Benutzeranleitung / Produktwartung HN3620 des Produzenten CDA
Zur Seite of 28
Customer Care Department • The Group Ltd. • Harby R oad • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.
2 Important The CD A Group L td cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that CD A reserve the right to invalidate the guarantee supplied with this product following incorrect installation or misuse of the appliance or use in a commercial environment.
3 2004/108/EC. Parts intended to come into contact with food conform to 89/109/EC. IMPORT ANT INFORMA TION FOR CORRECT DISPOSAL OF THE PRODUCT IN A CCORD ANCE WITH EC DIRECTIVE 2002/96/EC.
4 surface prior to use. • Do not modify the appliance in any way as this will invalidate the guarantee and is potentially dangerous. • The hob top is not designed for any use other than cooking: any other use (e.g. as a worktop) is potentially dangerous and will invalidate the guarantee.
5 capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. • Children shall not play with the appliance. • Cleaning and user maintenance shall not be made by children without supervision.
6 divider must be made of material capable of withstanding 65°C above ambient temperature. • Never place inammable items or materials in a drawer or cupboard below the hob. Precautions in the event of an appliance fault • If a fault is noticed, switch o the appliance and turn o the electricity supply .
7 FOR THOSE WITH HEART P A CEMAKERS OR A CTIVE IMPLANTS: The function of this hob conforms to current electromagnetic interference standards and thus is in total compliance with legal requirements (2004/108/CE directives).
8 Cooking On Induction The principle of induction cooking is based on magnetic eect. When you put your cookware on an induction zone and switch it on, the electronic boards in the hob produce induced currents in the base of the cookware and instantly raise its temperature.
9 Using Y our Hob Fig. 1 Control panel: 3. Power key 4. Timer display 5. Zone selection keys 6. Zone displays 7 . - key 8. + key 9 . Timer control light Zones: 1.
10 Using Y our Hob The table below oers guidance as to what each power level is for . T o switch the hob on T o switch the power on, touch and hold the key for appro ximately two seconds. The hob will beep and both zone displays will show zero. Please note: If a power level is not set within ten seconds, the hob will switch o automatically .
11 T o turn the power o T o switch o a single zone, touch the “Selection” key for the zone no longer required. T ouch the “-” key until the zone display shows zero. When both zones are at zero, the hob will switch o automatically after appro ximately ten seconds.
12 • At the end of the set time, the selected zone will switch o and the timer display will ash “00” . The hob will beep for appro ximately one minute. • T o switch o the beep and the ashing displays, touch any key . T o cancel the timer • T ouch the “Zone selection” key for the zone you wish to cancel the timer from.
13 and hold the timer “+” or “-” keys to scroll through the duration quickly . • After appro ximately ve seconds, the control LED stops ashing and the countdown will start. • At the end of the set time, the the timer display will ash “00” and the hob will beep for appro ximately one minute.
14 in the relevant zone display after cooking until the zone is at a safe temperature to touch. In the event of a power cut, the residual heat indictors will illuminate after the power supply is restored. However , when there is no power supply to the hob the residual heat indicators will not work, so extra care must be taken.
15 Ecient Use of Y our Hob The hob is equipped with zones of dierent sizes, designed to accommodate most shapes and sizes of pan. For best results, only use pans with at bottoms and choose an appropriate zone depending on the size of the pan.
16 Care and Maintenance Always disconnect the appliance from the power supply before undertaking any cleaning or maintenance. Important: • S team cleaners must not be used when cleaning this appliance. • Y ou should use a non-abrasive cleaner to clean the hob top.
17 In the event of a fault with the hob, please advise CD A Customer Care of any fault code shown on the display Contact CD A Customer Care A: Customer Care Department, The CD A Group Ltd, Harby R oad, Langar , Nottinghamshire, NG13 9HY T: 01949 862 012 F: 01949 862 003 E: service@cda.
18 IMPORT ANT - PLEASE NOTE: In the event of any breakage , crack or cracking – even minimal – of the vitroceramic glass, immediately disconnect your appliance to prevent a risk of electric shock and contact CD A Customer Care. In use Y ou observe that Possible Causes What should you do ? One or all of the zones cuts out.
19 IMPORT ANT : When correctly installed, your product meets all safety requirements laid down for this type of product. However , special care should be taken around the rear or the underneath of the appliance as these areas are not designed or intended to be touched and may contain sharp or rough edges that could cause injury .
20 ventilation grille. • The furniture top rail should not be fitted to the unit. This allows the induction hob to exhaust air into the kitchen space.
21 on the hob may not allow the hob to be used at the same time as a pyrolytic programme on the oven. • The hob is equipped with an anti-overheating safety device that can be activated if the hob is installed over an oven that is not suciently ventilated.
22 How to Install the Hob: Overall dimensions of the hob: Width: 300 mm Depth: 510 mm W orktop cut-out dimensions: Width: 275 mm Depth: 490 mm 1. Make the required hole in the worktop. Before doing this, you must check the instructions supplied with any cooker hood to ensure that you will have the required clearance.
23 Mains Electricity Connection W arning! this appliance must be earthed W e recommend that the appliance is connected by a qualified electrician, who is a member of the N.
24 appliance should be marked on the outlet (13A). • Assembly and electrical connection should be carried out by specialised personnel. • When installing this product we recommend you seek the help of another individual. • Protection against live parts must be ensured after installation.
25 the absense of an earth connection or a faulty earth connection..
26 NO TES.
27 NO TES.
Please contact our Customer Care Department for Service on the details below Customer Care Department • The Group Ltd. • Harby R oad • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.
Ein wichtiger Punkt beim Kauf des Geräts CDA HN3620 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie CDA HN3620 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für CDA HN3620 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von CDA HN3620 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über CDA HN3620 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon CDA HN3620 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von CDA HN3620 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit CDA HN3620. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei CDA HN3620 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
