Benutzeranleitung / Produktwartung 0403MNMCREJEM des Produzenten JVC
Zur Seite of 34
COMP A CT COMPONENT SYSTEM For Customer Use: Enter below the Model No . and Serial No. which are located either on the rear , bot- tom or side of the cabinet. Retain this information for future r eference. M o d e l N o. S e r i a l N o. INSTR UCTIONS L VT1041-002 A [B] FS-X5 Consists of CA-FSX5 and SP-FSX5 SP-FSX5 CA-FSX5 SP-FSX5 FS-X5(B)_E.
G-1 W arnings, Cautions and Others IMPORT A NT fo r the U.K. DO NO T cut off the mains plug from this equipment. If the plug fitted is not suitable for the po wer points in your home or the cable is too short to reach a power point, then obtain an appropriate safety appro ved e xtension lead or consult your dealer .
G-2 SAFETY INSTR UCTIONS “ SOME DOS AND DON ’ TS ON THE SAFE USE OF EQUIPMENT ” This equipment has been disig ned and manuf actured to me et internation al saf ety standard s but, lik e any electrical equipment, care must be taken if y o u are to obtain the best results and safety is to be assured.
1 Introduction Thank you for purchasing the JVC Compact Component System. We hope it will be a valued addition to your home, giving you years of enjoyment. Be sure to read this instruction manual carefully befo re operating your new stereo system. In it you will find all the information you need to set up and use the system.
2 Table of Contents Introduction ... ................................................................ ..................................... 1 Features ............. ................. ................ ................. ................. ...............
Table of Contents 3 Setting the SLEEP Timer ................. ................. ................ ................. .................... ................. .2 7 Timer Priority ......... ................. ................. ................. .............
4 Getting Started Accessories Make sure that you have all of the following items, which are supplied with the System. FM Wire Antenna (1) AM (MW) Loop Antenna (1) Remote Control (1) Batteries (2) Speaker Cords (4) If any of these items are missing, contact your dealer immediately.
5 Getting Started CAUTI ON: • Make all connecti ons before plugging the Syst em into an AC power outlet. Connecting the FM Antenna Rear Panel of the Center Unit (CA-FSX5) Using the Supplied Wire Antenna • Fasten it up in the position until you ha ve the best reception.
6 Getting Started Connecting the AM (MW) Antenna Rear Panel of the Center Unit (CA-FSX5) • If the AM (MW) loop antenna wire is covered with vinyl, remove the vinyl by twisting it as shown in the diagram. • Make sure the antenna conductors do not t ouch any other terminals, connecting cords and power cord.
7 Getting Started Connecting the Speakers (SP-FSX5) These speakers are exclusively for this system . Using with other devices will damage the speakers. Connect the speaker cords between the speaker terminals of the Unit and those of the Speakers. • When inserting the speaker wire lead, open the speaker terminal.
8 Getting Started Connecting an External Equipment Connect signal cord s (not supplied) between the System ’ s LINE IN/OUT terminals and the o utput/input terminals of the ex- ternal MD recorder, tape deck, etc. (For the details of connection, please refer to the user ’ s manual of the external equipment.
9 Basic Operations Turning the Power On and Off Turning the System On Press the STANDBY/ON button. The display comes on and “ HELLO ” is displayed once. The STANDBY/ON indicator lights in green . The System comes on ready to continue in the mode it was in when the power was last turned off.
10 Basic Operations Adjusting the Bright ness (DIMMER - at Power On) You can adjust the brightness of the display. When the System is Turned On At power on, each time you press the DIMMER button on th.
11 Basic Operations Tone Control (BASS/TREBLE) You can control the tone by changing the bass (low frequen- cy) and treble (high frequency). On the Remote Control 1 Press the B ASS/TREBLE button. Each time you press the button, the Tone Control mode changes as follows.
12 Using the Tuner You can listen to FM and AM (MW) stations. Stations can be tuned in manually, automatically, or from preset memory storage. ❑ Before listening to the radio: • Make sure that both the FM and AM (MW) antennas are correctly connected.
13 Using the Tune r Presetting Stations You can preset up to 30 FM stations and up to 15 AM (MW) stations. • Preset numbers may have been set to factory test fre- quencies prior to shipment. This is not a malfunction. You can preset the stations you want in to memory by following one of the presetting methods below.
14 Using the Tuner Receiving FM Stations with RD S You can use the RDS (Radio Data System) by using the but- tons on the Remote Control. RDS allows FM stations to send additional signals with their regular program signals.
15 Using the Tune r To continue searching after the first stop, press the PTY SEARCH button again while the display indications blink. If no program is found, “ NOT FOUND ” appears on the dis- play, and the Unit returns to the l ast received station.
16 Using the Tuner Case 1: If there is no station broadcasting the program type you have selected The broadcast station being currently heard will continue to be heard. « When a station starts broadcasting the progr am you have se- lected, this Unit aut omatically switches to the stati on.
17 Using the CD Player You can use Normal, Random, Program or Repeat Play. Re- peat Play can repeat all the tracks or just one of the tracks on the CD. Here are the basic things you need to know to play a CD and locate the different tracks on it. This Unit has been designed only to playback the fo llow- ing CDs.
18 Using the CD Player ❑ You can insert a CD while listening to the other source. • Howe ver , while the CD door is operating (opening or closing), the other source will be muted. CAUTI ON: • DO NOT try to open or close the CD door by hands as it will be damaged.
19 Using the CD Player 5 Press the Numeric Keys to enter the track n umber you want to pr ogram (See page 11). The program order number will be assigned from “ 1 ” , if nothing is programmed yet. Example: • T o dele te the last e ntry , press the C ANCEL butt on.
20 Using the CD Player Repeating Tracks You can repeat all tracks or individual track, as many times as you like. During playback or in Stop mode, press the RE- PEAT button on the Remote Contro l. Each time you press the button, the Repeat mode and Re- peat indicator c hange as follows.
21 Using External Equipments Listening to External Equipment You can listen to the external equipment such as M D re- corder, tape deck or other auxiliary. ❑ First make sure that the external equipment is properly connected to the System. (See page 8).
22 Using External Equi pments Recording the System ’ s Source to External Equipment You can record t he System ’ s source to external equipment which is connected to the LINE OUT or OPTICAL DIGI- TAL OUT termin al of the System, such as ta pe deck or MD recorder, etc.
23 Using the Timers The timers let you control listening functions automatically. Two types of timers are available: DAILY Timer Use this timer to se t wake up everyday to music from any source, including melodies. SLEEP Timer Fall asleep and have your System turn off automatically after a certain length of time.
24 Using the Timers 3 Press the SET button. The minute digits of the time in dication blink on the dis- play. • To return to the hour setting, press the CANCEL button. 4 Press the 3 or 2 button to set the minute. 5 Press the SET button. “ ADJUST OK! ” appears on the display.
25 Using the Timers On the Remote Control 1 Press the CLOCK/TI MER button repeat- edly until “ ON (time) ” appears on the display. At this time, “ DAILY ” indicator blinks on the display. Each time you press the button, the display changes as follows.
26 Using the Timers 5 Setting the volume level. Press the 3 or 2 button to select the vo lume level (VOLUME 1-50), then press the SET button. 6 Select the FADE function. Press the 3 or 2 button to select either “ FADE ” (fades in at power on) or “ NoFADE ” (does not fade in).
27 Using the Timers Setting the SLEEP Timer Use the Sleep Time r to turn the System off after a certain number of minutes when i t is playing. By setting the Sleep Timer, you can fall asleep to music and know that your Sys- tem will turn off by itself rather than play all night.
28 Troubleshooting • If you are having a problem with your System, check this list for a possible solution before calling for service. • If you cannot solve the problem from the hints giv en here “ ERR OR! ” appears on the display , or the System has been phys- ically damaged, call a qualified person, such as your dealer , for service.
29 Care And Maintenance Handle your CDs carefully, and they will last a long time. Compact Discs CAUTI ON: • Do not use any sol vent (for example, con- ventional reco rd cleaner, spray thi nner, benzine, etc.) to cle an a CD. General Notes In general, you will have the best perfor mance by keeping your CDs and the mechanism clea n.
30 Specifications CA-FSX5 Amplifier Output Power Main :60 W (30 W + 30 W) at 4 Ω (1 kHz 10% THD) Sub :60 W (30 W + 30 W) at 4 Ω (80 Hz 10% THD) Input Sensitivity/Impedance (1 kHz) LINE IN :210 mV/51 k Ω (LEVEL 1) 520 mV/51 k Ω (LEVEL 2 ) Output Sensitivity/ Impedance (1 kHz) LINE OUT :600 mV/5.
VICT OR COMP ANY OF JAP AN, LIMITED EN 0403MNMCREJEM © 2003 VICT OR COMP ANY OF JAP AN, LIMITED FS-X5(B)_E.book Page 31 Friday, March 28 , 2003 2:49 PM.
Ein wichtiger Punkt beim Kauf des Geräts JVC 0403MNMCREJEM (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie JVC 0403MNMCREJEM noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für JVC 0403MNMCREJEM - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von JVC 0403MNMCREJEM reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über JVC 0403MNMCREJEM erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon JVC 0403MNMCREJEM besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von JVC 0403MNMCREJEM verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit JVC 0403MNMCREJEM. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei JVC 0403MNMCREJEM gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
