Benutzeranleitung / Produktwartung CLIER 835 des Produzenten Precor
Zur Seite of 44
As sembling and Maintaining the 835 Climber Prec or Incorporated 20031 142nd A venue NE P .O . Bo x 7202 W oodinville, W A USA 98072 -4002 CLM P AG/ OM 300714-2 41 rev E W arranty #36286- 114 14 F ebr.
.
.
Edition Inf ormation ASSEMBL ING AND MAI NTAININ G THE 835 CLI MBER P/N 300714 - 241 rev E Copyri ght © Febru ary 2 011 Pre cor In corpo rate d. All righ ts reserved. Specificati ons subject to change without no ti ce. Trademark Not e Precor, AMT, and EFX are registered trademarks and Preva is a trademark of Preco r Incorpora ted.
Important S af ety Instructi ons Read the following precaut ions thoroughly before you begin assembly, and save them afterward for future ref erence. Safety Precautions Always follow basic safet y precautions when using this equipment to reduce the chance of injury, fire, or damage.
4 Assembling and M aintaining the 8 35 Climber Use the power adapter provided with the equipment. Plug the power adapte r into an appro priate, gro unded power outlet a s marked on the equipmen t. Care should be taken whe n mounting or dismounting the equipme nt.
Important Saf ety Instructions 5 If you plan to move t he equipment, obtain hel p and use proper lifting techniques. ref er to the "Moving the Equipment" section of the assembly and maintenanc e guide. Use the equipment only for its intended purpose as described in this manual.
6 Assembling and M aintaining the 8 35 Climber Hazardous Mat erials and Prop er Disposal The ba tteries wit hin self - power ed equipment contai n materials that are consider ed hazardous to the environment . Federal law requires proper disposal of these batteries.
Important Saf ety Instructions 7 Radio F requenc y Inter ference ( RFI) The RFID module conform s to the following national standards defining acceptable limit s for radio frequency interference (RFI).
8 Assembling and M aintaining the 8 35 Climber European Applications CE compliance is claimed to the following directives: 1999/ 5/EC R&TTE Dir ective 200 6/95/EC LVD Dir ective 2002/95/EC RoHS Directive Directive compliance has been ver ified to the following standard s: EN 55022 EN 300 330 - 1 V1.
Important Saf ety Instructions 9 Radio F requenc y Inter ference ( RFI) This Precor exercise equip ment conforms to the follo wing national standards defining acceptable limits for r ad io frequency interference (RFI).
10 Assembling and M aintaining the 8 35 Climber Electrical Recom mendations: All Equ ipment Excluding Trea dmills Note : This is a recommendation only.
T able of Cont ents Import ant Safety In structi ons ................................................... 3 Safety Pre caution s ................................................................................. 3 Educating Users .......................
12 Assembling and Maintaining the 835 Climb er Self - P owered Featu res ............................................................. 31 Informational Displays Pr ior to Shu tdown ................................... 32 Symptoms of a Low Battery .....
Chapter 1 Assembling the Climber Thank you for choosing Pr ecor. For proper installation, please read this guide thoroughly and fol low the assembly instructions. If you do not assemble the climber according to these guidelines, you could void the Precor Limited Warranty.
14 Assembling and Maintainin g the 835 Climb er Impo rtan t : When wr ench tighteni ng, the he ad of the f as tener should be flush with the product. If it is not , cross - threadi ng has occurre d. Do not a ttempt to rew ork the asse mbly as more damage to the equipme nt will occur .
Assembling the Climb er 15 Required Tools Before beginning the installation, make sure you have the follo wing too ls avai lab le: Wire tie cutter Phill ips scr ewdriver One ¹₂ - inc.
16 Assembling and Maintainin g the 835 Climb er 4. Insert the han dlebar flange onto the screws protruding through the handrail clamp). Rotate the handlebar to align it with the si de screw holes. CAUTIO N : Hold the handlebar upright until it is securely fastened in s tep 6 .
Assembling the Climb er 17 7. Slide the plastic top cove r onto the uprigh t support. Impo rtan t : The cor rect orie ntation of t he plastic to p cover is shown in the following il lustration. 8. Retrieve the cable assembl y from the console container and remove any packaging ties.
18 Assembling and Maintainin g the 835 Clim ber 9. Ask your assistant to hold the upright support while y ou attach it to the base frame using four hex head sc rews and four washers. U sing a ¹₂ - inch b ox wrench or open - end wrench, tighten the four fastene rs in alternating order until all four are ful ly secured.
Assembling the Climb er 19 12. Slide the rubber grommet onto the plastic top cover, as shown in the following illu stration. Apply pressure to s nap it into place.
20 Assembling an d Maintaining the 8 35 Climber Attaching the Handra ils Use the following procedu re to install the external handrails on the climber. To attac h the handra ils: 1. Slide a lower han drail boot onto each handrail. Figure 8 : Adding the handrail boot 2.
Assembling the Climb er 21 3. Secure the lower handrails using four buttonhead screws and a ⁵₃₂ - inch hex key. Fully tighten the fasteners. 4. Using a ¹₂ - inch soc ket wrench, tighten the t wo nuts beneath the upper handrail clamp unti l the handrails cannot be pulled out of t he clamp.
22 Assembling an d Maintaining the 8 35 Climber 8. Clean the foot steps, p lasti c covers and upright supp ort with a soft cloth or wipe m oistened with an approp riate cleaning solution. For mo re information about which cleaners to use, refer to Daily Cle aning .
Chapter 2 Installing the Console To make installation easier, all Precor Experience Series consoles use the same mo unting hardware and connect or locations whenever possib le.
24 Assembling and Main taining the 83 5 Climber 3. Rest the console on the c onsole mount so that the no tch on the bottom of the cons ole ’ s back pla te rests on the rectangular hook at the bottom of the console mount , as shown in the following fi gure.
Installing the Con sole 25 Connecting Cables (P30) After the console has been seated, separate the individual cables out of the end of th e cable assembly and atta ch them to the appropriate circuit c onnectors ins ide the console. Refer to the following diagram a nd table to identify the cables and connectors.
26 Assembling an d Maintaining the 8 35 Climber Completing the Consol e Installation Before you complete the f inal installation steps, doub le - check the connections you have made. Make sure that a ll cables are fully and securely connecte d, and that any unneeded cables are tied back properly.
Chapter 3 Maintenanc e To keep t he equipment functi oning properly, perform the minor maintenance tasks in t his section at the int ervals shown on the maintenanc e checklist. Failure to main tain the equipment as described in this section could void the Precor Limited War ranty.
28 Assembling and Ma intaining the 83 5 Climber Alternatively, you can clean the equipment with Athletix fitness equipment cleaning wi pes (for more information, v isit www.a thletixpr oducts.com ) CAUTIO N Vacuum the floor underneat h the equipment frequently to prevent the accumulation of dust and dirt that can in terfere with its operation.
Maintenance 29 Moving the Equipment The equipment is very heavy. If you plan to move it to a new location, obtain the help of an adult assistant and use prope r lifting techniques. If the eq uipment includes roller wh eels on one end, use the wheels to reduce the load on you rself and your assistant.
30 Assembling and Main taining the 83 5 Climber.
Chapter 4 Self - Po w er ed F eatur es Impo rtan t : This chapter of t he manual describes Precor fitness equipment that can operate without being connec ted to AC power. This includes units equippe d with P40 or P20 con soles. H owever, P8 0 consoles must be con nected to AC power through their power supplies to oper ate.
32 Assembling and Maintain ing the 835 Clim ber Informational Displays Prior to Shutdown The equipment saves its battery charge by moving into a shutdown mode. If the use r does not maintain the mi nimum rate of moti on, a 30 - secon d shutdown process begins.
Self - Powered Featu res 33 Using the Opti onal Power Adapte r After connecting the powe r adapter to the equipment , plug the opposite end into the a ppr opriat e powe r sou rce ( 120 V o r 240 V). CAUTION: When the o ptional power adap ter is in u se, mak e sure that the power supply cord d oes n ot create a s afety haz ard.
34 Assembling and Mainta ining the 83 5 Climber Replacing th e Battery The equipment ’ s batter y is built to last for a long time. However, if you feel that the battery may need repla cing, check with an authorized s ervice technician. Refer to Obtaining Service .
Chapter 5 Commer cial C ar di o v a scular E quipment Limit ed W arr anty PLEASE READ THESE WARRA NTY TERMS AND CONDITIONS C AREFULLY BEFORE USING YOUR PREC OR INCORPORATED PROD UCT. BY USING THE EQUIPMENT, YOU ARE CONSENTING TO BE BOUND B Y THE FOLLOWING WARRANTY TERMS AND CONDITIONS .
36 Assembling and Mainta ining the 83 5 Climber Opti ons / Accesso ries Many op tions or a cces sories h ave c omponents that ar e conn ected interna lly or mou nted inside the elec tronic co nsole . The follow ing guide lines determ ine the wa rranty f or the se compone nts.
Commercial Cardiovascular Equipment Limited W arranty 37 This Li mited Warr an ty sh all not ap ply to: 1. So ftware versi on upgrad es. 2. Softwa re def ects t hat do not m aterially and ne gative ly aff ect the norm al perf orm ance of the p roduct und er norm al co nditions of use .
38 Assembling and Main taining the 83 5 Climber EXCLUSION OF CONSEQUENTIAL AND INCIDENTAL DAMAGES. PRECOR AND/OR ITS S UPPLIERS SHALL HAVE NO OBLIGATION OR LIABI LITY, WHETHE R ARISING IN CO NTRACT (I.
Commercial Cardiovascular Equipment Limited W arranty 39.
40 Assembling and Main taining the 83 5 Climber.
.
As sembling and Maintaining the 835 Climber Prec or Incorporated 20031 142nd A venue NE P .O . Bo x 7202 W oodinville, W A USA 98072 -4002 CLM P AG/ OM 300714-2 41 rev E W arranty #36286- 114 14 F ebr.
Ein wichtiger Punkt beim Kauf des Geräts Precor CLIER 835 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Precor CLIER 835 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Precor CLIER 835 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Precor CLIER 835 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Precor CLIER 835 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Precor CLIER 835 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Precor CLIER 835 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Precor CLIER 835. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Precor CLIER 835 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
