Benutzeranleitung / Produktwartung 247.79452 des Produzenten Craftsman
Zur Seite of 27
Owner's Manual 33 Ton Hydraulic Log Splitter Model Nos. 247.794520 CAUTION: Before using this product, read this manual and follow all safety rules and operating instructions. • Safety • Assembly • Operation • Service • Maintenance • Espa5ol Sears, Roebuck And Co.
Content Page Warranty Information ......................................... 2 Safe Operation Practices ................................... 3 Accessories ....................................................... 6 Assembly ...............................
This symbol points out important safety instructions which, if not followed, could endanger the per- sonal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate your log splitter. Failure to comply with these instructions may result in personal injury.
the control until the helper is clear of the area, More accidents occur when more than one person operates the log splitter than at any other time, No one should operate this unit while intoxicated or while taking medication that impairs the senses or reactions.
For logs that are not cut square, the longest portion of the log should be rotated down and the most square end placed against the splitting wedge. Keep your work area clean. Immediately remove split wood around your splitter so that you do not stumble over it.
Make certain pump is mounted and aligned properly Use a flexible "spider" type coupling between engine and pump drive shafts Keep hoses clear and unblocked Bleed air out of hoses before oper.
IMPORTANT: This unit is shipped without gasoline in the engine. After assembly, see OPERATION section of this manual for proper fuel fill-up. Tools and Other Items Required Crowbar or large screwdrive.
upright position. Release spring lever. See Figure 4, Spring Lever Jack Stand Lower the beam assembly to its horizontal position. Make certain the beam is locked securely with the horizontal beam lock. See Figure 5. Pull the log splitter off the pallet.
Know Your Log Splitter Read this owner's manual and safety rules before operating your log splitter. Compare the illustrations on this page with your equipment to familiarize yourself with the location of various controls and adjustments. Save this manual for future reference.
OPERATING CONTROLS (See Figure 6.) WARNING: Before using your log splitter, again refer to the safety rules on pages 3-6 of this manual. Always be careful, Do not operate the log splitter without the proper amount of hydraulic oil in the reservoir tank.
• Make sure the spark plug wire is disconnected. Prime the pump by pulling the recoil starter as far as it will go. Repeat approximately 10 times. • Reconnect the spark plug wire and start engine. • Use the control handle to engage the wedge to the far extended position.
Tolower the beam, pull out the beam lock on the reservoir tank and pivot it down to release the beam. Carefully pull back on beam and lower it to the horizontal position. See Figure 10. Pull out the beam lock on the tongue, pivot it upwards and release it to hold the beam.
Maintenance Schedule //Fill in service dates here Check reservoir fluid " 4 0 Changehydraulic fluid "_ Change hydraulicfilter a. Lubricate beam and wedge Check engine oil Change engine oil _ W Serviceaircleaner foam filter "-- I_ Service air cleaner paper filter C g.
However, normal wear will occur. Periodically adjust the bolts on the side of the wedge plate as follows to eliminate excess space between the wedge plate and the beam. Loosen the lock nuts on the two adjustment bolts on the side of the gib plate, located beneath the splitting wedge.
• Tighten wing nut securely. Clean engine Clean engine periodically. Remove dirt and debris with a cloth or brush. Cleaning with a forceful spray of water is not recommended as water could contaminate the fuel system. Frequently remove grass clippings, dirt and debris from cooling fins, air intake screen and levers and linkages.
spider fails completely, you will experience a loss of power. ,_ WARNING: Never hit the engine shaft in any manner, as a blow will cause permanent damage to the engine or the pump. Follow the instructions carefully as the alignment of the couplings is critical.
Prepare your log splitter for storage at the end of the season or if the log splitter will not be used for 30 days or more. WARNING: Never store machine with fuel in the fuel tank inside of building w.
Problem Cylinder rod will not move Cylinder shaft speed slow while extending end retracting Engine runs but wood will not sprit, or splits too slowly Engine stalls during splitting wood Engine will not tum or stalls under low load Leaking pump shaft seal Possible Cause 1.
Trouble-Shooting Guide continued Problem Possible Causes Engine failsto start 1. Dirty air cleaner. 2. Fuel tank empty, or stale fuel. 3. Choke not in ON position. 4. Blocked fuel line. 5. Spark plug wire disconnected. Corrective Action 1. Service air cleaner following instruction_ on page 14 of thismanual.
Craftsman 9 H.P. Log Splitter Model 247.794520 22 23 24 _ 25 43 42 44 21 2O 8 17 13 14 B_627 6 58 3_ 33 38 18 / 47 59 ; 60 61 48 / 49 _.62 64 65 / /66 96 ,< / " 45 46 86 / 7! 82 69 ?8 82 2O.
Craftsman 9 H.P, Log Splitter Model 247.794520 KEY NO. 5 6 7 6 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 3O 31 32 33 34 35 36 37 38 39 4O 41 42 43 44 45 46 47 PART NO.
Craftsman 9 H.P. Horizontal Shaft Engine Model No. 143.999003 forCraftsman Log Splitter Model 247.794520 75 / 3o 87 70 6g I 172,, 224, 173 240 _325 .110 / 245 370G,_r_ _ / I_ 250 245A 276 251 25 26 28.
Craftsman 9 H.P. Horizontal Shaft Engine Model No. 143,999003 for Craftsman Log Splitter Model 247.794520 Key Part No. Description Qty. Key Part No. Description No. No. 0 RPM Low 1700 75 35319 Oil Seal 0 RPM High 3450 to 3750 80 31845 Governor Shaft 1 35385 Cylinder (Incl.
Craftsman 9 H.P. Horizontal Shaft Engine Model No. 143.999003 for Craftsman Log Splitter Model 247.794520 Key No. 178 182 184 185 186 200 2o3 204 206 207 209 215 223 224 238 239 24o 242 245 245A 25O 251 260 261 262 264A 265 275 276 277 277A 278 Part No.
Craftsman 9 H.P. Horizontal Shaft Engine Model No. 143.999003 for Craftsman Log Splitter Model 247.794520 Key Part No. Description Qty. No. 0 640112 1 1 631776A 2 631970 _i1_ 4 631184 7 / 5 631183 / "_', 6 640109 / 18_ / / .
Craftsman 9 H.P. Horizontal Shaft Engine Model No, 143,999003 for Craftsman Log Splitter Model 247.794520 12 8 J 6 / _6 _'_5 _'2 -11 Key No. Part No. Description 1 2 3 4 5 6 7 8 11 12 13 590704 590599A $96600 590696 590601 590697 590698 590699 590700 590705 590535 590701 Recoil Starter Spring Pin (Incl.
In U.S.A. or Canada for in-home major brand repair service: Call 24 hours a day, 7 days a week 1-800-4-MY-HOME sM (1-800"469-4663) Pare pedir servicio de reparaci6n a domicillio -- 1-800-676-5811 Au Canada pour tout le service ou les pi_ces -- 1-800-469-4663 For the repair or replacement parts you need: Call 6 a.
Ein wichtiger Punkt beim Kauf des Geräts Craftsman 247.79452 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Craftsman 247.79452 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Craftsman 247.79452 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Craftsman 247.79452 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Craftsman 247.79452 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Craftsman 247.79452 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Craftsman 247.79452 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Craftsman 247.79452. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Craftsman 247.79452 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
