Benutzeranleitung / Produktwartung 6601 Series des Produzenten Dixon
Zur Seite of 50
.
IMPORTANT - READ CAREFULLY The Dixon @ ZTR @ Mower is both easy and fun to operate. However, any power mower must be operated properly to be safe. It is not a toy or a recreational vehicle. Before you start to use the mower, read the operator's manu al carefully and become completely familiar with the controls.
Part No. 8946 September 1995 INDEX SAFETY ................................................................ Pages 1 - 6 WARRANTY POLICY ........................................... Pa ge 7 SPECIFICATIONS ................................................ Page 8 SEAT ADJUSTMENT .
SAFETY RIDING LAWNM OWERS, IF IMPROPERLY OPERATED, CAN CAUSE SERIOUS INJURY OR DEATH The most common causes of injury to the operator or bystander... Page 1.
SAFETY SAFETY SYMBOLS: SAFETY ALERT SYMBOL - When you see this symbol, BE ALERT to the potentia l for injury. Follow recommended safety precautions and safe operating practices. Danger indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
SAFE TY This cutting mower is capable of amputating hands and feet, and throwing objects. Failure to observe the following safety instructions could result in serious injury or death. GENER AL OPERATION: • Read, understand, and follow all instructions in the manu al and on the mower before starting.
SAFETY SLOPE OPER ATION: Slopes are a major factor related to loss - of - control and tip - over accidents, which can result in severe injury or death. All slopes require extra caution. If y ou cannot back up the slope or if you feel uneasy on it, do not mow it.
SAFETY CHILDREN: Tragic accidents can occur if the operator is not alert to the presence of children. Children are attracted to lawn mowers and the mowing activity. NEVER assume children will sta y where they were last seen. Be alert to avoid accidents.
SAFETY SERVICE: • Use extra care in handling gasoline and other fuels. They are flammable and vapors are explosive. Use only an approved container. Never remove gas cap or add fuel with the engine runnin g. Allow engine to cool before refueling. Do not smoke.
DIXON LIMITED WARRANTY POLICY -- HYDRO - GEA R MODELS This warranty policy applies to all HydroGear mowers or any 50" model, purchased on or after March 1,1990. WARRANTY: Dixon Warranty term is for a period of one (1) year from date of purchase or 400 hours of use, whichever occurs first.
SPECIFICATIONS Model ZTR 6601 CHASSIS: 1 1 GA - rectangular tube BODY: Two piece - made of rotational molded polyethylene. Front body con tains access panels for battery service and engine to mower deck belt removal. Rear body tilts up to allow service on the entire drive system.
SE AT ADJUSTMENT INSTRUCTIONS 1 . Place parking brake in ON position. (Pull brake lever up) 2. Raise and push seat assembly and upper body rearward. 3. Loosen two front seat adjus tment knobs, P/N 3978, and slide seat forward or backward to desired position.
CONTROLS Page 10.
CONTROLS PARKING BRAKE: The parking brake used on the Model ZTR 6601 is designed to hold the mower from moving and is not intended for use in stopping the mower while it is in motion. CAUTION En gage parking brake before starting engine. Do not leave engine running for extended periods of time without the parking brake engaged.
CONTROLS TO GO FORWARD: From neutral position, gently push both drive levers forward. To increase speed, move levers farther forward. TO GO BACKWARD: From neutral position, gently pull both drive levers toward you. TURNING: Turning is controlled by moving one drive lever slightly forward or rearward of the other.
CONTROLS BLADE DRIVE: Located on control panel, on operator's right. To engage th e mower blades, lift switch up lightly and push forward. To disengage blades, pull switch backward. Switch is clearly marked "on and off". CIRCUIT BREAKER: Located on control panel, on operator's right.
OPERATION INSTRUCTIONS The safe and successful operation of the Model ZTR 6601 will depend upon the operator h aving the correct knowledge of all controls used on the mower and making good judgements about the terrain to be mowed. NEVER allow anyone to operate the mower without complete knowledge of all controls and their functions.
OPERATION INSTRUCTIONS PARKING BRAKE SWITCH TEST: With parking brake in the OFF position, engine should not turn over or attempt to start when the key switch is moved to the start position.
OPERATION INSTRUCTIONS STARTING INSTRUCTIONS: Cold Engine 1. Push choke control lever fully forward. 2. Push throttle control lever to 1/2 setting. 3. Insert ignition key an d turn to "Start" position. When engine starts, release ignition key.
OPERATION INSTRUCTIONS STARTING INSTRUCTIONS: Engine has been operated. 1 . Move throttle control lever to 1/4 to 1/2 setting. 2. Insert ignition key and turn to "Start" position. When engine s tarts, release ignition key. Key will return to "Run" position.
OPERATION INSTRUCTIONS In order to achieve optimum cutting performance, please read and follow the tips listed below. Additional information can be found in the troubleshooting guide on page 35. CAUTION Be sure that deflector is prop erly installed on the discharge chute.
CARE AND MAINTENANCE This portion of the Model ZTR 6601 owners manual deals with normal service items which can be performed by the owner. Please remember that if you are in doubt as to the correct se.
CARE AND MAINTENANCE CUTTER BLADE MAINTENANCE: NOTE: Observe proper blade position prior to removal. 1. Safely raise front of mower. 2. Hold or block blade from turning. CAUTION Wear heavy, thick gloves when holding onto cutter blade, avoid the sharp edge of the blade.
CARE AND MAINTENANCE BELT TENSION ENGINE TO MOWER DECK BELT: No adjustment required. P/N 9758 Correct belt tension is maintained through a fixed engine location and a spring loaded idler system. A pulsing movement of the belt idler will be observed both during engagement of the electric blade clutch and actual operation of the mower deck.
CARE AND MAINTENANCE FUEL SHUT OFF VALVE: A fuel shut off valve is located at the bottom rear of each fuel tank. Always turn the valve to the "OFF" position when the mower is stored or not in use.
CARE AND MAINTENANCE REAR WHEELS: The rear wheels of the Model ZTR 6601 are of an "offset" center design to both compliment the articu lation of the mowing deck and to provide stability when mowing on sloped ground.
CARE AND MAINTENANCE LUBRICATION DRIVE SYST EM: The gears in the HydroGear gearbox are permanently lubricated using a special grease which completely eliminates the need for any type of maintenance. The HydroGear BDU - 10L Series 70 hydrostatic transmissions are serviced with any high quality 10 W30 mo tor oil.
CARE AND MAINTENANCE CAUTION HOT oil may cause burns. Allow engine to cool before draining oil. CHANGING THE ENGINE OIL: 1. The "snap lock" oil drain valve is located on the left side of the engine crankcase. 2. Place a suitable container under the drain valve.
CARE AND MAINTENANCE DECK LEVELING AND HEIGHT ADJUSTING PROCEDURE 1. On the right side of the machine^ the tie bar between the lift arms should be adjusted so there is 20 - 1/2" b etween clevis eyes. If adjustment is necessary, loosen jam nuts on both ends of the bar, and turn bar by hand until 20 - 1/2" dimension is achieved.
CARE AND MAINTENANCE DRIVE SYSTEM ADJUSTMENTS: Adjustment of the drive system is limited to the actual function of the hydro static transmissions as outlined below.
CARE AND MAINTENANCE PARKING BRAKE CABLE ADJUSTMENT: Position parking brake lever in the off or disengaged position. This will allow the belt idler used on the engine to T - box to swing fully and apply tension to the belt.
CARE AND MAINTENANCE NEUTRAL ADJUSTMENT: Swing upper control levers out into the neutral slots. Raise upper body to the fully open position. Start engine and disengage parking brake. Caution should be used when releasing parking brake as mower may tend to creep or move prior to adjustment.
CARE AND MAINTENANCE FORWARD TRAVEL SPEED ADJUSTMENTS: Stop e ngine, move levers to drive position, lightly push each upper control lever forward until a resistance is felt on the lever. At this time, check that the forward lever stops on the bottom of each lever are hitting the stop blocks.
CARE AND MAINTENANCE PROCEDURE FOR ELECTRIC CLUTCH ADJUSTMENT Electric clutches require periodic Air Gap adjustments to extend the life of the clutch. Listed below is both an Air Gap adjustment procedure and an Ohms test to check for a faulty coil within the clutch.
CARE AND MAINTENANCE HYDROSTATIC TRANSMISSION OIL AND FILTER SERVICE SERVICE INTERVALS: 1. Initial oil and filter service - 50 hours. 2. Every 250 hours thereafter. OIL REQUIREMENTS: Any high quality engine oil with an API classification of SG/CD is recommended.
CARE AND MAINTENANCE WHEELS AND TIRES: Correct tire pressure is important for correct operation of mower. Front Tires 11X4X5 Air Pressure 16 - 21 Ibs. Rear Tires 20 X 1 1 X 8 Air Pressure 5 Ibs. (maximum pressure) NOTE: Check lug nuts periodically for tightness.
STANDARD SERVICE PARTS LIST MODEL ZTR 6601: BLADES: Hi - Lift: P/N 9383 Engine To Mower Deck: Serpentine Belt: Engine To T - Box: T - Box To Hydros: P/N 9758 P/N 6939 P/N 1714 P/N 1765 Hydrostatic Tra.
TROUBLESHOOT ING MOWER CUT QUALITY: There are many variables that can effect the cut quality of any riding mower. Type and conditions of grass, cut height setting, engine RPM and ground speed are some of the variables that interact creating differences in cut quality.
TROUBLESHOOTING DRIVE SYSTEM: SITUATION Mower pulls to one side or the other CAUSES Drive adjustment RE MEDY Consult your dealer for repair Drive system will not function on either side after changing.
TROUBLESHOOTING ELECTRICAL SYSTEM: SITUATIO N CAUSES REMEDY Starter will not turn engine over Circuit breaker engaged Push button to reset Consult your dealer for repair Starter will not turn engine o.
Page 38.
Page 39.
Page 40.
Page 41.
Page 42.
Page 43.
Page 44.
NOTES.
DIXON INDUSTRIES, INC A BLOUNT COMPANY AIRPORT INDUSTRIAL PARK PO BOX 1569 COFFEYVILLE KS 67337 O945 316 251 2OOO FAX 316 251 4117 OWNER INFORMATION DATE PURCHASED MOWER MODEL NUMBER PURCHASED FROM MO.
The Engine Exhaust from this product contains chemicals kno wn to the state of California to cause cancer, birth defects or other reproductive harm. ® Dixon and ZTR are registered trademarks of Dixon Industries, Inc.
Ein wichtiger Punkt beim Kauf des Geräts Dixon 6601 Series (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Dixon 6601 Series noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Dixon 6601 Series - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Dixon 6601 Series reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Dixon 6601 Series erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Dixon 6601 Series besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Dixon 6601 Series verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Dixon 6601 Series. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Dixon 6601 Series gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
