Benutzeranleitung / Produktwartung 10652569101 des Produzenten Kenmore
Zur Seite of 25
® Side by Side Refrigerator Refrigerador de dos puertas R_frig_rateur c6te & c6te % . , <, ,+ = ,, = ,,+, Sears Roebuck and Co., Hoffman Estates, IL 60179 U.S.A. www.sears.com 2220694 Sears Canada, Inc., Toronto, Ontario, Canada M5B 2B8 www.sears.
TABLE OF CONTENTS WARRANTY .................................................................................... 2 REFRIGERATOR SAFETY ............................................................. 3 REFRIGERATOR INSTALLATION ...........................
REFRIGERATOR SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others.
REFRIGERATOR INSTALLATION Removing packaging materials • Remove tape and glue residue from surfaces before turning on the refrigerator. Rub a small amount of liquid dish soap over the adhesive with your fingers.
Electrical Shock Hazard Pluginto a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock.
TOOLS NEEDED: 1/4 in., 1/2 in., and %6 in. hex-head socket wrenches, a flat-head screwdriver and a Phillips screwdriver. IMPORTANT: Before you begin, turn the refrigerator control OFF, unplug refrigerator or disconnect power. Remove food and any adjustable door orutility bins from doors.
NOTE: It may only be necessary to remove either the door handle or the doors to get your product through the doorway of your residence. Measure the door opening to determine whether to remove the refrigerator handles or the doors. Handle Removal (optional) 1.
3, Door Closing 1. Move the refrigerator into its final position. 2. Place a level inside the refrigerator at the back of the top shelf (see Graphic 6). 3. Locate the leveling screws behind the base grille of the refrigerator on either side. 4. Use a hex-head socket wrench to adjust the rear roller leveling screws until the refrigerator is level.
Please read before using the water system. Immediately after installation, follow the steps below to make sure that the water system is properly cleaned. 1. Open the freezer door and turn off the ice maker. For Style 1 lift up the wire shutoff arm as shown.
IMPORTANT: Because air circulates between both sections, any odors formed in one section will transfer tothe other. You must thoroughly clean both sections to eliminate odors.
Cut Hazard Use a sturdy glass when dispensing ice or water. Failure to do so can result in cuts. Depending on your model, you may have one or more of the following options: the ability to select either crushed or cubed ice, a special light that turns on when you use the dispenser, or a lock option to avoid accidental dispensing.
The dispenser lock (on some models) Style 1: Behind the base grille filter Your dispenser can be turned off for easy cleaning or to prevent accidental dispensing by small children and pets. To turn off the dispenser, press the LOCK button. The indicator will appear above the LOCK button and the ice and water dispensers will not work.
Flushing the Water System After Replacing Filter Use a sturdy container to depress the water dispenser bar until the water begins to flow. Flush the water system by dispensing and discarding 2 to 3 gal. (8 to 12 L) of water. Cleaning the system will take approximately 6 to 7 minutes and will help clear air from the line.
2. Wash ice bin or bucket with a mild detergent, rinse well and 2. Replace the shelf by guiding it back into the slots on the dry thoroughly. Do not use harsh or abrasive cleaners or frame and pushing the shelf in past the stop. solvents. REMEMBER: • Allow 24 hours to produce the first batch of ice.
The dell drawer stores raisins, nuts, spreads, and other small items at normal refrigerator temperatures. TO remove and replace the dell drawer: 1. Remove the dell drawer by sliding it straight out to the stop. Lift the front and slide the drawer out the rest of the way.
Ca JB< Ate o_ s{ '_e s(xSes-Accesso'y To remove and replace the wine rack (left) or can/bottle rack (right): 1. Remove the rack by pulling it straight out from the shelf. 2. Replace the rack by sliding it in between the shelf and the wall of the refrigerator.
NOTE: Can racks may be purchased as an Accessory for some models, TO remove and replace the racks/bins: 1. Remove the racWbin by lifting it and pulling it straight out. 2. Replace the rack/bin by sliding it in above the desired support and pushing it down until it stops.
Refrigerator Crisper Light or Upper Freezer Light (on some models) • Remove light shield by grasping the top center of the shield and pulling forward while turning it slightly to one side. If necessary, remove top crisper drawer to access crisper light shield.
4. Depending on your model, turn the Thermostat Control or Refrigerator Control to OFR See the "Setting or Using the Controls" section. 5. Unplug the refrigerator.
Is there a water filter installed on the refrigerator? The • filter may be clogged or installed incorrectly. Check the filter installation instructions to ensure that the filter was installed correctly and is not clogged. If installation or clogging is not a • problem, call a technician or other qualified person.
The dispenser water is not cool enough The doors will not close completely • Has the refrigerator been newly installed? Allow 24 hours • Are food packages blocking the door open? Rearrange for the refrigerator to cool completely. • Has a large amount of water been recently dispensed? Allow 24 hours for the water to cool completely.
SERVICE Master Protection Agreements Congratulations on making a smart purchase. Your new Kenmore_"_appliance is designed and manufactured for years of dependable operation. But like all products, it may require preventive maintenance or repair from time to time.
WATER FILTER CERTIFICATIONS Water _nt Device Certif_ato Numbez 98- 1366 D+t_]n_t*_ Ko,mmbet L_,, 1998 Depart_mt o f Ikalth Services Water Tx_tment Device Certificate Numb_ 98-1367 Ds_ Bm_: Novlmmb_ IS+ 19:J8 TrtdemlrldMedd D#h_ox_on R Iicemeat Eleme_tl vrnmpoot vcF-i.
PRODUCT DATA SHEETS Base Grille Water Filtration System Model WF-NLC250/NLC250 (_) Tested and certified by NSF International against ANSI/NSF Standard 42 for the reduction of Chlorine (Class I) Taste and Odor and against ANS/NSF Standard 53 for the reduct on of Lead, Cysts and Turb d ty.
Your Home For repair-in your home-of all major brand appliances, lawn and garden equipment, or heating and cooling systems, no matter who made it, no matter who sold it! For the replacement parts, accessories and owner's manuals that you need to do-it-yourself.
Ein wichtiger Punkt beim Kauf des Geräts Kenmore 10652569101 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Kenmore 10652569101 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Kenmore 10652569101 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Kenmore 10652569101 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Kenmore 10652569101 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Kenmore 10652569101 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Kenmore 10652569101 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Kenmore 10652569101. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Kenmore 10652569101 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
