Benutzeranleitung / Produktwartung RC-BX25BK des Produzenten JVC
Zur Seite of 24
RC - BX25BK RC - BX15BK / BU CD PORTABLE SYSTEM SISTEMA PORTATIL CON CD CHAINE PORTABLE A CD RC-BX25BK/RC-BX15BK/BU CD PORTABLE SYSTEM MANUAL DE INSTRUCCIONES MANUAL D’INSTRUCTIONS INSTRUCTIONS T RC.
2 ENGLISH Thank you for purchasing this JVC product. Please read these instructions carefully before starting operation to be sure to obtain optimum performance and a longer service life from the unit. CONTENTS Features ...............................
3 INFORMA TION (For U.S.A) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reaso- nable protection against harmful interference in a residential installation.
4 SAFETY PRECAUTIONS Prevention of Electric Shocks, Fire Hazards and Damages 1. Even when the POWER button is set to ST ANDBY , a very small current will flow . T o save power and for safety when not using the unit for an extended period of time, dis- connect the power cord from the household AC outlet.
5 3. Condensation In the following cases, condensation may occur on the lens, in which case the unit may not operate correctly . • In a room where a heater has just been switched on. • In a place where there is smoke or high humidity . • When the unit is moved directly from a cold to a warm room.
6 POWER SUPPL Y A. Operation on household AC • Connect the AC power cord. • The provided AC power cord for this unit has certain one-way direction connections to prevent electric shock. Refer to the illustra- tion for correct connection. CAUTIONS: 1.
7 Checking batteries When the tape speed or output sound de- creases, or CD playback is intermittent, replace all batteries with fresh ones. When making an important recording, use new batteries (preferably alkaline batteries with a longer service life) to avoid any possible failure.
NAMES OF P ARTS AND THEIR FUNCTIONS • Front of top panel 1 BASS BOOST switch _ ON: Set to this position to listen to Bass boost sound. — OFF: Set to this position when Bass boost sound is not required.
y Cassette holder u Cassette operation buttons 8 P AUSE: Press to stop the tape temporarily during playback and recording. § STOP/EJECT : Press to stop the tape. Pressing this button after the tape stops opens the cassette holder . 1 FF: Press to wind the tape forward rapidly .
10 REMOTE CONTROL UNIT (RC-BX25 only) Preparation before use • Installing batteries in the remote control unit 1. Remove the battery cover from the back of the remote control unit.
11 The following operations can be performed using the remote control unit. • Check the functions of the operation buttons carefully and operate them cor- rectly .
12 SWITCHING THE POWER ON/ OFF Switching the power on/off • Switching on: • Switching off: COMPU PLA Y (only when AC power is used) Even when the power is set to ST ANDBY , pres- sing the button shown below switches on the power and selects the source.
13 CONCERNING COMP ACT DISCS Since dirty , damaged and warped discs may damage the unit, care should be taken of the following: 1. Usable compact discs Use compact discs with the mark shown. 2. Notes on handling discs • Do not touch the reflective recorded surface.
14 PLA YING COMP ACT DISCS Playing an entire disc ... The following example assumes a compact disc with 10 tunes and a total playing time of 50 minutes 45 seconds. Operate in the order shown 1 Press to open the Disc holder . 2 Load a disc with the label side facing up and close the Disc holder .
15 Search playback (to locate the required position on the disc) • The required position can be located using fast-forward or reverse search while play- ing a disc. • Hold down the button; search play starts slowly and then gradually increases in speed.
16 Direct access playback (using the re- mote control) (RC-BX25 only) • Pressing any of the track number buttons will start play from the beginning of the de- signated tune, without your having to press the 6 button. 1 Press the 7 (clear) button to set to the CD mode.
17 CASSETTE T APE Cassette tape 1. Loose tape may cause trouble. With a pen- cil, gently tighten the tape as shown. 2. T o prevent recordings from being erased accidentally , remove the tab(s) with a screw- driver . Reseal the slots with adhesive tape to erase and re-record after the tabs have been broken off.
18 RADIO RECEPTION Operate in the order shown 1 Press to set to TUNER mode. 2 Select the band (See page 8). 3 T une to the required station. 4 Adjust. Using the antennas Note: The built-in ferrite core antenna can pick up in- terference from television receivers in the neighborhood and thereby disturb AM reception.
19 RECORDING • In recording, the ALC circuit automatically optimizes the recording level; adjustment of the recording level is unnecessary . Operate in order shown 1 Select the recording source. • When recording from the radio —Set the TUNER mode • When recording from the CD player —Set the CD mode 2 Load a cassette.
20 Synchronized recording with the CD player • In this system, the CD player starts play- back when deck enters the recording mode. Operate in the order shown 1 Set the POWER button to ON. 2 Load a cassette. 3 Load a disc. 4 Set to CD. 5 Press the ¶ REC button with the T APE (Play) button, synchronized recording will start.
21 Erasing When recording on a pre-recorded tape, the pre- vious recording is automatically erased and only the new material can be heard when the tape is played. T o erase a tape without making a new record- ing ... 1. Press the 7 (CD stop) button while there is no disc loaded in the unit.
22 TROUBLESHOOTING What appears to be trouble is not always serious. Make sure first ... 1 Power cannot be turned on. * Is the power cord unplugged? 2. When the T APE (Play) button is pressed, tape does not move. * Is the 8 P AUSE button pressed? 3. Playback sound is at a very low level.
23 SPECIFICA TIONS Compact disc player section T ype : Compact disc player Signal detection : Non-contact optical system pickup (semiconductor laser) Number of channels : 2 channels (stereo) Frequency.
VICTOR COMPANY OF JAPAN, LIMITED RC-BX25BK/RC-BX15BK/BU CD PORTABLE SYSTEM Printed in China 0199IMMIDEHIT EN,SP,FR A4-3C 98.12.1 EN,SP,FR2-23RC-BX25BXCOVER 12/24/98, 3:39 PM 2.
Ein wichtiger Punkt beim Kauf des Geräts JVC RC-BX25BK (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie JVC RC-BX25BK noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für JVC RC-BX25BK - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von JVC RC-BX25BK reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über JVC RC-BX25BK erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon JVC RC-BX25BK besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von JVC RC-BX25BK verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit JVC RC-BX25BK. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei JVC RC-BX25BK gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.