Benutzeranleitung / Produktwartung FC285H des Produzenten Fantom Vacuum
Zur Seite of 19
REPLACEMENT P ARTS IMPORT ANT SAFETY INSTRUCTIONS NAMES OF EACH P ART PREPARA TION BEFORE USE USING THE VACUUM CLEANER USING THE A TTACHMENTS EMPTYING THE DUST COMP ARTMENT CLEANING THE FILTERS CLEARI.
IMPORT ANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following. READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER WARNING - T o reduce the risk of fire, electric shock or injury: 1.
2 16. Do not touch the agitator while it is spinning. 17. Do not place any heavy items on top of the vacuum cleaner. 18. Do not step on the hose or pull it too strongly . 19. Do not pick up items such as pieces of waste paper or cloth which looks as though they may cause the hose to become blocked.
Plug shown in figure may diffe r from actual plug attached to unit for your a rea. NAMES OF EACH P ART W ARNING: Operate vacuum cleaner only at the voltage specified on name plate. FRONT REAR Set the O N/OFF switch to " ON " to light the headlight.
Handle Upholstery T ool & Dusting Brush Hose Cuff Suction Inlet Caution : Do not connect the power cord plug to the wall outlet until assembly is completed. Attaching the handle PREP ARA TIONS BEFORE USE Attaching th e suction hose A,B & a ttachments 1 2 Set the vacuum cleaner to the upright position.
PREP ARA TIONS BEFORE USE THERMAL SAFETY DEVICE IN MAIN BODY T o protect your vacuum cleaner motor from overheating, a thermal safety device has been built in.
Parallel position This position is used for cleaning under furniture. 6 ADJUSTING THE HANDLE Upright po sition The handle is normally locked in this position for storage or when using the attachments. Push the handle forward until it locks. The handle of this vacuum cleaner can be set to one of three positions -Upright, Normal, Parallel.
The suction force can be adjusted to several settings between " MIN " and " MAX ". Rug/Floor (T ools) SELECTOR EDGE CLEANING This vacuum cleaner is equipped with an " edge cleaning" functi on f or c leaning ca rpet edges near baseboards and stationary furniture.
Release Button B Attachment Clamp Caution: When using one of the attachments during cleaning, set the vacuum cleaner to the upright position. 1 2 3 USING THE A TT ACHMENTS Press the release button B to disconnect the handle from the vacuum cleaner . Remove the attachments from the vacuum cleaner.
USING THE A TT ACHMENTS 9 Hose Attachment Line up notches, push hose in till it clicks. Handle Hose Cuff Suction Inlet Suction Hose A The T urbo Brush is attached on the main body .
Projection Groove 1 1 2 3 2 4 1 2 Trapdoor Release Lever Dust Cup Knob Turn the dust cup knob several times in the direction shown(clockwise) to empty the dust compartment. EMPTYING THE DUST COMP ARTMENT Caution: Be sure to turn the ON/OFF switch to the "OFF" position and disconnect the power cord from the wall outlet before cleaning.
Remove the dust compartment.(refer to page 10) Clean the filter fins free of dirt with the forked end of cleaning utensil as shown. Prefilter Dust Compartment Ribs Main Filter 1 1 CLEANING THE FIL TERS 2 Set the dust compartment to the parallel position.
Bypass V alve (Inside) Caution: Be sure to turn the ON/OFF switch to the "OFF" position and disconnect Cleaning the agitator assembly 1 2 3 CLEARING BLOCKAGES AND CLEANING THE A GIT A T OR ASSEMBL Y the power cord from the wa ll outlet before clearing any blockages in the suction hose and cleaning th e agitator assembly .
Place a new flat belt onto the motor shaft and pulley. 1 2 3 4 5 REPLACEMENT INSTRUCTIONS Caution: Be sure to turn the O N/OFF swit ch to the"OFF" position and disconnect the po wer cord fro m the wall outlet before replacing an y of the parts be low .
Projection Groove 14 1 1 REPLACEMENT INSTRUCTIONS REMOVING THE BOTT OM PLA TE Set the vacuum cleaner to the parallel position and turn it over . REA TT ACHING THE BOTT OM PLA TE Insert the projection on the bottom plate into the groove on the nozzle housing and set the bottom plate in place.
Filter Cover HEP A Filter 2 2 1 1 Sub-Filter Air Inlet Cover Caution: Be sure that seal on the HEPA filter is inserted towards the inside of the vacuum cleaner. The filter cover should be correctly oriented when it is reattached. Do not reattach it upside down.
The filter sensor will go on even the contents still away from the MAX mark as vacuuming a large amount of fine dust. In this case, please clean the filters. (refer to page 1 1) If the suction force is becoming weak or when the cleaner is vacuuming noisily , the filter sensor will go on.
If there is a problem with the vacuum cleaner, carry out the following checks to find the cause. If the problem still persists after the checks have been made, do not use the vacuum cleaner to prevent the possibility of an accident occurring.
FAN TOM, 94 Main Mill Street, Door 16, Plattsburgh, N.Y . 12901 RETURN TO F ANTOM , 94 Main Mill Street, Door 16 , Plattsburgh , N.Y . 12901 OWNERSHIP REGISTRA TION CARD Please fill out and mail the product registration card wit hin ten (10) days of purchase.
Ein wichtiger Punkt beim Kauf des Geräts Fantom Vacuum FC285H (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Fantom Vacuum FC285H noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Fantom Vacuum FC285H - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Fantom Vacuum FC285H reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Fantom Vacuum FC285H erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Fantom Vacuum FC285H besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Fantom Vacuum FC285H verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Fantom Vacuum FC285H. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Fantom Vacuum FC285H gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
