Benutzeranleitung / Produktwartung CA-MXJ50 des Produzenten JVC
Zur Seite of 32
GVT0029-008A [ B ] For Customer Use: Enter below the Model No. and Serial No. which are located either on the rear , bottom or side of the cabinet. Retain this information for future reference.
Warnings, Cautions and Others IMPORT ANT for the U .K. DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable f or the power points in your home or the cable is too short to reach a power point, then obtain an appro- priate safety appro ved extension lead or consult y our dealer .
– G-2 – SAFETY INSTR UCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been disigned and manuf actured to meet inter national saf ety standards but, like an y electrical equipment, care must be taken if y ou are to obtain the best results and saf ety is to be assured.
– 1 – Introduction About This Manual This manual is org anized as follows: • The manual mainly explains operations using the b uttons and controls on the unit. Y ou can also use the b uttons on the remote control if they ha ve the same or similar names (or marks) as those on the unit.
– 2 – Contents Location of the Buttons and Controls ....................... 3 Front Panel ................................................................. 3 Remote Control .......................................................... 5 Getting Started .
– 3 – 1 2 3 6 7 8 9 p q w r t u i 5 4 CA-MXJ750R CA-MXJ552R CA-MXJ550R CA-MXJ500 e y o j l k / z x c v n b ; a s d f g h Location of the Buttons and Controls Become familiar with the b uttons and controls on your unit. Front Panel Powered Rolling Panel Press P ANEL OPEN/ CLOSE to open the panel.
– 4 – See pages in the parentheses for details. Front Panel 1 Disc trays 2 (On/Standby) button and ST ANDBY lamp (9) 3 Display windo w 4 For CA-MXJ750R: SUBWOOFER V OLUME control (10) For CA-MXJ552R/CA-MXJ550R/CA-MXJ500: A CTIVE BASS EX.
– 5 – When using the remote control, point it at the remote sensor on the front panel. Remote Control Remote Control 1 Disc number buttons (CD1, CD2, and CD3) (15) Pr essing one of these buttons also turns on the unit.
– 6 – Getting Started Unpacking After unpacking, check to be sure that you ha ve all the follo wing items. The number in the parentheses indicates the quantity of the pieces supplied. • AM (L W/MW) loop antenna (1) • FM antenna (1) • Remote control (1) • Batteries (2) If any is missing, consult your dealer immediately .
– 7 – 1 Connect the AM (L W/MW) loop antenna to the AM LOOP terminals as illustrated. 2 T urn the AM (L W/MW) loop antenna until y ou hav e the best reception. T o connect an outdoor AM (L W/MW) antenna When reception is poor , connect a single vinyl-covered wir e to the AM EXT terminal and extend it horizontally .
– 8 – For playing the other equipment thr ough this unit, connect between the audio output jacks on the other equipment and A UX jacks by using audio cords (not supplied). T o audio output T o start the display demonstration manually Press and hold DEMO f or more than 2 seconds.
– 9 – Common Operations T urning On or Off the Power T o tur n on the unit, press so that the ST ANDBY lamp goes off. The Po wered Rolling Panel opens automatically . T o tur n off the unit (on standby), press again so that the ST ANDBY lamp lights up.
– 10 – When using the remote control, press SUBWOOFER + to increase the subwoofer v olume or press SUBWOOFER – to decrease it. For CA-MXJ552R/CA-MXJ550R/CA-MXJ500 The ACTIVE B ASS EX. (e xtension) LEVEL control provided for this unit can maintain the richness and fullness of the bass sound while listening to any source at lo w volume.
– 11 – Surround modes * : D.CLUB : Increases resonance and bass. HALL : Adds depth and brilliance to the sound. ST ADIUM : Adds clarity and spreads the sound, like in an outdoor stadium. SEA (Sound Effect Amplifier) modes: R OCK : Boosts lo w and high frequency .
– 12 – Listening to FM and AM (L W/MW) Broadcasts T uning in a Station 1 Pr ess FM/AM. The unit automatically turns on and tunes in the previously tuned sta tion (either FM or AM — L W/MW). The Po w er ed Rolling Panel automatically opens. • Each time you press the button, the band alternates between FM and AM (L W/MW).
– 13 – Receiving FM Stations with RDS This section is f or the model having RDS functions — that is CA-MXJ750R, CA-MXJ552R, and CA- MXJ550R. RDS allows FM stations to send an additional signal along with their regular progr am signals.
– 14 – Switching to a Program T ype of Y our Choice T emporarily By recei ving EON data sent by FM RDS stations, the EON function allo ws the unit to switch temporarily to a broadcast program of your choice (T A, NEWS, and INFO) from a dif ferent station.
– 15 – Playing Back CDs Loading CDs On the unit ONL Y : 1 Pr ess 0 for the disc tray (CD1 to 3) y ou want to load a CD onto. The unit automatically turns on and the disc tray comes out. T he Powered Rolling Panel also opens automatically . 2 Place a disc correctl y on the circle of the disc tray , with its label side up.
– 16 – T o locate a particular point in a track During play , press and hold 1 or ¡ . • 1 : Fast re verses the disc. • ¡ : Fast forw ards the disc. When using the remote control, press and hold 1 / 4 or ¢ / ¡ . T o go to another track Press 4 or ¢ repeatedly before or during playback.
– 17 – T o stop during play , press 7 . • Random play also stops when one of the disc trays is opened. T o exit fr om Random play mode, press PROGRAM/ RANDOM repeatedly again before or after play so that the unit enters another play mode.
– 18 – Playing Back T apes Y ou can play back type I, type II, and type IV tapes without changing any settings. Playing Back a T ape 1 Pr ess EJECT ( 0 ) for the deck y ou want to use. 2 Put a cassette in, with the exposed part of the tape down. 3 Close the cassette holder gently .
– 19 – Recording Recording a T ape on Deck B 1 Press EJECT 0 f or the deck B. 2 Put in a recordab le cassette, with the exposed part of the tape down. 3 Close the cassette holder gently . 4 Check the tape direction of deck B. • If the tape direction is not correct, press T APE 2 3 twice then 7 to change the tape direction.
– 20 – CD Direct Recording Everything on the CD goes onto the tape in the order it is on the CD, or according to the order you hav e made for Program play . 1 Put a recordable cassette into deck B. 2 Place a disc correctl y on the circle of the disc tray , with its label side up.
– 21 – Auto Edit Recording By using Auto Edit Recording, you can record the CD tracks to f it the tape. Auto Edit Recording makes a program by selecting the CD tracks in numerical order . Howe ver , to prev ent the end of the last track on the front side from being cut off , the last track is selected so as to fit on the remaining tape length.
– 22 – Using the T imers There are three timers av ailable — Recording T imer, Daily T imer , and Sleep T imer . Before using the timers, you need to set the clock built in the unit. (See page 9.) Using Daily Timer W ith Daily T imer , you can wake to your fa vorite music or radio program.
– 23 – DAILY Canceled ON TIME ON TIME Clock setting (See page 9.) REC 6 When selecting “– CD – –” 1) Press 4 or ¢ to select the disc number , then press SET . 2) Press 4 or ¢ to set the track number , then press SET . The unit enters volume setting mode.
– 24 – Using Sleep T imer W ith Sleep T imer , you can fall asleep to music. Y ou can set Sleep T imer when the unit is turned on. How Sleep Timer actually works The unit automatically turns of f after the specified time length passes. On the r emote control ONL Y : 1 Press SLEEP .
– 25 – Maintenance T o get the best performance of the unit, keep your discs, tapes, and mechanism clean. Handling cassette tapes • If the tape is loose in its cassette, take up the slack by inserting a pencil in one of the reels and rotating. • If the tape is loose, it may get stretched, cut, or caught in the cassette.
– 26 – If you are ha ving a pr oblem with y our unit, chec k this list for a possible solution befor e calling for service. If you cannot solve the problem from the hints gi ven here, or the unit has been physically damaged, call a qualif ied person, such as your dealer , for service.
– 27 – Classification of the PTY codes for some FM stations may be different fr om the above list. Description of the PTY codes: NEWS :N e w s . AFF AIRS : T opical program expanding or enlar ging upon the news — debate, or analysis. INFO : Program the purpose of which is to impart advice in the widest sense.
– 28 – Specifications CA-MXJ750R Amplifier section Output Po w er (IEC 268-3/DIN) SUBWOOFERS: 65 W per channel, min. RMS, both channels dri ven into 6 Ω at 63 Hz with no more than 0.9% total harmonic distortion. MAIN SPEAKERS: 20 W per c hannel, min.
VICTOR COMP ANY OF JAP AN , LIMITED EN J V C 0100MWMMDWJEM Cover-CA-MXJ500,etc[B]/f 00.1.10, 2:06 PM 4.
Ein wichtiger Punkt beim Kauf des Geräts JVC CA-MXJ50 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie JVC CA-MXJ50 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für JVC CA-MXJ50 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von JVC CA-MXJ50 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über JVC CA-MXJ50 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon JVC CA-MXJ50 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von JVC CA-MXJ50 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit JVC CA-MXJ50. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei JVC CA-MXJ50 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.