Benutzeranleitung / Produktwartung LVT1364-002B des Produzenten JVC
Zur Seite of 30
LVT1364-002B [B] MICR O COMPONENT SYSTEM UX-G4 UX-G3 –Consists of CA-UXG4 and SP-UXG4 –Consists of CA-UXG3 and SP-UXG3 INSTR UCTIONS UX-G4_UX-G3.cover[B]B.
G-1 W arnings, Cautions and Other s CA UTION— (ST ANDBY/ON) button! Disconnect the mains plug to shut the power off completely (all lamps and indications go off). The (ST ANDBY/ON) button in an y position does not disconnect the mains line. • When the unit is on standby , the ST ANDBY lamp lights red.
G-2 SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been designed and manuf actured to meet international safety standards , but lik e any electrical equipment, care must be tak en if you are to obtain the best results and saf ety is to be assured.
1 Power sources •W hen unplugging the unit from the wall outlet, al ways pull on the plug, not the AC po wer cord. DO NO T handle the A C power cord with w et hands. Moisture condensation Moisture may condense on the lenses inside the unit in the following cases: • After starting to heat the room.
2 Contents Location of the Buttons and Controls ............................. 3 Main Unit .................................................................................. 3 Remote Control .............................................................
3 Location of the Buttons and Controls Become familiar with the b uttons and controls on your unit. Main Unit OPEN COMPACT DIGITAL AUDIO DAIL Y TIMER/SNOOZE 1 3 2 COMPACT DIGITAL AUDIO ST ANDBY CD PHO.
4 Display window Display window 1 D AIL Y 1/2/3 (timer number) indicator 2 (timer) indicator 3 ON/OFF (timer on-time/of f-time) indicators 4 REC (recording timer) indicator 5 (group folder) indicator .
5 Remote Control See pages in parentheses for details. When using the remote control, point it at the remote sensor on the front panel. 1 ST ANDBY/ON b utton (8, 22) 2 SLEEP button (23) 3 CLOCK/TIMER .
6 Getting Started Unpacking After unpacking, check to be sure that you ha ve all the follo wing items. The number in parentheses indicates the quantity of each piece supplied. • FM antenna (1) • AM (MW) loop antenna (1) • Remote control (1) • Batteries (2) If any item is missing, consult your dealer immediately .
7 Connecting Other Equipment To connect an audio equipment Y ou can connect audio equipment—used only as a playbac k de vice. • DO NO T connect any equipment while the power is on. • DO NO T plug in any equipment until all connections are complete.
8 Common Operations Setting the Clock Before operating the unit any further , f irst set the unit’ s clock. When you plug in the po wer cord, “0:00” starts flashing on the display . Y ou can set the clock when the unit is either turned on or in standby mode.
9 Selecting the Source To select the source, press CD 6 , T APE 2 3 , FM/AM, or AU X . • When you select CD as the source, playback starts automatically . To operate the CD play er , see pages 10 to 13. To operate the tape deck, see page 14. To operate the tuner (FM or AM (MW)), see pages 15 to 17.
10 Playing Back the Entire Disc—Normal Play 1 Press ) OPEN on top of the unit. The disc cov er opens. •Y ou can insert a disc while listening to another source. 2 Place a disc corr ectly with its label side up. 3 Close the disc cov er gently . 4 Press CD 6 .
11 Ta g T o remove the disc, press ) OPEN on the unit, then take out the disc by holding it at the edges while pressing the unit’ s pi vot lightl y . • If the disc cannot be read corr ectly (because it is scratched, f or e xample) or an unreadable CD-R or CD-R W is inserted Playback will not start.
12 Repeating T racks—Repeat Play Y ou can hav e all the tracks, the program or indi vidual track currently playing, repeat as many times as you lik e.
13 Displaying the Remaining Time during Playback Y ou can display the remaining time of the current track/disc and the elapsed time of the current track/disc during playing.
14 If no cassette is inserted when y ou press T APE ¤ ‹ “NO T APE” appears on the display . To stop playing, press 7 . To fast-wind to the left or to the right, press ¢ or 4 (or UP ¢ or DO WN 4 on the unit). The tape direction indicator ( 3 or 2 ) starts flashing rapidly on the display .
15 T uning in to a Station 1 Pr ess FM/AM to select either “FM” or “AM (MW). ” The unit automatically turns on and tunes in to the previously recei v ed station—either FM or AM (MW). • Each time you press the button, the band alter nates between FM and AM (MW).
16 123 456 78 0 9 OVER FM/AM PRESET GROUP PRESET GROUP UP DOWN T uning in to a Preset Station On the r emote control ONL Y : 1 Pr ess FM/AM to select either “FM” or “AM (MW). ” The unit automatically turns on and tunes in to the previously recei v ed station—either FM or AM (MW).
17 Searching for Programs by PTY Codes (PTY Search) One of the advanta ges of RDS is that you can locate a particular kind of program by specifying the PTY codes. •F or details on the PTY codes, see “ Description of the PTY codes ” on the right column.
18 Listening to the External Equipment Y ou can listen to the external equipment such as MD recorder , cassette deck, or other auxiliary . •F irst, make sure that the external equipment is properly connected to the unit. (See page 7.) 1 Set the volume le vel to the minimum position.
19 3 Start playing the source—FM, AM (MW), or auxiliary equipment connected to A UX jack. •W hen the source is FM or AM (MW), tune in to the station you want to record. • When recording from discs, see “Recording Discs— Disc Synchronized Recording” on page 20.
20 To stop recording f or a moment, press REC. Both the CD playback and tape recording are paused. T o resume r ecording, press T APE ¤ ‹ . To stop recording , press 7 . The recording stops and the CD playback is paused. To record on both sides—Reverse Mode On the r emote control ONL Y : Press REV .
21 Using the T imers There are four timers a vailable—Daily T imer , Recording T imer , Snooze T imer, and Sleep T imer . • Before using these timers, make sure the b uilt-in clock is set correctly (see page 8). Using Daily Timer and Recor ding Timer Y ou can set the timer whether the unit is on or of f.
22 3 F or the Recording Timer ONL Y : Set the off-time y ou want the unit to tur n off. (1) Press UP or DO WN to set the hour , then press SET . (2) Press UP or DO WN to set the minute, then press SET . If you want to change the time setting, press CANCEL.
23 Using Sleep T imer W ith Sleep T imer, you can fall aslee p to your fav orite music or radio program. •Y ou can set Sleep T imer only when the unit is turned on. •Y ou can also turn of f the unit automatically by using Auto Standby . (See page 8.
24 Maintenance To get the best performance of the unit, keep your discs, tapes and mechanism clean. General notes In general, you will hav e the best performance by keeping your discs, tapes and the mechanism clean. • Store discs and tapes in their cases, and keep them in cabinets or on shelves.
25 If you are ha ving a problem with your unit, check this list for a possible solution before calling for service. If you cannot solve the pr oblem from the hints giv en here, or the unit has been physically damaged, call a qualif ied person, such as your dealer for service.
26 Amplifier Section Output Power: 25 W per channel, min. RMS, driv en into 4 Ω at 1 kHz with no more than 10% total harmonic distortion. (IEC268-3) Audio input sensiti vity/Impedance (at 1 kHz) A UX: 500 mV/50 k Ω Speakers Impedance: 4 Ω – 16 Ω T uner FM tuning range: 87.
EN 0205NYMMDWORI © 2005 Victor Company of Japan,Limited UX-G4/UX-G3 MICRO COMPONENT SYSTEM UX-G4_UX-G3.cover[B].p65 05.2.7, 4:58 PM 2.
Ein wichtiger Punkt beim Kauf des Geräts JVC LVT1364-002B (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie JVC LVT1364-002B noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für JVC LVT1364-002B - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von JVC LVT1364-002B reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über JVC LVT1364-002B erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon JVC LVT1364-002B besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von JVC LVT1364-002B verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit JVC LVT1364-002B. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei JVC LVT1364-002B gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
