Benutzeranleitung / Produktwartung 5100 LP des Produzenten Coleman
Zur Seite of 36
Gas Barbecue Use, Car e & Assembly Manual W ith Grill Lighting Instructions 5100 LP Gas Series 5110 Natural Gas Series ASSEMBLER/INST ALLER: Leave these instructions with the consumer . CONSUMER/USER: Read all these instructions and keep them in a safe place for future r eference.
2 DANGER • FOR OUTDOOR USE ONL Y . NEVER operate grill in enclosed areas, as this could lead to gas accumulating from a leak, causing an explosion or a carbon monoxide buildup which could result in injury or death. DO NOT use in garages, breezeways, sheds or any enclosed area.
3 1 3 2 24 " 8 7 36" (90cm) 36" (90cm) 36" (90cm) Clear REPRESENT A TIVE ILLUSTRA TION • Installation must conform with local codes or , in the absence of local codes, with either the National Fuel Gas Code, ANSI Z223.1 (USA), CAN/CGA-B149.
4 Longer detachable power-supply cords or extension cords must be used with care. The marked electrical rating of the cord set or extension cord must be at least as great as the electrical rating of the appliance. If the appliance is of the grounded type, the exten- sion cord should be a grounding-type 3-wire cord.
5 DANGER • DO NOT insert any foreign object s into the valve outlet. Y ou may damage the valve. A damaged valve can cause a leak, which could result in explosion, fire, severe per- sonal injury or death.
6 W ARNING Handle a full cylinder with care. Gas is under high pressure. DANGER • NEVER store a spare L.P . gas supply cylinder under the grill body or inside grill enclosure or in the vicinity of any heat producing appliance. (Fig. 12) • NEVER fill the cylinder beyond 80% full.
Assembly/Set up ■ Remove components from p ackage. 7 Firebox Side Burner Rear Support Rear T rim Plate Side Burner Grate Right Side T able Left Side Burner T able Grates Burner Heat T ents™ Base T.
1-A . Arrange the two panels and the base on the ground as shown. Ö Ö LOOSEL Y assemble the Right Panel and the Left Panel to the Grill Base using one screw (TN) in each top corner . Ö Ö NOTE: Use a large piece of cardboard or a ground cloth to protect the painted finish on the grill.
Ö Ö Carefully turn the assembly up-side-down to perform Step 2. This will give easy access to assemble the parts in Step 2. 2-A . Carefully turn the grill Up-Side-Down. 2-A Base (up-side-down) 2-B . Assemble eight additional screws (TN) to fasten the Side Panels to the base Base.
Ö Ö NOTE: Use a ground cloth to protect the paint finish during this step. 2-A . Carefully turn the grill Up-Side-Down. 3-A 3-A . Check that all fasteners are tightened before turning the grill Right-Side-Up. Ö Ö Carefully turn the grill Right-Side-Up.
Ö Ö Assemble the T op Panel. Ö Ö Assemble the Rear Support. 5-A 5-A . Assemble the T op Panel to the Left and Right Side Panels with eight Screws (TN). Hardware shown actual size TN (x8) T op Panel Ö Ö Install Door Magnets. 5-B 5-B . Assemble the Rear Support to the Left and Right Side Panels with eight Screws (TN).
Ö Ö NOTE: Use a ground cloth to protect the paint finish during Step 7 and 8 . Ö Ö Assemble Right Side T able to the Firebox. 7-A 7-A . Lay the Firebox on it’s backside with lid closed .
Ö Ö Assemble Left Side Burner Assembly to the Firebox. Hardware shown actual size (CX) M6 x 20mm Screw (5) Qty . (UO) M6 Locking Hex Nut (1) Qty . 8-A 8-A . Assemble the Left Side Burner T able to the Firebox with five Screws (CX) and one Locking Hex Nut (UO).
Ö Ö Assemble Firebox to the Grill Cart. Ö Ö HINT : A second person is helpful when aligning the Firebox to the Grill Cart. 9-A 9-B 9-C 9-D 9-A . Carefully place the Firebox onto the Cart Assembly . T ake care to not damage the fuel hoses. They must be routed through the large hole in the top panel.
Ö Ö Fasten the Firebox to the Grill Cart. 10-A 10-A . LOOSEL Y fasten the right side of the Firebox to the Grill Cart with three Screws (TN), two Flat W ashers (DY) and two Locking Hex Nuts (UO).
Ö Ö Fasten the Rear T rim Plate to the Grill Cart. (VP) Self T apping Screw (2) Qty . Hardware shown actual size 1 1-A 1 1-A . Fasten the Rear T rim Plate to the Firebox with two Screws (VP). Ö Ö Tighten all fasteners. FIREBOX VP (x2) REAR TRIM PLA TE VP Step 11 16 1 1-B 1 1-B .
12-A Hardware shown actual size (XR) M5 x 15mm Flat Head Screw (8) Qty . Ö Ö Fasten both Left and Right Doors to the Grill Cart. Ö Ö Attach the T ool Hook to the Right Door . 12-C . Fasten the Right Door to the Grill Cart with four Flat Head Screws (XR).
Ö Ö Install three Heat T ents™. Ö Ö Install three Cooking Grates. Ö Ö Install the W arming Rack. 13-A 13-B 13-C . Install three Cooking Grates, flat side downward. Ö Ö Locate the Power Grate in the center position. 13-C 13-B . Install three Heat T ents™ over the Burners.
14-A Ö Ö Install the Side Burner V alve. 14-B Side Burner V alve 14-A . Route the Side Burner V alve through the Large Hole in the Left Panel. Large Hole 14-C 14-E 14-D 14-C .
15-D Ö Ö Assemble the Side Burner to the Left Side T able. Ö Ö Assemble the Electrode to the Side Burner . 15-A 15-B 15-A . Slip the Burner T ube through the Left Side T able. 15-D . View showing Side Burner properly installed. 15-B . Align Burner T ube with Burner V alve.
Ö Ö Assemble the Electrode Wires and the Battery to the Electrode Module. Note : The fuel hoses are not shown in this step, for simplicity . 16-A Side Burner Wire 9-V olt Battery T op Burner Wires Electrode Module 16-A . Slip the T op Burner Wires through the large hole in the T op Panel.
Ö Ö Install Side Burner Knob and Side Burner Grate onto the Left Side Burner . 17-A Side Burner Knob Side Burner Grate 17-A . Place the Side Burner Knob on the valve stem. Ö Ö Place the Side Burner Grate on the Left Side Burner . Align the pins downward into the alignment holes.
Ö Ö Install the Grease Pan. Ö Ö Install the Grease Cup. 19-A 19-B 19-A . Slide the Grease Pan Assembly into the back of the grill. Ö Ö Tilt the pan slightly upward until the Grease Cup Support clears the Rear Support. Rear Support 19-B . Place the Grease Cup into the Grease Cup Support.
Ö Ö Attach an LP Cylinder to the Grill. 20-A Cylinder Support LP Cylinder 20-A . Set LP Cylinder in the Cylinder Support with the outlet valve facing toward the front of the grill. 20-B 20-B . T ighten the Cylinder Hold-Down Bolt against the bottom cylinder collar .
Ö Ö NOTE: Step 21 applies to you only if your grill is set up from the factory to use NA TURAL GAS. If your grill is set up from the factory to use LP GAS, skip back to Step 20. Step 21 P LACE THE RUBBER PLUG ONT O THE GAS SUPPL Y LINE . T HEN A TT ACH THE SOCKET END OF THE QUICK DISCONNECT COUPLING ONTO THE GAS SUPPL Y LINE .
26 1. Check that the cylinder valve is closed by turning the cylinder knob clockwise to a full stop. 2. Check that all the grill burner knobs are in the off position. 3. Remove the protective caps from the cylinder valve and cou - pling nut. NOTE: The coupling nut connect s to the large outside threads on the valve outlet.
CAUTION Inspect the gas supply hoses before each use. If there are cuts, damage, excessive abrasion or wear , replace the hoses prior to operating the appliance.
28 1. T urn on any or all burner gas control knobs to high. (Fig. 19) 2. Press the igniter switch until the flame ignites. 3. If the flame doesn’t immediately light, turn off control knob and wait five minutes for gas to clear . 4. Repeat steps 1 through 3.
Good Bad Y ellow Blue Holes in Burner Y ellow Blue Burner Control Setting Tip s • The high flame setting is too hot for direct cooking. The high flame setting is good for quick searing of meat, then finish cooking on medium or low flame settings.
Step s For Cleaning V enturi: 1. Remove burner from grill bottom. 2. Look inside lower end of venturi tubes for nests, webs or mud. 3. T o remove the above obstructions, use an accessory flexible venturi brush or bend a small hook on one end of a 20-inch- long flexible wire such as the one shown in Fig.
CAUTION A collision with the grill, as with any metal object, could cause injury . Use care when moving a port able gas grill. Moving the grill: • Move grill slowly . DO NOT run with or pull the grill behind you; it could hit you from behind causing injury .
TYPE 1 CONNECTION ILLUSTRA TION Thermal Sensitive Handwheel 1-5/16" Acme Connection Nipple with Excess Flow V alve Regulator YOUR NEW GAS GRILL IS EQUIPPED WITH A TYPE 1 CONNECTION DEVICE WHICH HAS 3 SAFETY FEA TURES: (SEE TYPE 1 CONNECTION ILLUSTRA TION) 1.
Please do not send other correspondence to the address belo w. PRODUCT REGISTRA TION DEP ARTMENT PO BO X 2931 WICHIT A ,KS 67201 A TTN: DEPT 586 IMPOR T ANT! Coleman ¨ Grill W arranty Registration Ca.
7) Side burner (if applies) 8) Steamer/Fryer/W ar mer (if applies) 9) Side table design 10) Color of the grill (not including stainless steel) 11) Warming racks 12) Dependable igniter 13) Size of the .
Recipes Lemongrass beef skewers with peanut dipping sauce Cooking time after marination: 4-5 minutes 2 pounds boneless sirloin For the Marinade: 3 cloves garlic, minced 2 stalks lemongrass, trimmed of tough outer layer , sliced (find in Asian market s) 2 Tb sugar 1 Tb soy sauce 3 Tb thai fish sauce (find in Asian markets) 1.
Coleman Gas Barbecue Grill Limited W arranty Castings and Burners - Limited Lifetime Electronic Ignition Components - Limited Five (5) Y ears Cooking Surfaces and Other Parts - Limited Three (3) Y ears The Coleman Company , Inc. (“Coleman”) warrants that this product will be free from defects in material and workmanship.
Ein wichtiger Punkt beim Kauf des Geräts Coleman 5100 LP (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Coleman 5100 LP noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Coleman 5100 LP - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Coleman 5100 LP reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Coleman 5100 LP erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Coleman 5100 LP besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Coleman 5100 LP verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Coleman 5100 LP. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Coleman 5100 LP gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
