Benutzeranleitung / Produktwartung D630-3N28FD1 des Produzenten Dell
Zur Seite of 43
Dell™Latitude™D630ServiceManual Notes, Notices, and Cautions Information in this document is subject to change without notice. © 2007DellInc.Allrightsreserved. Reproduction in any manner whatsoever without the written permission of Dell Inc.
Back to Contents Page Before You Begin Dell™Latitude™D630ServiceManual Recommended Tools Turning Off Your Computer Before Working Inside Your Computer This section provides procedures for removing and installing the components in your computer.
1. Ensure that the work surface is flat and clean to prevent the computer cover from being scratched. 2. Save and close any open files, exit any open programs, then shut down the operating sys.
Back to Contents Page Flashing the BIOS Dell™Latitude™D630ServiceManual Flashing the BIOS From a CD Flashing the BIOS From the Hard Drive If a BIOS - update program CD is provided with the new system board, flash the BIOS from the CD.
Back to Contents Page Internal Card With Bluetooth ® Wireless Technology Dell™Latitude™D630ServiceManual If you ordered an internal card with Bluetooth wireless technology with your computer, it is already installed. To replace the internal card with Bluetooth wireless technology: 1.
6. Lift the card from the compartment, ensuring that you do not pull on the card cable with excessive force. 7. Disconnect the card from the cable and remove the card from the computer. 8. Connect the new card to the cable. 9. Rotate and slide the card under the metal securing tab.
Back to Contents Page PC Card Reader Dell™Latitude™D630ServiceManual 1. Follow the instructions in Before You Begin . 2. Remove any installed media bay device (see Media Bay Devices ). 3. Remove the hinge cover (see Hinge Cover ).
Back to Contents Page Coin - Cell Battery Dell™Latitude™D630ServiceManual To replace the coin - cell battery: 1. Follow the procedures in Before You Begin . 2. Remove the hinge cover (see Hinge Cover ). 3. Remove the keyboard (see Removing the Keyboard ).
Back to Contents Page Processor Dell™Latitude™D630ServiceManual Removing the Processor Installing the Processor Removing the Processor 1. Follow the instructions in Before You Begin . 2. Remove any installed media bay device (see Media Bay Devices ).
1. Align the pin - 1 corner of the processor so that it points to the triangle on the system board, and insert the processor into the ZIF socket. When the processor is correctly seated, all four corners are aligned at the same height. If one or more corners of the processor are higher than the others, the processor is not seated correctly.
Back to Contents Page Display Assembly Dell™Latitude™D630ServiceManual Removing the Display Assembly Removing the Display Bezel Removing the Display Panel .
10. From the back of the computer, remove the two M2.5 x 8 - mm screws. 11. From the bottom of the computer, remove the two M2.5 x 8 - mm screws labeled "D." 12. Turn the computer top - side up and open the display. 13. Lift the display assembly out of the computer base.
4. Remove the six M2.5 x 5 - mm shoulder screws from the front of the bezel. 5. Starting from the inside edges of the bezel, use your fingers to pry the bezel upward and outward from the display panel. Release the sides of the bezel next; if necessary, use a plastic scribe to release the corners of the bezel from the display panel.
5. Lift the display panel a few inches from the top cover. 6. Draw the display cable pull - tab away from the top cover to release the display cable, and lift the display panel fully from the top cover. Removing the Display Panel Brackets 1.
Removing the Display Hinges 1. Follow the instructions in Before You Begin . 2. Remove the display assembly (see Display Assembly ). 3. Remove the display bezel (see Removing the Display Bezel ). 4. Remove the display panel (see Removing the Display Panel ).
Back to Contents Page Fan Dell™Latitude™D630ServiceManual 1. Follow the instructions in Before You Begin . 2. Remove the system board (see Removing the System Board ). 3. Remove the M2.5 x 5 - mm screw that secures the fan to the base.
Back to Contents Page Hard Drive Dell™Latitude™D630ServiceManual To replace the hard drive in the hard drive bay: 1. Follow the procedures in Before You Begin . 2. Turn the computer over, and remove the two hard - drive screws.
Back to Contents Page Hinge Cover Dell™Latitude™D630ServiceManual 1. Follow the procedures in Before You Begin . 2. Open the display all the way (180 degrees) so that the display rests flat on your work surface.
Back to Contents Page Keyboard Dell™Latitude™D630ServiceManual Removing the Keyboard Replacing the Keyboard Removing the Keyboard 1. Follow the instructions in Before You Begin . 2. Remove the hinge cover (see Hinge Cover ).
1. Connect the keyboard connector to the system board. 2. Fold the pull - tab down and secure it and the keyboard cable underneath the locking arm before locking it in place. 3. Place the tabs along the front edge of the keyboard into the palm rest and lay the keyboard down on the palm rest, pressing the sides down into the detents.
Back to Contents Page Memory Dell™Latitude™D630ServiceManual DIMM A DIMM B Your computer has two user - accessible SODIMM sockets, one accessed from beneath the keyboard (DIMM A), and the other accessed from the bottom of the computer (DIMM B).
5. Ground yourself and install the new memory module: a. Align the notch in the module edge connector with the tab in the connector slot. b. Slide the module firmly into the slot at a 45 - degree angle, and rotate the module down until it clicks into place.
4. Ground yourself and install the new memory module: a. Align the notch in the module edge connector with the tab in the connector slot. b. Slide the module firmly into the slot at a 45 - degree angle, and rotate the module down until it clicks into place.
Back to Contents Page Communications Cards Dell™Latitude™D630ServiceManual Wireless Local Area Network (WLAN) Card Mobile Broadband Network (WWAN) Card Subscri.
5. To install a WLAN card: a. Move any antenna cables out of the way to make space for the WLAN card. b. Insert the WLAN card into the system board connector at a 45 - degree angle, and press the card into the metal securing tabs until you feel a click.
If you ordered a Mobile Broadband network card with your computer, the card is already installed. 1. Follow the procedures in Before You Begin . 2. Remove the hinge cover (see Hinge Cover ). 3. Remove the keyboard (see Removing the Keyboard ).
a. Move any antenna cables out of the way to make space for the Mobile Broadband network card. b. Insert the card into the system board connector at a 45 - degree angle, and press the card into the metal securing tabs until you feel a click. c.
the metal bracket on the sides. 4. Install the coin - cell battery (see Coin - Cell Battery ). FCM (Flash Cache Module) The FCM, or Flash Cache Module, is an internal flash drive that helps improve the performance of your computer. 1. Follow the procedures in Before You Begin .
8. Align the new FCM card with the connector at a 45 degree angle, and then press the card into the connector until it clicks. 9. Reconnect the antenna cables to the top of the FCM card. 10. Replace the keyboard (see Replacing the Keyboard ).
Back to Contents Page Modem Dell™Latitude™D630ServiceManual 1. Follow the instructions in Before You Begin . 2. Remove any installed media bay device (see Media Bay Devices ). 3. Remove the hinge cover (see Hinge Cover ).
Back to Contents Page Media Bay Devices Dell™Latitude™D630ServiceManual 1. If present, remove the device locking screw from the bottom of the computer. 2. If the computer is running, double - click the Safely Remove Hardware icon on the taskbar, click the device you want to eject, and then click Stop .
Back to Contents Page Palm Rest Dell™Latitude™D630ServiceManual 1. Follow the instructions in Before You Begin . 2. Remove any installed media bay device (see Media Bay Devices ). 3. Remove the hinge cover (see Hinge Cover ).
11. Turn the computer top - side up and remove the palm rest. a. Starting at the back center of the palm rest, use your fingers to separate the palm rest from the base by lifting the inside edge of the palm rest.
Back to Contents Page Using Cards Dell™Latitude™D630ServiceManual Card Types Removing a PC Card or Blank Installing a PC Card or an ExpressCard Removing.
Press the release latch and remove the card or blank. For some release latches, you must press the latch twice: once to pop the latch out, and then a second time to pop the card out. Save a blank to use when no PC Card is installed in a slot. Blanks protect unused slots from dust and other particles.
Removing a Smart Card Grasp the smart card by the edge with your fingers, and then pull the card straight out of the computer. Installing a Smart Card You can install a smart card in the computer while the computer is running. The computer automatically detects the card.
If you encounter too much resistance, do not force the card. Check the card orientation and try again. Back to Contents Page 1 smart card blank .
Back to Contents Page Speaker Dell™Latitude™D630ServiceManual 1. Follow the instructions in Before You Begin . 2. Remove any installed media bay device (see Media Bay Devices ). 3. Remove the hinge cover (see Hinge Cover ).
Back to Contents Page System Board Dell™Latitude™D630ServiceManual Removing the System Board Installing the System Board Removing the System Board The system board's BIOS chip contains the Service Tag, which is also visible on a barcode label on the bottom of the computer.
17. Remove the four 5 - mm hex screws on the back of the computer. 18. Lift the system board out and away from the base. Installing the System Board 1. Perform all the steps in Removing the System Board in reverse order. 2. Replace the battery (see Before Working Inside Your Computer ).
Back to Contents Page Processor Thermal - Cooling Assembly Dell™Latitude™D630ServiceManual Removing the Processor Thermal - Cooling Assembly Replacing the Processor Thermal - Cooling Assembly Removing the Processor Thermal - Cooling Assembly 1.
2. Place the assembly on the system board. 3. Tighten in consecutive order the four captive screws, labeled "1" through "4," on the thermal - cooling assembly. 4. Replace the palm rest (see Palm Rest ). 5. Replace the keyboard (see Replacing the Keyboard ).
Back to Contents Page Dell™Latitude™D630ServiceManual Information in this document is subject to change without notice. © 2007DellInc.Allrightsreserved. Reproduction in any manner whatsoever without the written permission of Dell Inc.
Ein wichtiger Punkt beim Kauf des Geräts Dell D630-3N28FD1 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Dell D630-3N28FD1 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Dell D630-3N28FD1 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Dell D630-3N28FD1 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Dell D630-3N28FD1 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Dell D630-3N28FD1 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Dell D630-3N28FD1 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Dell D630-3N28FD1. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Dell D630-3N28FD1 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
