Benutzeranleitung / Produktwartung S 2110 des Produzenten Miele
Zur Seite of 24
Operating instructions Vacuum cleaners S 2110 / S 2120 / S 2130 To avoid the risk of accidents or damage to the appliance, it is essential to read these instructions before using it for the first time.
Caring for the environment ..........................................3 Description of the vacuum cleaner ...................................4 Warning and safety instructions .....................................6 Preparing for use ....................
Disposal of the packing material The transport and protective packing has been selected from materials which are environmentally friendly for disposal and can normally be recycled. Ensure that any plastic wrappings, bags, etc. are disposed of safely and kept out of the reach of babies and young children.
Description of the vacuum cleaner 4.
a Handle b Air inlet valve c Release button d Connection piece for storage * e Telescopic tube * f Connection socket g EasyLock tube * h Slide controls for the telescopic tube * i Dust compartment rel.
This appliance conforms to current safety requirements. Improper use of the appliance can, however, present a risk of both personal injury and material damage. To avoid the risk of accidents and damage to the appliance, please read these instructions carefully before installation and before using it for the first time.
~ There is a metal inlay underneath the handle which is designed to avoid the unpleasant effects of electrostatic discharges. Please make sure that you keep your hand in constant contact with this metal strip during vacuuming.
~ Do not vacuum up any inflammable or combustible liquids or gases and do not vacuum in areas where such substances are stored. The cleaner might explode. ~ Do not vacuum up items which are heavy, hard or have sharp edges. They could cause a blockage and damage the appliance.
Attaching the suction hose a ^ Insert the hose connector into the suction socket until it clicks into position. To remove the suction hose b ^ Press the release buttons at the side of the hose connector, and lift the hose from the socket.
Adjusting the telescopic tube One part of this telescopic tube is packed inside the other and can be adjusted to suit your height for comfortable vacuum cleaning. ^ Press the telescopic tube release button to release the tubes and adjust to the required height.
The following accessories are supplied: a Dusting brush b Upholstery nozzle c Crevice nozzle d VarioClip for the above accessories Symbols on the holder show where to attach the different accessories. VarioClip ^ Attach the VarioClip either on-hand at waist level or on-board at the connector.
Pull out the mains cable a ^ Pull out the mains cable to the required length (max.cable length approx. 5.5 m). , If vacuuming for longer than 30 minutes, the mains cable must be pulled out to its fullest extent. Otherwise there is a danger of overheating.
Adjusting the suction power The suction power can be regulated to suit the type of flooring. Reducing the suction power reduces the amount of effort required to manoeuvre the floorhead. Some models also have symbols on the controls. The symbols indicate the type of use the settings are suitable for.
ParkSystem A parking system has been designed for conveniently parking the vacuum cleaner during pauses. ^ Slot the floorhead into the parking attachment at the back of the vacuum cleaner. Storing ^ Stand the vacuum cleaner upright when it is not being used and during storage.
, Always disconnect the vacuum cleaner from the electrical supply for maintenance work and for cleaning. Switch off at the wall socket and remove the plug. The Miele filter system consists of three filters which must be replaced from time to time to ensure that your vacuum cleaner performs efficiently.
When to change the dustbag Change the dustbag when the colour marker in the dustbag change indicator fills the display, or sooner if it is no longer effective. Miele dustbags are disposable, and designed for single use only. Do not attempt to re-use them as suction would be reduced.
Replacing the dustbag ^ Press the release button for the dust compartment lid and raise the lid as far as it will go. The dustbag has a closing flap which closes automatically when the dust compartment lid is raised to prevent any dust escaping. Replacing the dustbag a ^ Pull the dustbag out by the grip next to the self-closing flap on the collar.
When to change the dust compartment filter (for motor protection) Replace this filter every time you start a new packet of dustbags. An exhaust filter is supplied with every packet of Miele dustbags. How to change the dust compartment filter ^ Open the dust compartment lid.
Replacing one type of exhaust filter with another Your Miele vacuum cleaner can be fitted with optional Active Air Clean / Active HEPA filter. This filter can be used instead of the Air Clean filter, which is supplied as standard.
When to change the thread lifters The thread lifters on the suction inlet to the floorhead can be replaced. Check them from time to time and replace them if the pile has worn down. To replace the thread lifters Floor head SBD 350-3 ^ Use a suitable tool to remove them from the slots a .
The vacuum cleaner switches off automatically. A temperature limiter switch switches the vacuum cleaner off automatically if it gets too hot. This can occur if, for instance, large articles block the suction tube or when the filter bag is full or contains particles of fine dust.
In the event of a fault that you cannot easily remedy, please contact – your Miele Vacuum Cleaner Specialist or – The Miele Customer Contact Centre (see back cover for address). Warranty The appliance is guaranteed for a period of 2 years. For information on the appliance guarantee specific to your country please contact Miele.
All work should be carried out by a suitably qualified and competent person in strict accordance with national and local safety regulations. The voltage connected load are given on the data plate located underneath the vacuum cleaner. Please ensure that these match the household mains supply.
Alteration rights reserved (S 2110 - S 2130) - 1510 M.-Nr. 07 861 720 / 00.
Ein wichtiger Punkt beim Kauf des Geräts Miele S 2110 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Miele S 2110 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Miele S 2110 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Miele S 2110 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Miele S 2110 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Miele S 2110 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Miele S 2110 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Miele S 2110. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Miele S 2110 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
