Benutzeranleitung / Produktwartung 926057 des Produzenten Ariens
Zur Seite of 34
Owner/Operator Man ual Manuel Du Prop riétaire/Utilisa teur Model 926057 – Power Brush 3 6 (Serial No. 000101 +) Power Brush 36 04653900 4/13 Printed in USA ENGLISH FRANÇAIS E10 The use of any gasoline e xceeding 10% ethanol (E10) or 10% MTBE will void the product warranty.
EN - 2 Safet y . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Assembly . . . . . . . . . . . . . . . . . . . . . . . . 8 Controls & Feat ur es. . . . . . . . . . . . . . . 10 Operati on . . . . . . . . . . . . . . . . . . . . . . . 11 Maintena n ce .
EN - 3 DISCLAI MER Ariens reserves the right to discont inue, make changes to, and add improvements upon its product s at any time without public notice or obligation. The des criptions and specifications contained in this manual wer e in effect at printing.
EN - 4 REQUI RED OP ER AT OR T RAIN ING Original purchaser of this unit was instructed by the seller on safe and proper operation. If unit is to be used by someone other than original purchaser; loaned, r ented or sold, AL WA YS provide this manual and any needed safety training before operation.
EN - 5 EMISSIO N CONTROL S YSTEM This equipment and/or its engine may include exhaust and evaporative emissions control system components required to meet U.S. Environmental Protection Agency (EP A) and/or California Air Resources Board (CARB) re gulations.
EN - 6 Keep children and people away . Keep children out of work area and under watchful care of a responsible adult. NEVER allow children to operate or play on or near unit. Be alert and shut off unit if children enter area. DO NOT allow adults to oper ate unit without proper training.
EN - 7 Adjust brush height before operat ing. Engage traction drive clutch bef ore attachment clutch. If brush is set too l ow or if terrain is irregular brush can drive machine rearward. DO NOT operate on steep slopes. DO NOT cl ear debris across the f ace of slopes.
EN - 8 T ools Req uired: •T i r e G a u g e • Pliers • 1/2-In. 3/8-In, 7/16-In, and 9/16-In Wrench and/or Adjust able Wrench Unp acking Unit Unfold Handle bar (Figure 3) 1. R emove the lower and loosen the upper hardware on t he handlebar assem bly .
EN - 9 Check T ire Press ure Check tire pressure and adjust to the pressure listed on tire sidewall. Check Eng ine Crankc ase Oil IMPORT ANT : Engine is shipped with 5W-30 oil in crankcase. Refer to Engine Manual for detailed instructions. Fill Engine Fu el T ank Refer to Engine Manual for proper fuel type and tank capacity .
EN - 10 1. Traction Drive Clutch Lever 2. Speed Selector Lever 3. A ttachment Clutch Lever 4. B rush Ang le Lock Lever 5. R ecoil S tarter Handle 6. E ngine Shut Off Switch 7. E ngine Throttle 8. Oil Fill/Dipstick 9. B rush G uard 10. Brush 1 1. Height A djustment Wheels 12.
EN - 11 ST A NDARD CONTROLS See Controls and F eatures on p age 10. T ract i on Dr ive Cl utch - Lef t Hand Lever Squeeze the T raction Drive Clutch Lever against the handlebar (1) to engage wheel drive for propelling unit. Release lever (2) to stop movement.
EN - 12 Throttle Lever The throttle controls the engine speed. T o increase or decrease engine s peed, adjust to: 1. Fast (normal or warm starts) to left 2. Par t-Throt tle at center 3. Slow (cold weat her starts) to right Elec tri c Starter The electric starter will start a properly choked engine when the starter button is pushed.
EN - 13 3. Lift the brush head assembly off the ground and reverse the unit to move it away from t he swept area. 4. Stop engine and allow all moving parts to sto p. 5. C heck the width of the s wept area. The brush pattern should be 2 – 3 inches (5.
EN - 14 5. Fill fuel tank to wit hin 1/2 in (1.27 cm) below bottom of filler neck. See Specifications on page 29 for f uel tank capacity . IMPORT ANT : DO NOT OVERFILL! This equipment and/or its engin.
EN - 15 5. P ull recoil starter handle with a rapid continuous full arm stroke. Let rope rewind slowly . IMPORT ANT : DO NOT let S tarter Handle snap against S tarter . NOTE: When opera ting unit in the winter months, recoil guard foam cover must be installed.
EN - 16 Ariens Dealers will provide any service or adjustments which may be required to keep your unit operating at peak efficiency . Should engine service be r equired, contact a Ariens dealer or an auth orized engine manufacturer's service center.
EN - 17 OPERATING PO SITION (Figure 7) T o connect the brush attachment to traction unit: 1. P lace attachment belts onto attachment pulley . NOTE: Holding down the attachment clutch lever will make it easier t o reconnect the brush attachment to t raction unit.
EN - 18 CHECK CLUTCH OPERATION Brush must stop quickly when attachment clutch lever is released. Wheels must st op quickly when traction drive clutch lever is released.
EN - 19 GENERAL LUBRICATION (Figure 8) 1. P lace unit into the service position (See Serv ice Pos iti o n on page 16). IMPORT ANT : Wipe each fitting clean before and after lubrication. DO NOT allow grease or oil to get on friction disc, friction plate or belts.
EN - 20 RECOIL GUARD FOAM C OVER INST ALLATION (Figure 9) The recoil foam cover slides over the starter handle and attaches to the recoil guard with Ve l c r o ® . NOTE: The recoil guard foam cover is not necessary for operation during the non-winter months.
EN - 21 ATT ACHMENT CLUTCH ADJUSTMENT (Figures 1 1, 12 and 13) Remove Att achment Cable Slac k 1. R emove the belt cover . 2. Lo osen jam nut on cable adjustment barrel, and then turn the adjustment barrel down to shorten cable and remove all c able slack (Figure 1 1).
EN - 22 Check Att achment Idl er Arm Roller Clearance (Figure 13) NOTE: It will be difficult to check the measurement inside the frame. Use a 1/ 2 in. (12.7 mm) minimum spacer as a gauge to check the clearance between the roller and the frame. 1. R emove bottom cover .
EN - 23 T RACTI ON DRIVE CLUTCH ADJUSTMENT (Figure 15) If drive slip s, adjust traction clutch to compensate for friction disc wear . T o adjust traction clutch: 1. Lo osen jam nut on traction cable adjustment barrel. Turn the adjustment barrel down to shorten cable and remove all c able slack.
EN - 24 2. T o gain b elt clearance, back out the st op screw from the frame until the drive plate assembly c an swing past it (Figure 15). 3. P ull idler away from t raction drive belt and remove belt from engine sheave. It may be necessary to turn engine pulley using recoil handle ( Figure 16).
EN - 25 BRUSH SEGMENT REPLACEME NT (Figure 18, 1 9, and 20) 1. S hut of f engine, close fuel shut-of f valve, disconnect spark plug w ire and allow unit to cool c ompletely .
EN - 26 3. Lo osen each bearing setscrew and slide bearings inward, aw ay from horizontal end sup port s. IMPORT ANT : Brush gearbox splined shaft will separate fr om brush housing u-joint. Support splined shaft to prevent damage (Figure 19). 4. M anually move t raction unit backwards, pulling brush housing away from brush assembly .
EN - 27 IMPORT ANT : Brush segm ents must be aligned properly so they do not nest tog ether (Figure 19). 7. R emove used brush segments and replace with ne w segments. IMPORT ANT : For each brush segment, align the pair of engagement fingers on alternating support shafts.
EN - 28 T o obtain a complete parts manual, find your model and serial number . Then go t o www .ariens.com. T ROUBLESHOOTING PROBLEM PROBABLE CAUSE CORRECTION Engine wi ll not crank/ start. 1. Fuel tank is empty . 2. Fuel shut-off valve closed. 3. Engine s hut off switch turne d off.
EN - 29 SPE CIFICATIONS Model N umber 926057 Engine Subaru EX27 Engine Displacement – in 3 (cc) 16.2 (265) Fast Idle S peed – RPM 3800 ±100 S tarter 120V A C Electric and Recoil Fu e l See Engine Manual T ank Capacity – qts. (L) 6. 3 (6 .1 ) Clearing Width – in.
Sno-Chore 2013 EN - 30 Sno-Thro ® , Sno- T ek ® and Chore Perform ing Equipment Limited W arranty Ariens C ompany (Ari ens) warr ants to the o riginal purch aser that Ariens, G ravely , Parker , and.
Sno-Chore 2013 EN - 31 Exceptions and Limitations The chart below details special e xceptions to this warran ty: Custome r R e s pons i bili ti es Regist er the product i mmedia tely at t he time of sale.
Sno-Chore 2013 EN - 32 Exclusions – Items Not Covered by This W arranty • Parts that a re not ge nuine Arie ns, Gravely, Parker or Co untax service parts ar e not cove red by thi s warranty an d may voi d the war ranty .
.
Ariens C ompany 655 West Ryan S t reet Brillion, WI 541 10 920-756-4688 Fax 920-756-2407 www .ariens.com.
Ein wichtiger Punkt beim Kauf des Geräts Ariens 926057 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Ariens 926057 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Ariens 926057 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Ariens 926057 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Ariens 926057 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Ariens 926057 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Ariens 926057 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Ariens 926057. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Ariens 926057 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
