Benutzeranleitung / Produktwartung KIRK KWS8000 des Produzenten Polycom
Zur Seite of 38
Polycom ® KIRK ® Wireless Ser ver 8000 Installation Guide.
ii Copyright © Polycom, Inc. All Rights Reserved Catalog No. 14184630_Hd.1 Version 1 Proprietary and Confidential The information contained herein is the sole intellec tual property of Polycom, Inc. No distribution, reproduction or unauthorized use of the se materials is permitte d withou t the expressed written consent of Polycom, Inc.
Contents 1 Contents KWS8000 Installation Installing the KWS8000 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1–1 Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
1–1 1 KWS8000 Installation This guide des cribes how you i nstall the KWS80 00. Installing the KWS8000 The KWS 8000 can be installed in a rack, on a flat surface or on a wall using the KWS8000 Wall Hanger.
Polycom KIRK Wireless Ser v er 8000 Installation Guide 1–2 General Installation Information The maximum number of KWS 8000 units that can be linked together depends on the mounting method and the ma.
KWS8000 Installation 1–3 Rack mounting Safety Precautions. • Ensure that the leveling jacks on the bottom of the rack are fully extended to the floor with the full weig ht of the rack resting on them. • In a single rack installation, stab iliz ers should be attached to the rack.
Polycom KIRK Wireless Ser v er 8000 Installation Guide 1–4 Figure 1- 1 Rack Installation Installing the KWS 8000 on a Flat Surf ace Before you start installa tion take notic e of the following safety precautions. Flat Surface Mounting Safety Precautions • Ensure the surface can support the weight of the unit.
KWS8000 Installation 1–5 2 Before placing the unit, carefully turn it upside down and mount the four rubber pads supplied in the package. On e must be placed at e ach corner of the bottom plate.
Polycom KIRK Wireless Ser v er 8000 Installation Guide 1–6 2 Mount the wall ha nger securely using f our screws. Use rawlplu gs, expansion bolts or other appropriate fastening methods in relation to the wall material. 3 Remove drilling dust, unpac k the KW S8000, fit it into the wall hanger, and then fasten the two front screws.
KWS8000 Installation 1–7 • The interface cables must be removed before any interface card is removed or replaced. • When unplugging power, unplug AC mains power first before unplugging the power connector from the KWS8000. • The AC adapters must never be hanging by their own weight in the AC mains connector or the output connector.
Polycom KIRK Wireless Ser v er 8000 Installation Guide 1–8 The unit configuration determines which plugs to use. Connect the plugs according to the following table.
KWS8000 Installation 1–9 Figure 1-5 S toring room for two AC power adapte rs If more than two AC power adapters ar e used, these must be kept on a flat surface (same requirements as for the KW S8000 unit).
Polycom KIRK Wireless Ser v er 8000 Installation Guide 1–10 Figure 1-6 Installing Interface cards 2 Plug the interface cables into the card as de scribed in “Connecting Interface Cables” on page 1-11. T o Install CPU Cards 1 Ensure that the KWS8000 is powered off completely.
KWS8000 Installation 1–11 Figure 1-7 Installing CPU card 3 Plug the interface cables into the card as de scribed in “Connecting Interface Cables” on page 1-11. 4 Connect the power and reboot the unit. Connecting Interface Cables The front interface of the KWS8000 is provided with connectors for the different interfaces provided.
Polycom KIRK Wireless Ser v er 8000 Installation Guide 1–12 Figure 1-8 Harnessing cables to the back and out.
KWS8000 Installation 1–13 Figure 1-9 Harnessing cables to the side and out. Regardless of which way is used for harnessing, you must guide the cables through the opening in the plastic front .
2–1 2 Replacing Components The KWS8000 is designed to minimize down-tim e. Several components can be replaced while the system is up. Component Replacement The following components are hot-swappable.
Polycom KIRK Wireless Ser v er 8000 Installation Guide 2–2 Component Replacement Precautions • Cards contain static sens itive circuitry and may be destroyed or damaged by electrostatic discharge (ESD.) • All maintenance tasks must be perf ormed by qualified, authorized personnel only.
Replacing C omponents 2–3 7 Plug the interface cables into the card. 8 Connect power and reboot the unit. Replacing the Backplane The backplane cannot be repl aced on-site. The chassis wi ll have to be returned for repair or be replaced with a new one.
3–1 3 Regulator y Notices This section contains important sa fety regulations for the KWS8000. International Regulator y and Product Infor mation United States Federal Communication Commission (FCC) Part 15: Class A Statement .
Polycom KIRK Wireless Ser v er 8000 Installation Guide 3–2 Polycom Inc. or our designated agent. This stipulation is required by the FCC and applies during and after the warranty period. United St ates Safety Construction Details : o All connections are indoor only .
Regulator y Notices 3–3 be collected separately . Canadian Department of Communications This Class [A] digital apparatus complies with Canadian ICES-003.
Polycom KIRK Wireless Ser v er 8000 Installation Guide 3–4 Impor tant Safety Instr uctions and Product Information Before using your te lephone equipmen t, you should always follo w basic safety instruction to reduce the risk of fire, electrical shock and injury to persons, and damage to property.
Regulator y Notices 3–5 Warning 1 Avoid using telephone durin g an electr ical storm. There may be a risk of electrical shock from lightning 2 Do not use the telephone to report a gas leak in the vicinity of the leak 3 Do not place the unit near microwave ovens, radio equipment, or non-ground connected televisions.
Polycom KIRK Wireless Ser v er 8000 Installation Guide 3–6 IC Note: Operation is subject to the followin g two conditions: (1) This device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Regulator y Notices 3–7 EXCLUSIONS . Polycom will not be liable under this limited warranty i f its testing and examination disclose that th e alleged defect or ma lfunction in the product does not exist or results from: • Failure to f ollow Polycom' s instal lation, operation, or maintenance instructions.
Polycom KIRK Wireless Ser v er 8000 Installation Guide 3–8 OUT OF OR IN CONNECTION WI TH THE SALE, INSTALLATION, MAINTENANCE, USE, PE RFORMA NCE, FAILUR E, OR INTERRUPTION OF ITS PRODUCTS, EVEN IF P.
Regulator y Notices 3–9 “PRODUCT”). You may use the SOFTWARE PRODUCT only in connection with the use of the PRODUCT. You are not permitted to le ase, rent, di stribute or sublicense the SOFTWARE PRODUCT or to use the SOFTWARE PRODUCT in a time-sharing arrangem ent or in any other unauthorized manner.
Polycom KIRK Wireless Ser v er 8000 Installation Guide 3–10 and related rights in the content accessed throu gh the SOFTWARE PRODUC T is the property of such content owner an d may be protected by applicable law. This Agreement gives you no rights in such content.
Regulator y Notices 3–11 6.1 Limited Warran ty . POLYCOM warr ants that (a) the SOF TWARE PRODUCT will perform substantiall y in accordance with the accompanying documentation for a period of ninety.
Polycom KIRK Wireless Ser v er 8000 Installation Guide 3–12 OR THE PROVISION OF OR FAILUR E TO PROVIDE SUPPORT SERVICES, EVEN IF POLYCOM HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. IN ANY CASE, POLYCOM' S ENTIRE LIABILITY SHALL BE LIMITED TO THE GREATER OF THE AMOUNT ACTUALLY PAID B Y YOU FOR THE SOFTWARE PRODUCT OR U.
. 3–13 10.4 U.S. Government Restricted Rights. The SOFTWARE PRODUCT and documentation are provided with RESTRICTED RIGHTS. The SOFTWARE PRODUCT programs and documentation are deemed to be "commercial computer software" and "commercial computer software documentation", respectively, pursuant to DFAR Se ction 227.
KWS 8000 Installation and Configuration Guide 11 T ables Table 1-1 Physical dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1–1 Table 1-2 Power supply . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figures 11 Figures Figure 1-1 Rack Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1–4 Figure 1-2 Wall hanger positioni ng . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Index Index – 1 Index A AC power adapters 1–9 E Environment 1–1 F Flat surface installation 1–4 I Interface cable connection 1–11 Interface card installation 1–9 P Physical dimensions 1–.
A–1 A RJ45 Wiring The following table shows the assignment s of wire pairs to plug and socket pins of the RJ45 cable. Ta b l e A - 1 RJ45 cable wiring Pin Pair Wiri ng Connector 1 Connector 2 Connec.
.
14184630, Hd.1. Rasmussens Bogtrykkeri, Ringkøbing.
Ein wichtiger Punkt beim Kauf des Geräts Polycom KIRK KWS8000 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Polycom KIRK KWS8000 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Polycom KIRK KWS8000 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Polycom KIRK KWS8000 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Polycom KIRK KWS8000 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Polycom KIRK KWS8000 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Polycom KIRK KWS8000 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Polycom KIRK KWS8000. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Polycom KIRK KWS8000 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
