appears befor e the displayed num- ber) before pr essing TA L K .
24 If a record exists in the s elected loca- tion, Replace Memory? appe ars, prompting you to confirm the re place- ment. Move the cursor to Ye s or No , then press SELECT . DELETING CALLER ID RECORDS You can delete Caller ID recor ds individ- ually or all at once.
25 T ROUBLESHOOTING We do not expect you to have an y problems with your p hone, but if you do, the follo w- ing suggestions might he lp. Problem Suggestion The phone does not work or wor ks poo rly . Be sure the base’ s phone line cord and A C adapter are correctly and securely con- nected.
26 If you still have problems, disconnect the ET-1118. If other phones on the same line work properly, t he fault is in t his phone or its installation. If you cannot fin d the prob- lem, take your ET-1118 to your local RadioShack st ore for assistance.
27 CARE AND MAINTENANCE Your RadioShack ET-1118 900 MHz Digital Spread Spectrum Cordless Telephone is an example of superior design and craftsmanship. The following suggestions will help you care for your ET-1118 so you can enjoy it for years. Keep the ET-1118 dry.
28 REPLACING THE BATTERY PACK If you follow the instructions in “Connect- ing and Charging the Bat tery Pack” on Page 10, the b attery pack should last about one yea r. If the battery pa ck does not hold a char ge for more than 2 hours after an overnight ch arge, replace it with a new 3.
29 THE FCC W ANTS Y OU TO KNOW In the unlikely event that your phone causes problems on th e phone line, the phone company can tempor arily discon- tinue your service.
30 NOTES.
31.
RadioShack A Division of T andy Corporation Fort W orth, T exas 76102 UCZZ01641BX 07A99 Printed in the Philippines Limited One-Y ear Warranty This product is warranted by RadioShack against manufactu .
Ein wichtiger Punkt beim Kauf des Geräts Radio Shack ET-1118 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Radio Shack ET-1118 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Radio Shack ET-1118 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Radio Shack ET-1118 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Radio Shack ET-1118 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Radio Shack ET-1118 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Radio Shack ET-1118 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Radio Shack ET-1118. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Radio Shack ET-1118 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
