Benutzeranleitung / Produktwartung PP09S des Produzenten Dell
Zur Seite of 37
Dell™Latitude™D430ServiceManual Notes, Notices, and Cautions Information in this document is subject to change without notice. © 2007DellInc.Allrightsreserved. ReproductioninanymannerwhatsoeverwithoutthewrittenpermissionofDellInc.
Back to Contents Page Battery Latches Dell™Latitude™D430 1. Follow the instructions in "BeforeYouBegin"onpage7 . 2. Remove any installed PC Cards from the PC Card slot. 3. Remove any installed memory modules or Mini PCI cards (see Memory and Mini - Cards ).
Back to Contents Page 1 screw driver 2 bracket 3 securing tab 4 shorter battery - latch assembly 5 computer base .
Back to Contents Page Before You Begin Dell™Latitude™D430 Recommended Tools Turning Off Your Computer Before Working Inside Your Computer This chapter provides procedures for removing and installing the components in your computer.
3. If the computer is connected to a docking device (docked), undock it. See the documentation that came with your docking device for instructions. 4. Disconnect all telephone or network cables from the computer. 5. Close the display and turn the computer upside down on a flat work surface.
Back to Contents Page Internal Card With Bluetooth ® Wireless Technology Dell™Latitude™D430 If you ordered an internal card with Bluetooth wireless technology with your computer, it is already installed. 1. Follow the procedures in "BeforeYouBegin"onpage7 .
Back to Contents Page PC Card/Smart Card Reader Dell™Latitude™D430 1. Follow the instructions in "BeforeYouBegin"onpage7 . 2. Remove any installed PC Cards from the PC Card slot. 3. Remove any installed memory modules or Mini PCI cards (see Memory and Mini - Cards ).
Back to Contents Page Coin - Cell Battery Dell™Latitude™D430 1. Follow the procedures in "BeforeYouBegin"onpage7 . 2. Remove the keyboard (see Keyboard ). 3. Disconnect the coin - cell battery cable connector from the system board connector.
Back to Contents Page Memory and Mini - Cards Dell™Latitude™D430 Memory Mini - Cards Memory You can increase your computer memory by installing memory modules on the system board. See "Specifications" in your computer User's Guide for information about the memory supported by your computer.
5. Ground yourself and install the new memory module: a. Align the notch in the module edge connector with the tab in the connector slot. b. Slide the module firmly into the slot at a 45 - degree angle, and rotate the module down until it clicks into place.
a. Disconnect the antenna cables from the WLAN card. b. Release the card by pushing the metal securing clips toward the back of the computer until the card pops up slightly. c. Lift the card out of its connector. 2. Install the WLAN card: a.
Mobile Broadband (WWAN) Cards If you ordered a Mobile Broadband card with your computer, the card is already installed. 1. If a Mobile Broadband card is not already installed, go to step 5. If you are replacing a Mobile Broadband card, remove the existing card: a.
b. Align the card with the connector at a 45 - degree angle, and press the card into the connector until you feel a click. c. Connect the white antenna cable with the black stripe to the conne.
Back to Contents Page 1 metal tabs (2) on SIM card slot 2 SIM card with cut - off corner NOTE: When you replace the SIM card, ensure that you slide the SIM card under the two metal tabs on the SIM card slot with the cut - off corner of the card facing toward the back of the computer.
Back to Contents Page Display Assembly Dell™Latitude™D430 Removing the Display Assembly Removing the Display Bezel Removing the Display Panel Removing the Display - Panel Brackets Removing the Display Cable Removing the Display Latch 1.
7. Lift the display assembly away from the computer. Removing the Display Bezel 1. Remove the six screw covers/bumpers and the six M2.5 x 4.2 - mm shoulder screws from the display bezel. 2. Use your fingers to carefully separate the display bezel from the top cover.
Removing the Display - Panel Brackets 1. Remove the four M2 x 3 - mm screws (two on each bracket) from the display - panel brackets. Removing the Display Cable 1 M2 x 3- mm screws (2) 2 di.
Removing the Display Latch Back to Contents Page 1 M2 x 3 - mm screws (2) 2 screw holders (2) 3 display latch 4 metal plate 5 display base .
Back to Contents Page Fan Dell™Latitude™D430 1. Follow the instructions in "BeforeYouBegin"onpage7 . 2. Remove any installed PC Cards from the PC Card slot. 3. Remove any installed memory modules or Mini PCI cards (see Memory and Mini - Cards ).
Back to Contents Page Flashing the BIOS Dell™Latitude™D430 1. Ensure that the AC adapter is plugged in and that the main battery is installed properly. 2. Insert the BIOS update program CD, and turn on the computer. Follow the instructions that appear on the screen.
Back to Contents Page Hard Drive Dell™Latitude™D430 Removing the Hard Drive Dismantling the Hard Drive Replacing the Hard Drive Removing the Hard Drive 1. Follow the procedures in "BeforeYouBegin"onpage7 .
Dismantling the Hard Drive 1. Use your fingers to carefully remove the protective cover from the hard drive. 2. Use a hard drive tool to carefully pry up the ZIF connector that holds the hard drive cable, and remove the cable.
Replacing the Hard Drive 1. Follow the steps in Removing the Hard Drive in reverse order. 2. Install the operating system for your computer (see "Restoring Your Operating System" in your computer User's Guide ).
Back to Contents Page Hinge Cover Dell™Latitude™D430 1. Follow the procedures in "BeforeYouBegin"onpage7 . 2. Open the display all the way (180 degrees) so that it rests on your work surface. 3. Starting on the right side of the computer, use a plastic scribe to pry up the hinge cover.
Back to Contents Page Keyboard Dell™Latitude™D430 1. Follow the procedures in "BeforeYouBegin"onpage7 . 2. Remove the hinge cover (see Hinge Cover ). 3. Remove the keyboard: a. Remove the three M2 x 3 - mm screws across the top of the keyboard.
Back to Contents Page Modem Dell™Latitude™D430 1. Follow the instructions in "BeforeYouBegin"onpage7 . 2. Remove any installed PC Cards from the PC Card slot. 3. Remove any installed memory modules or Mini PCI cards (see Memory and Mini - Cards ).
Back to Contents Page Palm Rest Dell™Latitude™D430 Removing the Palm Rest Replacing the Palm Rest Removing the Palm Rest 1. Follow the instructions in "BeforeYouBegin"onpage7 . 2. Remove any installed PC Cards from the PC Card slot.
11. Disconnect the speaker connector from the system board. 12. Disconnect the Secure Digital/SIM card reader cable from the system board. 13. Disconnect the touch pad cable from the system board. 14. Lift the plastic bar on the LED board connector and disconnect the LED board cable from the system board.
Replacing the Palm Rest 1. Align the palm rest with the computer base and gently snap into place. 2. Connect the LED board connector to the system board. 3. Connect the touch pad connector to the system board. 4. Connect the Secure Digital/SIM card reader cable connector to the system board.
Back to Contents Page Pin Assignments for I/O Connectors Dell™Latitude™D430 USB Connector Video Connector USB Connector Video Connector Back to Contents Page .
Back to Contents Page Power Button Assembly Dell™Latitude™D430 1. Follow the instructions in "BeforeYouBegin"onpage7 . 2. Remove any installed PC Cards from the PC Card slot. 3. Remove any installed memory modules or Mini PCI cards (see Memory and Mini - Cards ).
Back to Contents Page Suspend - Switch Sensor Board Dell™Latitude™D430 1. Follow the instructions in "BeforeYouBegin"onpage7 . 2. Remove any installed PC Cards from the PC Card slot. 3. Remove any installed memory modules or Mini PCI cards (see Memory and Mini - Cards ).
Back to Contents Page Wireless Switch Dell™Latitude™D430 1. Follow the instructions in "BeforeYouBegin"onpage7 . 2. Remove any installed PC Cards from the PC Card slot. 3. Remove any installed memory modules or Mini PCI cards (see Memory and Mini - Cards ).
Back to Contents Page Speaker Dell™Latitude™D430 1. Follow the instructions in "BeforeYouBegin"onpage7 . 2. Remove any installed PC Cards from the PC Card slot. 3. Remove any installed memory modules or Mini PCI cards (see Memory and Mini - Cards ).
Back to Contents Page System Board Dell™Latitude™D430 Removing the System Board Replacing the System Board Removing the System Board The system board's BIOS chip contains the Service Tag, which is also visible on a barcode label on the bottom of the computer.
Replacing the System Board 1. Follow all of the steps in Removing the System Board in reverse order. 2. Turn on the computer. 3. Insert the CD that accompanied the replacement system board into the appropriate drive. Follow the instructions that appear on the screen.
Back to Contents Page Dell™Latitude™D430 Notes, Notices, and Cautions Information in this document is subject to change without notice. © 2007DellInc.Allrightsreserved. ReproductioninanymannerwhatsoeverwithoutthewrittenpermissionofDellInc.
Ein wichtiger Punkt beim Kauf des Geräts Dell PP09S (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Dell PP09S noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Dell PP09S - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Dell PP09S reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Dell PP09S erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Dell PP09S besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Dell PP09S verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Dell PP09S. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Dell PP09S gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
